Searched full:mirror (Results 1 – 25 of 41) sorted by relevance
12
| /Documentation/devicetree/bindings/arm/mediatek/ |
| D | mediatek,mt7622-pcie-mirror.yaml | 4 $id: http://devicetree.org/schemas/arm/mediatek/mediatek,mt7622-pcie-mirror.yaml#
7 title: MediaTek PCIE Mirror Controller for MT7622
14 The mediatek PCIE mirror provides a configuration interface for PCIE
21 - mediatek,mt7622-pcie-mirror
38 pcie_mirror: pcie-mirror@10000400 {
39 compatible = "mediatek,mt7622-pcie-mirror", "syscon";
|
| /Documentation/networking/device_drivers/ethernet/freescale/dpaa2/ |
| D | switch-driver.rst | 187 …add block 1 ingress protocol 802.1q flower skip_sw vlan_prio 3 action mirred egress mirror dev eth6
196 …add block 1 ingress protocol 802.1q flower skip_sw vlan_id 200 action mirred egress mirror dev eth6
201 …add block 1 ingress protocol 802.1q flower skip_sw vlan_id 200 action mirred egress mirror dev eth6
204 …add block 1 ingress protocol 802.1q flower skip_sw vlan_id 200 action mirred egress mirror dev eth6
208 packet will reach the mirror port, if the VLAN found in the packet is not
212 mirror rules can be installed but their ''to'' port has to be the same::
214 …add block 1 ingress protocol 802.1q flower skip_sw vlan_id 200 action mirred egress mirror dev eth6
215 …add block 1 ingress protocol 802.1q flower skip_sw vlan_id 100 action mirred egress mirror dev eth7
216 Error: fsl_dpaa2_switch: Multiple mirror ports not supported.
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-mcp23s08.txt | 55 - microchip,irq-mirror: Sets the mirror flag in the IOCON register. Devices
59 One for bank 1 and another for bank 2. If irq-mirror is set, both
78 microchip,irq-mirror;
136 microchip,irq-mirror;
|
| /Documentation/devicetree/bindings/mtd/ |
| D | mtd-physmap.yaml | 33 - ge,imp3a-firmware-mirror
35 - gef,ppc9a-firmware-mirror
37 - gef,sbc310-firmware-mirror
39 - gef,sbc610-firmware-mirror
|
| /Documentation/devicetree/bindings/display/ |
| D | lvds.yaml | 23 data-mirror:
|
| /Documentation/arch/m68k/ |
| D | buddha-driver.rst | 69 $f01-$f3f mirror of $f00
74 $f41-$f7f mirror of $f40
80 $f81-$fbf mirror of $f80
95 $fc1-$fff mirror of $fc0
|
| /Documentation/networking/device_drivers/ethernet/marvell/ |
| D | octeontx2.rst | 229 - Receive mirror/multicast packet drop due to insufficient buffer.
234 - Memory Fault due to WQE read/write from multicast/mirror buffer.
235 - Receive multicast/mirror replication list error.
242 - RAS Error Reporting for NIX Receive Multicast/Mirror Entry Structure.
243 - RAS Error Reporting for WQE/Packet Data read from Multicast/Mirror Buffer..
|
| /Documentation/devicetree/bindings/net/ |
| D | mediatek,net.yaml | 76 mediatek,pcie-mirror:
79 Phandle to the mediatek pcie-mirror controller.
222 mediatek,pcie-mirror: false
449 mediatek,pcie-mirror = <&pcie_mirror>;
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-clone.rst | 291 * The resulting cache device is not a one-to-one mirror of the source device
302 is not a one-to-one mirror of the source device.
312 3. Use dm-mirror: The mirror target has a background copying/mirroring
318 one-to-one mirror of the source device and handles reads and writes to
|
| D | kcopyd.rst | 7 notification. It is used by dm-snapshot and dm-mirror.
|
| D | dm-init.rst | 52 `mirror` constrained, userspace should verify main/mirror device
|
| D | dm-ima.rst | 333 #. mirror
487 5. mirror
490 section above) has the following data format for 'mirror' target.
497 target_name := "target_name=mirror"
514 When a 'mirror' target is loaded, then IMA ASCII measurement log will have an entry
515 similar to the following, depicting what 'mirror' attributes are measured in EVENT_DATA
521 …target_index=0,target_begin=0,target_len=2048,target_name=mirror,target_version=1.14.0,nr_mirrors=…
|
| D | dm-log.rst | 11 the legs of the mirror and may not reach the legs at the same time.
|
| /Documentation/arch/arm/omap/ |
| D | dss.rst | 166 mirror 0=off, 1=on
197 mirror 0=off, 1=on
345 omapfb.mirror=<y|n>
346 - Default mirror for all framebuffers. Only works with DMA rotation.
|
| /Documentation/filesystems/ |
| D | fiemap.rst | 32 which the process would like mappings for. Extents returned mirror
93 All offsets and lengths are in bytes and mirror those on disk. It is valid
|
| /Documentation/scheduler/ |
| D | sched-nice-design.rst | 75 bash's "nice" command mirror this relative API.
|
| /Documentation/firmware-guide/acpi/apei/ |
| D | output_format.rst | 84 mirror Broken | memory sparing | scrub corrected error | \
|
| /Documentation/networking/ |
| D | representors.rst | 202 action mirred egress mirror dev $REP_DEV
208 trigger the TC rule again and mirror the packet to ``REP_DEV``.)
|
| /Documentation/admin-guide/media/ |
| D | fimc.rst | 29 - memory-to-memory processing (color space conversion, scaling, mirror
|
| /Documentation/bpf/libbpf/ |
| D | libbpf_naming_convention.rst | 139 mirror of the mainline's version of libbpf for a stand-alone build.
|
| /Documentation/userspace-api/media/v4l/ |
| D | control.rst | 149 Mirror the picture horizontally.
154 Mirror the picture vertically.
|
| /Documentation/w1/ |
| D | w1-netlink.rst | 154 All other fields in every structure will mirror the same parameters in the
|
| /Documentation/input/ |
| D | gameport-programming.rst | 28 space (is above 0x1000), use that one, and don't map the ISA mirror.
|
| /Documentation/userspace-api/ |
| D | iommufd.rst | 162 list of iommu_domains that mirror the IOVA to PFN map.
|
| /Documentation/mm/ |
| D | hmm.rst | 136 With these two features, HMM not only allows a device to mirror process address
147 device driver that wants to mirror a process address space must start with the
|
12