Searched +full:msm +full:- +full:uart (Results 1 – 4 of 4) sorted by relevance
| /Documentation/devicetree/bindings/serial/ |
| D | qcom,msm-uart.yaml | 1 # SPDX-License-Identifier: GPL-2.0 OR BSD-2-Clause 3 --- 4 $id: http://devicetree.org/schemas/serial/qcom,msm-uart.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Qualcomm MSM SoC Serial UART 10 - Bjorn Andersson <andersson@kernel.org> 11 - Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> 14 The MSM serial UART hardware is designed for low-speed use cases where a 15 dma-engine isn't needed. From a software perspective it's mostly compatible 16 with the MSM serial UARTDM except that it only supports reading and writing [all …]
|
| D | qcom,msm-uartdm.yaml | 1 # SPDX-License-Identifier: GPL-2.0 OR BSD-2-Clause 3 --- 4 $id: http://devicetree.org/schemas/serial/qcom,msm-uartdm.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Qualcomm MSM Serial UARTDM 10 - Andy Gross <agross@kernel.org> 11 - Bjorn Andersson <bjorn.andersson@linaro.org> 12 - Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> 15 The MSM serial UARTDM hardware is designed for high-speed use cases where the 16 transmit and/or receive channels can be offloaded to a dma-engine. From a [all …]
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,gsbi.yaml | 1 # SPDX-License-Identifier: GPL-2.0 OR BSD-2-Clause 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Andy Gross <agross@kernel.org> 11 - Bjorn Andersson <bjorn.andersson@linaro.org> 12 - Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> 16 representing a serial sub-node device that is mux'd as part of the GSBI 21 devices. These serial devices can be a QCOM UART, I2C controller, spi 26 const: qcom,gsbi-v1.0.0 28 '#address-cells': [all …]
|
| /Documentation/admin-guide/ |
| D | kernel-parameters.txt | 16 force -- enable ACPI if default was off 17 on -- enable ACPI but allow fallback to DT [arm64,riscv64] 18 off -- disable ACPI if default was on 19 noirq -- do not use ACPI for IRQ routing 20 strict -- Be less tolerant of platforms that are not 22 rsdt -- prefer RSDT over (default) XSDT 23 copy_dsdt -- copy DSDT to memory 24 nospcr -- disable console in ACPI SPCR table as 41 If set to vendor, prefer vendor-specific driver 73 Documentation/firmware-guide/acpi/debug.rst for more information about [all …]
|