Home
last modified time | relevance | path

Searched +full:nand +full:- +full:on +full:- +full:flash +full:- +full:bbt (Results 1 – 16 of 16) sorted by relevance

/Documentation/devicetree/bindings/mtd/
Dsamsung-s3c2410.txt1 * Samsung S3C2410 and compatible NAND flash controller
4 - compatible : The possible values are:
5 "samsung,s3c2410-nand"
6 "samsung,s3c2412-nand"
7 "samsung,s3c2440-nand"
8 - reg : register's location and length.
9 - #address-cells, #size-cells : see nand-controller.yaml
10 - clocks : phandle to the nand controller clock
11 - clock-names : must contain "nand"
14 Child nodes representing the available nand chips.
[all …]
Ddavinci-nand.txt1 Device tree bindings for Texas instruments Davinci/Keystone NAND controller
4 NAND interface contains.
7 Davinci DM646x - https://www.ti.com/lit/ug/sprueq7c/sprueq7c.pdf
8 Kestone - https://www.ti.com/lit/ug/sprugz3a/sprugz3a.pdf
12 - compatible: "ti,davinci-nand"
13 "ti,keystone-nand"
15 - reg: Contains 2 offset/length values:
16 - offset and length for the access window.
17 - offset and length for accessing the AEMIF
20 - ti,davinci-chipselect: number of chipselect. Indicates on the
[all …]
Dvf610-nfc.txt1 Freescale's NAND flash controller (NFC)
3 This variant of the Freescale NAND flash controller (NFC) can be found on
7 - compatible: Should be set to "fsl,vf610-nfc".
8 - reg: address range of the NFC.
9 - interrupts: interrupt of the NFC.
10 - #address-cells: shall be set to 1. Encode the nand CS.
11 - #size-cells : shall be set to 0.
12 - assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
13 - assigned-clock-rates: The NAND bus timing is derived from this clock
14 rate and should not exceed maximum timing for any NAND memory chip
[all …]
Dlpc32xx-slc.txt1 NXP LPC32xx SoC NAND SLC controller
4 - compatible: "nxp,lpc3220-slc"
5 - reg: Address and size of the controller
6 - nand-on-flash-bbt: Use bad block table on flash
7 - gpios: GPIO specification for NAND write protect
11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)
12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
15 - nxp,wwidth: Write pulse width (W_WIDTH)
16 - nxp,whold: Write hold time (W_HOLD)
17 - nxp,wsetup: Write setup time (W_SETUP)
[all …]
Dnvidia-tegra20-nand.txt1 NVIDIA Tegra NAND Flash controller
4 - compatible: Must be one of:
5 - "nvidia,tegra20-nand"
6 - reg: MMIO address range
7 - interrupts: interrupt output of the NFC controller
8 - clocks: Must contain an entry for each entry in clock-names.
9 See ../clocks/clock-bindings.txt for details.
10 - clock-names: Must include the following entries:
11 - nand
12 - resets: Must contain an entry for each entry in reset-names.
[all …]
Datmel-nand.txt1 Atmel NAND flash controller bindings
3 The NAND flash controller node should be defined under the EBI bus (see
4 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt).
5 One or several NAND devices can be defined under this NAND controller.
6 The NAND controller might be connected to an ECC engine.
8 * NAND controller bindings:
11 - compatible: should be one of the following
12 "atmel,at91rm9200-nand-controller"
13 "atmel,at91sam9260-nand-controller"
14 "atmel,at91sam9261-nand-controller"
[all …]
Dgpmi-nand.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/gpmi-nand.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Freescale General-Purpose Media Interface (GPMI)
10 - Han Xu <han.xu@nxp.com>
13 The GPMI nand controller provides an interface to control the NAND
14 flash chips. The device tree may optionally contain sub-nodes
21 - enum:
22 - fsl,imx23-gpmi-nand
[all …]
Draw-nand-chip.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/raw-nand-chip.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Raw NAND Chip Common Properties
10 - Miquel Raynal <miquel.raynal@bootlin.com>
13 - $ref: nand-chip.yaml#
19 {size} bytes for a particular raw NAND chip.
21 The interpretation of these parameters is implementation-defined, so
28 pattern: "^nand@[a-f0-9]$"
[all …]
Dbrcm,brcmnand.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Broadcom STB NAND Controller
10 - Brian Norris <computersforpeace@gmail.com>
11 - Kamal Dasu <kdasu.kdev@gmail.com>
12 - William Zhang <william.zhang@broadcom.com>
15 The Broadcom Set-Top Box NAND controller supports low-level access to raw NAND
16 flash chips. It has a memory-mapped register interface for both control
17 registers and for its data input/output buffer. On some SoCs, this controller
[all …]
Dmediatek,mtk-nfc.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/mediatek,mtk-nfc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: MediaTek(MTK) SoCs raw NAND FLASH controller (NFC)
10 - Xiangsheng Hou <xiangsheng.hou@mediatek.com>
15 - mediatek,mt2701-nfc
16 - mediatek,mt2712-nfc
17 - mediatek,mt7622-nfc
21 - description: Base physical address and size of NFI.
[all …]
Dmarvell,nand-controller.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Marvell NAND Flash Controller (NFC)
10 - Miquel Raynal <miquel.raynal@bootlin.com>
15 - items:
16 - const: marvell,armada-8k-nand-controller
17 - const: marvell,armada370-nand-controller
18 - enum:
[all …]
Dingenic,nand.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/ingenic,nand.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Ingenic SoCs NAND controller
10 - Paul Cercueil <paul@crapouillou.net>
13 - $ref: nand-controller.yaml#
14 - $ref: /schemas/memory-controllers/ingenic,nemc-peripherals.yaml#
19 - ingenic,jz4740-nand
20 - ingenic,jz4725b-nand
[all …]
Dst,stm32-fmc2-nand.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/st,stm32-fmc2-nand.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Christophe Kerello <christophe.kerello@foss.st.com>
15 - st,stm32mp15-fmc2
16 - st,stm32mp1-fmc2-nfc
17 - st,stm32mp25-fmc2-nfc
28 - description: tx DMA channel
29 - description: rx DMA channel
[all …]
/Documentation/driver-api/
Dmtdnand.rst2 MTD NAND Driver Programming Interface
10 The generic NAND driver supports almost all NAND and AG-AND based chips
15 board drivers or filesystem drivers suitable for NAND devices.
31 --------------------------
37 - [MTD Interface]
43 - [NAND Interface]
45 These functions are exported and provide the interface to the NAND
48 - [GENERIC]
53 - [DEFAULT]
58 via pointers in the NAND chip description structure. The board driver
[all …]
/Documentation/devicetree/bindings/memory-controllers/
Dst,stm32-fmc2-ebi.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/memory-controllers/st,stm32-fmc2-ebi.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 asynchronous static devices (such as PSNOR, PSRAM or other memory-mapped
12 peripherals) and NAND flash memories.
14 - to translate AXI transactions into the appropriate external device
16 - to meet the access time requirements of the external devices
22 - Christophe Kerello <christophe.kerello@foss.st.com>
27 - st,stm32mp1-fmc2-ebi
[all …]
/Documentation/ABI/testing/
Dsysfs-class-mtd4 Contact: linux-mtd@lists.infradead.org
12 Contact: linux-mtd@lists.infradead.org
16 physical/simulated flash devices, partitions on a flash
17 device, or concatenated flash devices.
22 Contact: linux-mtd@lists.infradead.org
24 These directories provide the corresponding read-only device
30 Contact: linux-mtd@lists.infradead.org
34 read-write device so <minor> will be even.
39 Contact: linux-mtd@lists.infradead.org
42 to the read-only variant of the MTD device (in
[all …]