Home
last modified time | relevance | path

Searched +full:no +full:- +full:ether +full:- +full:link (Results 1 – 14 of 14) sorted by relevance

/Documentation/devicetree/bindings/net/
Drenesas,ether.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/net/renesas,ether.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - $ref: ethernet-controller.yaml#
13 - Sergei Shtylyov <sergei.shtylyov@gmail.com>
18 - items:
19 - enum:
20 - renesas,gether-r8a7740 # device is a part of R8A7740 SoC
21 - renesas,gether-r8a77980 # device is a part of R8A77980 SoC
[all …]
Drenesas,etheravb.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sergei Shtylyov <sergei.shtylyov@gmail.com>
15 - items:
16 - enum:
17 - renesas,etheravb-r8a7742 # RZ/G1H
18 - renesas,etheravb-r8a7743 # RZ/G1M
19 - renesas,etheravb-r8a7744 # RZ/G1N
20 - renesas,etheravb-r8a7745 # RZ/G1E
[all …]
/Documentation/networking/
Dnet_failover.rst1 .. SPDX-License-Identifier: GPL-2.0
21 it is available with link up and running.
28 virtio-net accelerated datapath: STANDBY mode
31 net_failover enables hypervisor controlled accelerated datapath to virtio-net
32 enabled VMs in a transparent manner with no/minimal guest userspace changes.
35 feature on the virtio-net interface and assign the same MAC address to both
36 virtio-net and VF interfaces.
47 <link state='down'/>
49 <alias name='ua-backup0'/>
56 <teaming type='transient' persistent='ua-backup0'/>
[all …]
Dgeneric-hdlc.rst1 .. SPDX-License-Identifier: GPL-2.0
12 1. Frame Relay (ANSI, CCITT, Cisco and no LMI)
14 - Normal (routed) and Ethernet-bridged (Ethernet device emulation)
16 - ARP support (no InARP support in the kernel - there is an
17 experimental InARP user-space daemon available on:
20 2. raw HDLC - either IP (IPv4) interface or Ethernet device emulation
25 Generic HDLC is a protocol driver only - it needs a low-level driver
28 Ethernet device emulation (using HDLC or Frame-Relay PVC) is compatible
40 gcc -O2 -Wall -o sethdlc sethdlc.c
66 - sets physical interface for a given port
[all …]
Dstatistics.rst1 .. SPDX-License-Identifier: GPL-2.0
14 - standard interface statistics based on
16 - protocol-specific statistics; and
17 - driver-defined statistics available via ethtool.
20 -----------------------------
25 $ ip -s -s link show dev ens4u1u1
27 link/ether 48:2a:e3:4c:b1:d1 brd ff:ff:ff:ff:ff:ff
38 Note that `-s` has been specified twice to see all members of
40 If `-s` is specified once the detailed errors won't be shown.
42 `ip` supports JSON formatting via the `-j` option.
[all …]
Dbonding.rst1 .. SPDX-License-Identifier: GPL-2.0
11 Corrections, HA extensions: 2000/10/03-15:
13 - Willy Tarreau <willy at meta-x.org>
14 - Constantine Gavrilov <const-g at xpert.com>
15 - Chad N. Tindel <ctindel at ieee dot org>
16 - Janice Girouard <girouard at us dot ibm dot com>
17 - Jay Vosburgh <fubar at us dot ibm dot com>
22 - Mitch Williams <mitch.a.williams at intel.com>
31 Additionally, link integrity monitoring may be performed.
35 the original tools from extreme-linux and beowulf sites will not work
[all …]
Darcnet.rst1 .. SPDX-License-Identifier: GPL-2.0
9 See also arcnet-hardware.txt in this directory for jumper-setting
13 Since no one seems to listen to me otherwise, perhaps a poem will get your
25 ARCnet 0.32 ALPHA first made it into the Linux kernel 1.1.80 - this was
36 If you don't e-mail me about your success/failure soon, I may be forced to
40 If you think so, why not flame me in a quick little e-mail? Please also
44 My e-mail address is: apenwarr@worldvisions.ca
55 The previous release resulted from many months of on-and-off effort from me
58 ARCnet 2.10 ALPHA, Tomasz's all-new-and-improved RFC1051 support has been
63 ---------------------------------
[all …]
/Documentation/networking/device_drivers/ethernet/pensando/
Dionic.rst1 .. SPDX-License-Identifier: GPL-2.0+
13 - Identifying the Adapter
14 - Enabling the driver
15 - Configuring the driver
16 - Statistics
17 - Support
25 $ lspci -d 1dd8:
34 ionic 0000:b5:00.0: 126.016 Gb/s available PCIe bandwidth (8.0 GT/s PCIe x16 link)
36 ionic 0000:b5:00.0 enp181s0: Link up - 100 Gbps
37 ionic 0000:b6:00.0: 126.016 Gb/s available PCIe bandwidth (8.0 GT/s PCIe x16 link)
[all …]
/Documentation/networking/device_drivers/ethernet/3com/
D3c509.rst1 .. SPDX-License-Identifier: GPL-2.0
21 ethercards in Linux. These cards are commonly known by the most widely-used
22 card's 3Com model number, 3c509. They are all 10mb/s ISA-bus cards and shouldn't
23 be (but sometimes are) confused with the similarly-numbered PCI-bus "3c905"
28 - 3c509 (original ISA card)
29 - 3c509B (later revision of the ISA card; supports full-duplex)
30 - 3c589 (PCMCIA)
31 - 3c589B (later revision of the 3c589; supports full-duplex)
32 - 3c579 (EISA)
45 The driver allows boot- or load-time overriding of the card's detected IOADDR,
[all …]
Dvortex.rst1 .. SPDX-License-Identifier: GPL-2.0
17 Don is no longer the prime maintainer of this version of the driver.
20 - Andrew Morton
21 - Netdev mailing list <netdev@vger.kernel.org>
22 - Linux kernel mailing list <linux-kernel@vger.kernel.org>
28 Since kernel 2.3.99-pre6, this driver incorporates the support for the
29 3c575-series Cardbus cards which used to be handled by 3c575_cb.c.
33 - 3c590 Vortex 10Mbps
34 - 3c592 EISA 10Mbps Demon/Vortex
35 - 3c597 EISA Fast Demon/Vortex
[all …]
/Documentation/networking/device_drivers/ethernet/aquantia/
Datlantic.rst1 .. SPDX-License-Identifier: GPL-2.0
8 For the aQuantia Multi-Gigabit PCI Express Family of Ethernet Adapters
12 - Identifying Your Adapter
13 - Configuration
14 - Supported ethtool options
15 - Command Line Parameters
16 - Config file parameters
17 - Support
18 - License
23 The driver in this release is compatible with AQC-100, AQC-107, AQC-108
[all …]
/Documentation/arch/m68k/
Dkernel-options.rst9 Author: Roman.Hodek@informatik.uni-erlangen.de (Roman Hodek)
11 Update: jds@kom.auc.dk (Jes Sorensen) and faq@linux-m68k.org (Chris Lawrence)
58 ----------
76 /dev/ram: -> 0x0100 (initial ramdisk)
77 /dev/hda: -> 0x0300 (first IDE disk)
78 /dev/hdb: -> 0x0340 (second IDE disk)
79 /dev/sda: -> 0x0800 (first SCSI disk)
80 /dev/sdb: -> 0x0810 (second SCSI disk)
81 /dev/sdc: -> 0x0820 (third SCSI disk)
82 /dev/sdd: -> 0x0830 (forth SCSI disk)
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]
/Documentation/fpga/
Ddfl.rst7 - Enno Luebbers <enno.luebbers@intel.com>
8 - Xiao Guangrong <guangrong.xiao@linux.intel.com>
9 - Wu Hao <hao.wu@intel.com>
10 - Xu Yilun <yilun.xu@intel.com>
29 +----------+ +-->+----------+ +-->+----------+ +-->+----------+
32 +----------+ | | Feature | | | Feature | | | Feature |
33 | Next_DFH |--+ +----------+ | +----------+ | +----------+
34 +----------+ | Next_DFH |--+ | Next_DFH |--+ | Next_DFH |--> NULL
35 | ID | +----------+ +----------+ +----------+
36 +----------+ | ID | | ID | | ID |
[all …]