Searched full:operates (Results 1 – 25 of 109) sorted by relevance
12345
| /Documentation/ABI/testing/ |
| D | sysfs-bus-surface_aggregator-tabletsw | 44 operates as a normal laptop.
47 back and the device operates mainly based on touch input.
49 - "tablet": The device operates as tablet and exclusively
|
| /Documentation/userspace-api/media/v4l/ |
| D | libv4l-introduction.rst | 121 operates like the :c:func:`open()` function.
125 operates like the :c:func:`close()` function.
129 operates like the libc ``dup()`` function, duplicating a file handler.
133 operates like the :c:func:`ioctl()` function.
137 operates like the :c:func:`read()` function.
141 operates like the :c:func:`mmap()` function.
145 operates like the :c:func:`munmap()` function.
|
| D | metafmt-vsp1-hgo.rst | 19 or HSV data. It operates on a possibly cropped and subsampled input image and
28 - In *64 bins normal mode*, the HGO operates on the three channels independently
31 - In *64 bins maximum mode*, the HGO operates on the maximum of the (R, G, B)
34 - In *256 bins normal mode*, the HGO operates on the Y channel to compute a
36 - In *256 bins maximum mode*, the HGO operates on the maximum of the (R, G, B)
|
| D | metafmt-vsp1-hgt.rst | 18 The VSP1 HGT is a histogram computation engine that operates on HSV
19 data. It operates on a possibly cropped and subsampled input image and
|
| /Documentation/devicetree/bindings/serial/ |
| D | serial-peripheral-props.yaml | 22 The maximum baud rate the device operates at.
31 The current baud rate the device operates at.
|
| /Documentation/devicetree/bindings/net/ |
| D | adi,adin.yaml | 21 RGMII RX Clock Delay used only when PHY operates in RGMII mode with
28 RGMII TX Clock Delay used only when PHY operates in RGMII mode with
|
| D | socfpga-dwmac.txt | 26 phy-mode: The phy mode the ethernet operates in
|
| D | motorcomm,yt8xxx.yaml | 23 RGMII RX Clock Delay used only when PHY operates in RGMII mode with
32 RGMII TX Clock Delay used only when PHY operates in RGMII mode with
|
| /Documentation/networking/devlink/ |
| D | devlink-eswitch-attr.rst | 8 Legacy mode operates based on traditional MAC/VLAN steering rules. Switching
38 * ``legacy`` operates based on traditional MAC/VLAN steering
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-exynos5.yaml | 53 If not specified, the bus operates in fast-speed mode at 100kHz.
55 If specified, the bus operates in high-speed mode only if the
|
| /Documentation/hwmon/ |
| D | ds620.rst | 38 The PO output pin of the DS620 operates active-low.
|
| D | gsc-hwmon.rst | 43 The GSC features 1 PWM output that operates in automatic mode where the
|
| D | mpq8785.rst | 20 wide input supply range. The MPQ8785 operates at high efficiency over a wide
|
| D | ads7828.rst | 37 set to true if it operates with an external reference, false for default
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | brcm,bcm6345-l1-intc.txt | 40 The driver operates in native CPU endian by default, there is no support for
|
| /Documentation/devicetree/bindings/mtd/ |
| D | nxp-spifi.txt | 5 mode 0 or 3. The controller operates in either command or memory
|
| /Documentation/networking/ |
| D | batman-adv.rst | 9 using UDP packets and sets routing tables, batman-advanced operates on ISO/OSI
143 As batman advanced operates on layer 2, all hosts participating in the virtual
|
| /Documentation/devicetree/bindings/regulator/ |
| D | richtek,rt6190.yaml | 15 voltage. It operates with wide input voltage range from 4.5V to 36V, and
|
| /Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | cpm.txt | 25 to specify the device on which a CPM command operates.
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | dongwoon,dw9768.yaml | 17 serial interface that operates at clock rates up to 1MHz. This chip
|
| D | sony,imx415.yaml | 15 pixels. This chip operates with analog 2.9 V, digital 1.1 V, and interface
|
| D | maxim,max96712.yaml | 21 Each GMSL2 serial link operates at a fixed rate of 3Gbps or 6Gbps in the
|
| /Documentation/devicetree/bindings/pwm/ |
| D | microchip,corepwm.yaml | 61 whether a given channel operates in regular PWM or DAC mode.
|
| /Documentation/misc-devices/ |
| D | bh1770glc.rst | 21 ALS and proximity parts operates on their own, but they shares common I2C
|
| /Documentation/arch/mips/ |
| D | ingenic-tcu.rst | 37 - On JZ4725B, channel 5 operates as TCU2, the others operate as TCU1.
|
12345