Searched +full:pcm +full:- +full:interface +full:- +full:rate (Results 1 – 19 of 19) sorted by relevance
| /Documentation/sound/soc/ |
| D | dai.rst | 2 ASoC Digital Audio Interface (DAI) 6 SoC controllers and portable audio CODECs today, namely AC97, I2S and PCM. 12 AC97 is a five wire interface commonly found on many PC sound cards. It is 30 usually varies depending on the sample rate and the master system clock 31 (SYSCLK). LRCLK is the same as the sample rate. A few devices support separate 35 I2S has several different operating modes:- 47 PCM chapter 50 PCM is another 4 wire interface, very similar to I2S, which can support a more 53 receive the audio data. Bit clock usually varies depending on sample rate 54 while sync runs at the sample rate. PCM also supports Time Division [all …]
|
| D | dapm.rst | 11 management frameworks and, as such, can easily co-exist with them. 32 The graph for the STM32MP1-DK1 sound card is shown in picture: 34 .. kernel-figure:: dapm-graph.svg 105 Audio Interface Input (with TDM slot mask). 107 Audio Interface Output (with TDM slot mask). 111 Digital Audio Interface Input. 113 Digital Audio Interface Output. 128 Sample Rate Converter within DSP or CODEC 130 Asynchronous Sample Rate Converter within DSP or CODEC 132 Widget that encodes audio data from one format (usually PCM) to another [all …]
|
| /Documentation/devicetree/bindings/net/bluetooth/ |
| D | brcm,bluetooth.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Linus Walleij <linus.walleij@linaro.org> 13 This binding describes Broadcom UART-attached bluetooth chips. 18 - items: 19 - enum: 20 - infineon,cyw43439-bt 21 - const: brcm,bcm4329-bt 22 - enum: [all …]
|
| /Documentation/sound/designs/ |
| D | tracepoints.rst | 8 Tracepoints in ALSA PCM core 11 ALSA PCM core registers ``snd_pcm`` subsystem to kernel tracepoint system. 12 This subsystem includes two categories of tracepoints; for state of PCM buffer 13 and for processing of PCM hardware parameters. These tracepoints are available 18 Tracepoints for state of PCM buffer 19 ------------------------------------ 24 Tracepoints for processing of PCM hardware parameters 25 ----------------------------------------------------- 30 In a design of ALSA PCM core, data transmission is abstracted as PCM substream. 31 Applications manage PCM substream to maintain data transmission for PCM frames. [all …]
|
| D | control-names.rst | 8 --------------- 68 Headset Mic mic part of combined headset jack - 4-pin 70 Headphone Mic mic part of either/or - 3-pin headphone or mic 76 PCM 77 PCM Pan 79 Analog Loopback D/A -> A/D loopback 80 Digital Loopback playback -> capture loopback - 98 ----------------------- 106 Tone Control - Switch 107 Tone Control - Bass [all …]
|
| D | oss-emulation.rst | 2 Notes on Kernel OSS-Emulation 12 The OSS emulation for PCM, mixer and sequencer devices is implemented 13 as add-on kernel modules, snd-pcm-oss, snd-mixer-oss and snd-seq-oss. 14 When you need to access the OSS PCM, mixer or sequencer devices, the 18 is called. The alias is defined ``sound-service-x-y``, where x and y are 22 Only necessary step for auto-loading of OSS modules is to define the 25 alias sound-slot-0 snd-emu10k1 27 As the second card, define ``sound-slot-1`` as well. 29 ``alias sound-slot-0 snd-card-0`` doesn't work any more like the old 38 after the corresponding OSS-emulation module is loaded. Don't worry [all …]
|
| D | compress-offload.rst | 2 ALSA Compress-Offload API 5 Pierre-Louis.Bossart <pierre-louis.bossart@linux.intel.com> 12 Since its early days, the ALSA API was defined with PCM support or 18 in system-on-chip designs, and DSPs are also integrated in audio 20 reduction of power consumption compared to host-based 26 ALSA PCM interface, a new 'Compressed Data' API is introduced to 27 provide a control and data-streaming interface for audio DSPs. 29 The design of this API was inspired by the 2-year experience with the 39 - separation between byte counts and time. Compressed formats may have 41 may vary from frame-to-frame. As a result, it is not possible to [all …]
|
| /Documentation/sound/cards/ |
| D | cmipci.rst | 2 Brief Notes on C-Media 8338/8738/8768/8770 Driver 8 Front/Rear Multi-channel Playback 9 --------------------------------- 13 DACs, both streams are handled independently unlike the 4/6ch multi- 16 As default, ALSA driver assigns the first PCM device (i.e. hw:0,0 for 17 card#0) for front and 4/6ch playbacks, while the second PCM device 22 - The first DAC supports U8 and S16LE formats, while the second DAC 24 - The second DAC supports only two channel stereo. 27 rate but only fixed rates: 5512, 8000, 11025, 16000, 22050, 32000, 36 will be FULL VOLUME regardless of Master and PCM volumes [#]_. [all …]
|
| D | bt87x.rst | 19 does audio. snd-bt87x is a driver for the second function. It's a sound 22 into your sound card's line-in you probably don't need this driver if all 44 <alsa-devel@alsa-project.org>, regardless of whether audio capture works 51 The chip knows two different modes (digital/analog). snd-bt87x 52 registers two PCM devices, one for each mode. They cannot be used at 60 rate depends on the external source which feeds the Bt87x with digital 61 sound via I2S interface. 70 maximum sample rate is 1792000 Hz, but audio data becomes unusable
|
| D | audiophile-usb.rst | 2 Guide to using M-Audio Audiophile USB with ALSA and Jack 9 This document is a guide to using the M-Audio Audiophile USB (tm) device with 15 * v1.4 - Thibault Le Meur (2007-07-11) 17 - Added Low Endianness nature of 16bits-modes 19 - Modifying document structure 21 * v1.5 - Thibault Le Meur (2007-07-12) 22 - Added AC3/DTS passthru info 35 - This port supports 2 pairs of line-level audio inputs (1/4" TS and RCA) 36 - When the 1/4" TS (jack) connectors are connected, the RCA connectors 48 * sample rate from 8kHz to 96kHz [all …]
|
| /Documentation/devicetree/bindings/net/ |
| D | lantiq,pef2256.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Herve Codina <herve.codina@bootlin.com> 14 line interface component designed to fulfill all required interfacing between 15 an analog E1/T1/J1 line and the digital PCM system highway/H.100 bus. 20 - const: lantiq,pef2256 27 - description: Master Clock 28 - description: System Clock Receive 29 - description: System Clock Transmit [all …]
|
| /Documentation/devicetree/bindings/sound/ |
| D | maxim,max98504.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> 13 Maxim Integrated MAX98504 speaker amplifier supports I2C control interface 14 with an IRQ output signal, PCM and PDM digital audio interface (DAI) and a 27 DIOVDD-supply: true 28 DVDD-supply: true 29 PVDD-supply: true 31 maxim,brownout-threshold: [all …]
|
| D | nvidia,tegra186-dspk.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/sound/nvidia,tegra186-dspk.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 11 Density Modulation (PDM) transmitter that up-samples the input to 12 the desired sampling rate by interpolation and then converts the 13 over sampled Pulse Code Modulation (PCM) input to the desired 1-bit 17 - Jon Hunter <jonathanh@nvidia.com> 18 - Sameer Pujar <spujar@nvidia.com> 21 - $ref: dai-common.yaml# [all …]
|
| /Documentation/sound/kernel-api/ |
| D | writing-an-alsa-driver.rst | 11 Architecture) <http://www.alsa-project.org/>`__ driver. The document 19 low-level driver implementation details. It only describes the standard 26 ------- 56 -------------- 60 sub-directories contain different modules and are dependent upon the 66 The code for OSS PCM and mixer emulation modules is stored in this 74 This directory and its sub-directories are for the ALSA sequencer. This 76 as snd-seq-midi, snd-seq-virmidi, etc. They are compiled only when 85 ----------------- 88 to be exported to user-space, or included by several files in different [all …]
|
| /Documentation/sound/ |
| D | alsa-configuration.rst | 2 Advanced Linux Sound Architecture - Driver Configuration guide 14 and PCM supports if you want to run OSS applications with ALSA. 38 ---------- 47 limiting card index for auto-loading (1-8); 49 For auto-loading more than one card, specify this option 50 together with snd-card-X aliases. 63 Module snd-pcm-oss 64 ------------------ 66 The PCM OSS emulation module. 70 PCM device number maps assigned to the 1st OSS device; [all …]
|
| /Documentation/driver-api/media/drivers/ |
| D | vidtv.rst | 1 .. SPDX-License-Identifier: GPL-2.0 10 ---------- 18 - A fake tuner driver, which will report a bad signal quality if the chosen 22 - A fake demod driver, which will constantly poll the fake signal quality 26 - A fake bridge driver, which is the module responsible for modprobing the 31 - Code responsible for encoding a valid MPEG Transport Stream, which is then 33 For now, we have a single, audio-only channel containing a single MPEG 34 Elementary Stream, which in turn contains a SMPTE 302m encoded sine-wave. 36 way to encode PCM audio data in a MPEG Transport Stream. 39 -------------- [all …]
|
| D | cx2341x-devel.rst | 1 .. SPDX-License-Identifier: GPL-2.0 7 ----------------------- 12 .. note:: the memory long words are little-endian ('intel format'). 21 .. code-block:: none 23 ivtvctl -O min=0x02000000,max=0x020000ff 26 register space :-). 35 .. code-block:: none 37 0x00000000-0x00ffffff Encoder memory space 38 0x00000000-0x0003ffff Encode.rom 39 ???-??? MPEG buffer(s) [all …]
|
| /Documentation/driver-api/soundwire/ |
| D | stream.rst | 17 stream must have same sample rate and same sample size. 20 interface. Below are some ways a stream can be represented in SoundWire. 24 ------------------------- 26 ------------------------- 31 +---------------+ Clock Signal +---------------+ 32 | Master +----------------------------------+ Slave | 33 | Interface | | Interface | 36 | L + R +----------------------------------+ L + R | 38 +---------------+ +-----------------------> +---------------+ 45 +---------------+ Clock Signal +---------------+ [all …]
|
| /Documentation/devicetree/bindings/clock/ |
| D | samsung,exynos5433-clock.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/clock/samsung,exynos5433-clock.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Chanwoo Choi <cw00.choi@samsung.com> 11 - Krzysztof Kozlowski <krzk@kernel.org> 12 - Sylwester Nawrocki <s.nawrocki@samsung.com> 13 - Tomasz Figa <tomasz.figa@gmail.com> 16 Expected external clocks, defined in DTS as fixed-rate clocks with a matching 18 - "oscclk" - PLL input clock from XXTI [all …]
|