Searched full:performed (Results 1 – 25 of 340) sorted by relevance
12345678910>>...14
| /Documentation/devicetree/bindings/mtd/partitions/ |
| D | partition.yaml | 75 performed.
88 entry itself (the padding is performed only when its parent section is
91 performed.
106 content of the entry itself (the padding is performed only when its
109 no alignment is performed.
|
| /Documentation/driver-api/firmware/ |
| D | lookup-order.rst | 13 * The ''Direct filesystem lookup'' is performed next, if found we
15 * The ''Platform firmware fallback'' is performed next, but only when
|
| D | direct-fs-lookup.rst | 5 Direct filesystem lookup is the most common form of firmware lookup performed
|
| /Documentation/virt/ |
| D | guest-halt-polling.rst | 11 1) The POLL flag is set while polling is performed, which allows
17 The downside of guest side polling is that polling is performed
36 performed before halting.
|
| /Documentation/watchdog/ |
| D | mlx-wdt.rst | 45 The last 2 actions are performed without a system reset.
59 initial timeout, performed action in expiration and configuration flags.
65 Access to HW registers is performed through a generic regmap interface.
|
| /Documentation/ABI/testing/ |
| D | configfs-usb-gadget-tcm | 6 is performed in the "target" subsystem of configfs.
|
| D | sysfs-kernel-mm-numa | 19 is performed before swap. It may move data to a NUMA
|
| /Documentation/arch/powerpc/ |
| D | syscall64-abi.rst | 91 will be performed as normal, and will return as normal. The syscall will be
92 performed in suspended state, so its side effects will be persistent according
101 be performed and the transaction will be doomed by the kernel with the
119 performed with the sc instruction, if it is 0x3000 then the system call was
120 performed with the scv 0 instruction.
147 The vsyscall is performed with a branch-with-link instruction to the vsyscall
|
| /Documentation/networking/ |
| D | checksum-offloads.rst | 52 No offloading of the IP header checksum is performed; it is always done in
107 LCO is performed by the stack when constructing an outer UDP header for an
111 It is also performed when constructing an IPv4 GRE header, in
112 net/ipv4/ip_gre.c:build_header(). It is *not* currently performed when
|
| /Documentation/userspace-api/gpio/ |
| D | chardev_v1.rst | 49 The following operations may be performed on the chip:
78 The following operations may be performed on the line handle:
103 The following operations may be performed on the line event:
|
| D | chardev.rst | 53 The following operations may be performed on the chip:
81 The following operations may be performed on the line request:
|
| /Documentation/driver-api/md/ |
| D | raid5-ppl.rst | 21 contents. PPL recovery is also performed when starting an array after an
37 performed for this stripe (parity is not updated). So it is possible to have
|
| /Documentation/networking/devlink/ |
| D | devlink-reload.rst | 45 being performed without fw activation. Therefore, the devlink reload
46 command returns the list of actions which were actrually performed.
|
| /Documentation/usb/ |
| D | mtouchusb.rst | 19 Performed multiple successful tests with an EXII-5010UC
54 the controller. This means calibration must be performed within the
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-fsl-mc | 17 of the fsl-mc bus is performed. A non-zero value
|
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-cmos.txt | 16 instance). If this is not done, it can be performed by the driver.
|
| D | epson,rtc7301.yaml | 28 The size (in bytes) of the IO accesses that should be performed
|
| /Documentation/userspace-api/media/v4l/ |
| D | pixfmt-bayer.rst | 13 performed on the image. The formats contain green, red and blue components, with
|
| /Documentation/arch/x86/ |
| D | tlb.rst | 21 1. The size of the flush being performed. A flush of the entire
22 address space is obviously better performed by flushing the
|
| /Documentation/hwmon/ |
| D | mcp3021.rst | 35 Communication to the MCP3021/MCP3221 is performed using a 2-wire I2C
|
| /Documentation/devicetree/bindings/net/ |
| D | broadcom-bcm87xx.txt | 14 value of zero, no read of the existing value is performed.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | syscon-common.yaml | 43 The size (in bytes) of the IO accesses that should be performed
|
| /Documentation/devicetree/bindings/mmc/ |
| D | mmc-pwrseq-emmc.yaml | 15 performed just after MMC core enabled power to the given mmc host (to
|
| /Documentation/driver-api/soundwire/ |
| D | stream.rst | 222 to be performed like prepare, enable, disable, de-prepare etc.
274 of the stream. Operations performed before entering in this state:
277 runtime is used as a reference for all the operations performed
304 Configuration state of stream. Operations performed before entering in
339 Prepare state of stream. Operations performed before entering in this state:
383 Operations performed before entering in this state:
412 Operations performed before entering in this state:
448 De-prepare state of stream. Operations performed before entering in this
482 Release state of stream. Operations performed before entering in this state:
|
| /Documentation/virt/kvm/s390/ |
| D | s390-diag.rst | 42 are performed.
83 If the function code specifies 0x501, breakpoint functions may be performed.
|
12345678910>>...14