Searched full:physically (Results 1 – 25 of 83) sorted by relevance
1234
| /Documentation/networking/ |
| D | smc-sysctl.rst | 29 Default: 0 (physically contiguous sndbufs and RMBs)
33 - 0 - Use physically contiguous buffers
35 - 2 - Mixed use of the two types. Try physically contiguous buffers first.
|
| /Documentation/devicetree/bindings/net/nfc/ |
| D | st,st21nfca.yaml | 22 Specifies that an ese is physically connected to the controller
33 Specifies that the uicc swp signal can be physically connected to the
|
| D | st,st-nci.yaml | 25 Specifies that an ese is physically connected to the controller
36 Specifies that the uicc swp signal can be physically connected to the
|
| /Documentation/ABI/testing/ |
| D | sysfs-firmware-sgi_uv | 72 This value is used to physically identify a hub within a system.
148 of the CPU physically connected to the corresponding PCI bus.
151 corresponding PCI bus. This value is used to physically locate
|
| /Documentation/devicetree/bindings/arm/ |
| D | arm,integrator.yaml | 27 rapid prototyping. See ARM DUI 0098B. This board can physically come
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-mt6323.txt | 23 describes the initial behavior for each LED physically and currently only four
|
| D | awinic,aw200xx.yaml | 70 and depends on how leds are physically connected to the led driver.
|
| /Documentation/networking/devlink/ |
| D | devlink-linecard.rst | 41 being physically connected or powered-up
46 be physically connected to the port
|
| /Documentation/power/ |
| D | suspend-and-cpuhotplug.rst | 203 c. When a CPU is physically hot-unplugged and a new (and possibly different
229 physically removing or inserting CPUs, the CPUs are not actually powered
240 [Note that we don't expect someone to physically pull out nodes and insert
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | ovti,ov2680.yaml | 36 This corresponds to the hardware pin XSHUTDOWN which is physically
|
| D | ovti,ov8856.yaml | 56 This corresponds to the hardware pin XSHUTDOWN which is physically
|
| D | ovti,ov5675.yaml | 52 This corresponds to the hardware pin XSHUTDN which is physically
|
| D | ovti,ov5693.yaml | 70 This corresponds to the hardware pin XSHUTDN which is physically
|
| D | toshiba,tc358746.yaml | 64 This corresponds to the hardware pin RESX which is physically active low.
|
| /Documentation/litmus-tests/ |
| D | README | 59 physically moving P1()'s two reads from x under the lock.
|
| /Documentation/watchdog/ |
| D | wdt.rst | 17 boards physically pull the machine down off their own onboard timers and
|
| /Documentation/core-api/ |
| D | memory-allocation.rst | 159 and related functions is not physically contiguous.
167 physically contiguous.
|
| D | swiotlb.rst | 64 buffer memory is physically contiguous. The expectation is that the DMA layer
90 allocations must be physically contiguous, the entire default memory pool is
211 must be physically contiguous, so the size is limited to MAX_PAGE_ORDER pages
|
| /Documentation/devicetree/bindings/bus/ |
| D | qcom,ssc-block-bus.yaml | 118 …// devices under this node are physically located in the SSC block, connected to an ssc-internal b…
|
| /Documentation/power/regulator/ |
| D | consumer.rst | 89 configuration changes and the voltage is physically set when the regulator is
121 limit configuration changes and the current limit is physically set when the
|
| /Documentation/driver-api/gpio/ |
| D | bt8xxgpio.rst | 16 How to physically access the GPIO pins
|
| /Documentation/admin-guide/mm/ |
| D | concepts.rst | 199 necessary to allocate large physically contiguous memory areas. Such
206 physically contiguous areas become possible.
|
| /Documentation/scsi/ |
| D | ChangeLog.ips | 8 4.90.11 - Don't actually RESET unless it's physically required
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-peripheral-props.yaml | 105 The devices are physically on a different buses but will always
|
| /Documentation/sound/designs/ |
| D | jack-injection.rst | 14 jack or to some audio jacks, we don't need to physically access the
|
1234