Searched full:properly (Results 1 – 25 of 273) sorted by relevance
1234567891011
| /Documentation/admin-guide/ |
| D | highuid.rst | 22 properly with huge UIDs. If it can deal with 64-bit file offsets on all
33 uses the 32-bit UID system calls properly otherwise.
43 - Validate that all filesystems behave properly.
78 - make sure that the UID mapping feature of AX25 networking works properly
|
| /Documentation/hwmon/ |
| D | adm1025.rst | 52 properly, you'll have a wrong +12V reading or a wrong VID reading. The way
54 process, assuming that the BIOS set it up properly beforehand. If it turns
|
| D | f71882fg.rst | 145 properly.
162 RPM mode, it will also set fan#_full_speed properly, if it does not then
163 fan control will not work properly, unless you set a sane fan#_full_speed
|
| D | shtc1.rst | 56 is used. Make sure clock-stretching works properly on your device if you
|
| /Documentation/scheduler/ |
| D | sched-debug.rst | 23 detect if pages are properly placed or if the data should be migrated to a
31 behaviour. If pages are properly placed then the scan delay increases,
|
| /Documentation/ABI/testing/ |
| D | sysfs-class | 13 work properly.
|
| D | sysfs-bus-optee-devices | 16 tee-supplicant to function properly or not. This attribute will be present for
|
| D | debugfs-wilco-ec | 6 tests, we need to ensure that the H1 chip is properly setting
|
| D | sysfs-bus-coresight-devices-stm | 7 properly and a sink has been identified for it. The path
|
| /Documentation/process/ |
| D | volatile-considered-harmful.rst | 23 unwanted optimization. If they are being used properly, there will be no
25 almost certainly a bug in the code somewhere. In properly-written kernel
106 been properly thought through.
|
| /Documentation/networking/dsa/ |
| D | bcm_sf2.rst | 71 in order to properly configure them. By default, the SF2 pseudo-PHY address, and
86 firmware gets reloaded. The SF2 driver relies on such events to properly set its
87 MoCA interface carrier state and properly report this to the networking stack.
|
| /Documentation/arch/x86/i386/ |
| D | IO-APIC.rst | 81 between the PIRQ lines. (distributing IRQ sources properly is not a
107 permute all IRQ numbers properly ... it will take some time though. An
109 won't function properly (e.g. if it's inserted as a module).
|
| /Documentation/livepatch/ |
| D | cumulative-patches.rst | 81 that are necessary to properly replace any older patch.
102 callback. It is called only when the livepatch is properly disabled.
|
| /Documentation/devicetree/bindings/media/ |
| D | st-rc.txt | 19 properly for IRB pins.
|
| /Documentation/scsi/ |
| D | qlogicfas.rst | 59 Make sure it works properly under DOS. You should also do an initial FDISK
72 that the file copied properly. (Turn off all caching when doing these
|
| /Documentation/devicetree/bindings/misc/ |
| D | xlnx,tmr-inject.yaml | 16 recovery logic is working properly.
|
| /Documentation/arch/arm/omap/ |
| D | omap.rst | 13 properly.
|
| /Documentation/ABI/obsolete/ |
| D | sysfs-gpio | 22 /<LINE-NAME> ... for a properly named GPIO line
|
| /Documentation/devicetree/bindings/sound/ |
| D | qcom,q6usb.yaml | 15 XHCI host controller properly for enabling the offloaded audio stream.
|
| /Documentation/i2c/busses/ |
| D | i2c-piix4.rst | 42 The PIIX4 (properly known as the 82371AB) is an Intel chip with a lot of
100 not working properly.
|
| /Documentation/arch/powerpc/ |
| D | booting.rst | 13 doesn't follow them properly. In addition, since the advent of the arch/powerpc
76 used by the assembly code to properly disable the MMU
|
| /Documentation/core-api/ |
| D | kobject.rst | 123 The ktype is required for a kobject to be created properly, as every kobject
131 properly. If the kobject is to be associated with a specific kset,
151 To properly access the name of the kobject, use the function
177 have been initialized properly, as userspace will instantly start to look
413 any other sysfs housekeeping will be handled for the caller properly.
432 For a more complete example of using ksets and kobjects properly, see the
|
| /Documentation/i2c/ |
| D | ten-bit-addresses.rst | 23 code (or it's there but not working properly.) Software implementation
|
| /Documentation/devicetree/bindings/remoteproc/ |
| D | wkup_m3_rproc.txt | 23 provide an appropriate ranges property for properly
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-image-process.rst | 46 used to test if a device is working properly.
|
1234567891011