Searched full:pulled (Results 1 – 25 of 41) sorted by relevance
12
| /Documentation/devicetree/bindings/iio/pressure/ |
| D | hoperf,hp03.yaml | 24 The XCLR pin is a reset of the ADC in the chip, it must be pulled
26 registers and pulled LO afterward.
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | veml6030.yaml | 34 - 0x10 # ADDR pin pulled down
35 - 0x48 # ADDR pin pulled up
|
| /Documentation/devicetree/bindings/sound/ |
| D | everest,es7241.yaml | 33 the sdout. If the sdout is pulled down, leftj format is used.
34 If this property is not provided, sdout is assumed to pulled
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-max3191x.txt | 31 pulled high (8-bit mode). Use this if the modesel pin
35 that modesel is pulled low (16-bit mode).
|
| D | nxp,pcf8575.yaml | 60 the input (pulled-up) state.
|
| /Documentation/dev-tools/ |
| D | index.rst | 6 be used to work on the kernel. For now, the documents have been pulled
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | ti,dac7612.yaml | 29 DACs are loaded when the pin connected to this GPIO is pulled low.
|
| D | adi,ad5592r.yaml | 104 * CH_OFFSTATE_PULLDOWN (the pin is pulled down)
|
| /Documentation/devicetree/bindings/extcon/ |
| D | qcom,pm8941-misc.yaml | 14 the USB ID pin has been pulled low or high.
|
| /Documentation/fb/ |
| D | metronomefb.rst | 17 The display and error status are each pulled through individual GPIOs.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | samsung,s2mps11.yaml | 49 power. Usually the ACOKB is pulled up to VBATT so when PWRHOLD pin goes
55 Indicates that WRSTBI pin of PMIC is pulled down. When the system is
|
| D | tps6507x.txt | 29 0: If defdcdc pin of DCDC2/DCDC3 is pulled to GND.
|
| /Documentation/process/ |
| D | 7.AdvancedTopics.rst | 53 will, of course, need a server that can be pulled from. Setting up such a
85 have pulled into their repositories, you will make life much more difficult
119 can affect your ability to get trees pulled in the future. Quoting Linus:
|
| /Documentation/maintainer/ |
| D | rebasing-and-merging.rst | 49 should usually not be changed. Others may have pulled a copy of your
62 have pulled changes from another developer's repository, you are now a
197 tree fails to be pulled upstream, whatever problems it had will block the
|
| D | pull-requests.rst | 136 against (to show the correct changes to be pulled and the diffstat). The
152 asking to be pulled from, git will complain saying it is not there,
|
| D | maintainer-entry-profile.rst | 30 - Git branches that are pulled into -next?
|
| D | messy-diffstat.rst | 77 to be pulled into, but to do it privately, as if it were the source of
|
| /Documentation/devicetree/bindings/usb/ |
| D | samsung,exynos-usb2.yaml | 44 needs to be pulled up for the bus to be powered.
|
| /Documentation/devicetree/bindings/leds/ |
| D | kinetic,ktd2692.yaml | 20 Also, When the AUX pin is pulled high while CTRL pin is high,
|
| /Documentation/scsi/ |
| D | lpfc.rst | 32 received from the midlayer. In the cases where a cable was pulled, link
|
| D | ChangeLog.sym53c8xx_2 | 33 - Check against GPIO3 pulled low for HVD controllers (driver did
|
| /Documentation/power/ |
| D | charger-manager.rst | 199 At the charger/battery-related events such as battery-pulled-out,
200 charger-pulled-out, charger-inserted, DCIN-over/under-voltage, charger-stopped,
|
| /Documentation/arch/arm/nwfpe/ |
| D | todo.rst | 59 pulled out from some docs on ARM floating point, specifically
|
| /Documentation/devicetree/bindings/iio/resolver/ |
| D | adi,ad2s1210.yaml | 113 the type of fault present, if any. As these pins a pulled low to indicate
|
| /Documentation/doc-guide/ |
| D | contributing.rst | 149 many of those comments are never pulled into the docs build. That makes
160 kerneldoc comments for internal use; those should not be pulled into the
|
12