Searched full:references (Results 1 – 25 of 312) sorted by relevance
12345678910>>...13
| /Documentation/doc-guide/ |
| D | parse-headers.rst | 6 order to describe the userspace API and to generate cross-references
7 between the code and the documentation. Adding cross-references for
12 cross-references. It has to be called via Makefile, while building the
26 enums and defines and create cross-references to a Sphinx book.
65 included via ..parsed-literal block with cross-references for the
73 enums and enum symbols and create cross-references for all of them.
84 The \ **ignore**\ means that it won't generate cross references for a
92 The \ **replace**\ means that it will generate cross references for a
140 references for \ **typedef**\ , \ **enum**\ and \ **struct**\ types. It will use :ref:
162 It won't generate cross-references for \ **PRIVATE**\ .
|
| /Documentation/gpu/dp-mst/ |
| D | topology-figure-2.dot | 9 /* Driver malloc references */
24 /* Topology references */
32 /* Malloc references */
|
| D | topology-figure-1.dot | 9 /* Driver malloc references */
24 /* Topology references */
30 /* Malloc references */
|
| D | topology-figure-3.dot | 12 /* Driver malloc references */
26 /* Topology references */
34 /* Malloc references */
|
| /Documentation/devicetree/ |
| D | dynamic-resolution-notes.rst | 21 3. Using the __local__fixups__ node information adjust all local references
23 4. For each property in the __fixups__ node locate the node it references
|
| /Documentation/firmware-guide/acpi/dsd/ |
| D | graph.rst | 16 hierarchical data extension supports nodes with references to other
41 for generic data node references.
76 The references to endpoints must be always done both ways, to the
151 References chapter
157 [data-node-ref] Documentation/firmware-guide/acpi/dsd/data-node-references.rst
|
| D | data-node-references.rst | 13 document defines a scheme to implement such references.
17 node object. Do not use non-string references as this will produce a copy of
89 References chapter
|
| D | leds.rst | 33 show below. Objects not relevant for LEDs or the references to them have been
86 References chapter
92 [data-node-ref] Documentation/firmware-guide/acpi/dsd/data-node-references.rst
|
| /Documentation/bpf/ |
| D | graph_ds_impl.rst | 81 Non-owning references
159 Let's enumerate the properties of both types of references.
184 From verifier's perspective non-owning references can only exist
191 To prevent this logic violation all non-owning references are invalidated by the
193 not page fault" property of non-owning references. So if the verifier hasn't
237 3) n and m are non-owning references, they both point to the same node
255 We prevent both by generalizing the "invalidate non-owning references" behavior
|
| /Documentation/mm/ |
| D | page_frags.rst | 38 was implemented. It allows for freeing multiple references from a single
40 cleaning up the multiple references that were added to a page in order to
|
| D | page_migration.rst | 71 Calling folio_isolate_lru() increases the references to the folio
88 if all references to a folio are removable at the time. The folio has
101 4. All the page table references to the page are converted to migration
110 6. The refcount of the page is examined and we back out if references remain.
|
| /Documentation/devicetree/bindings/phy/ |
| D | phy-lantiq-rcu-usb2.txt | 22 - clocks : References to the (PMU) "phy" clk gate.
24 - resets : References to the RCU USB configuration reset bits.
|
| D | phy-ath79-usb.txt | 7 - resets: references to the reset controllers
|
| /Documentation/livepatch/ |
| D | shadow-vars.rst | 26 A hashtable references all shadow variables. These references are
86 - find and remove any <_, id> references from global hashtable
214 3. References
|
| /Documentation/devicetree/bindings/siox/ |
| D | eckelmann,siox-gpio.txt | 5 - din-gpios, dout-gpios, dclk-gpios, dld-gpios: references gpios for the
|
| /Documentation/firmware-guide/acpi/ |
| D | index.rst | 12 dsd/data-node-references
|
| /Documentation/driver-api/80211/ |
| D | introduction.rst | 17 References to this standard will be given as "802.11-2007 8.1.5".
|
| /Documentation/sphinx/ |
| D | automarkup.py | 64 # to the creation of incorrect and confusing cross references. So
74 # Detect references to commits.
105 # Sort all references by the starting position in text
287 # these references if this is explicitly requested.)
298 # avoid adding cross-references to functions that have been explicitly
|
| /Documentation/arch/openrisc/ |
| D | todo.rst | 12 - Finish the renaming cleanup... there are references to or32 in the code
|
| /Documentation/usb/ |
| D | usb-help.rst | 2 USB references
|
| /Documentation/misc-devices/ |
| D | c2port.rst | 32 References chapter
35 The C2 Interface main references are at (https://www.silabs.com)
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | maxim,max1363.yaml | 13 Family of ADCs with i2c interface, internal references and threshold
|
| /Documentation/devicetree/bindings/arm/ |
| D | arm,scu.yaml | 17 References:
|
| /Documentation/admin-guide/laptops/ |
| D | disk-shock-protection.rst | 14 3. References
32 section 3. References below for pointers to more information about
124 3. References
|
| /Documentation/arch/x86/ |
| D | amd_hsmp.rst | 16 Eg: https://www.amd.com/content/dam/amd/en/documents/epyc-technical-docs/programmer-references/5589…
101 eg: https://www.amd.com/content/dam/amd/en/documents/epyc-technical-docs/programmer-references/5589…
|
12345678910>>...13