Home
last modified time | relevance | path

Searched +full:regulator +full:- +full:soft +full:- +full:start (Results 1 – 8 of 8) sorted by relevance

/Documentation/devicetree/bindings/regulator/
Dqcom-labibb-regulator.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/qcom-labibb-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Qualcomm's LAB(LCD AMOLED Boost)/IBB(Inverting Buck Boost) Regulator
10 - Sumit Semwal <sumit.semwal@linaro.org>
19 const: qcom,pmi8998-lab-ibb
23 $ref: regulator.yaml#
27 qcom,soft-start-us:
28 description: Regulator soft start time in microseconds.
[all …]
Dmps,mpq7920.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/mps,mpq7920.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Saravanan Sekar <sravanhome@gmail.com>
14 pattern: "pmic@[0-9a-f]{1,2}"
17 - mps,mpq7920
27 after their hardware counterparts BUCK[1-4], one LDORTC, and LDO[2-5]
30 mps,switch-freq:
40 $ref: regulator.yaml#
[all …]
Dregulator.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/regulator/regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Liam Girdwood <lgirdwood@gmail.com>
11 - Mark Brown <broonie@kernel.org>
14 regulator-name:
15 description: A string used as a descriptive name for regulator outputs
18 regulator-min-microvolt:
21 regulator-max-microvolt:
[all …]
Dqcom,spmi-regulator.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/regulator/qcom,spmi-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Robert Marko <robimarko@gmail.com>
15 - qcom,pm6125-regulators
16 - qcom,pm660-regulators
17 - qcom,pm660l-regulators
18 - qcom,pm8004-regulators
19 - qcom,pm8005-regulators
[all …]
/Documentation/devicetree/bindings/sound/
Dcs35l33.txt5 - compatible : "cirrus,cs35l33"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VP-supply : power supplies for the device,
11 Documentation/devicetree/bindings/regulator/regulator.txt.
15 - reset-gpios : gpio used to reset the amplifier
17 - interrupts : IRQ line info CS35L33.
18 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
21 - cirrus,boost-ctl : Booster voltage use to supply the amp. If the value is
26 - cirrus,ramp-rate : On power up, it affects the time from when the power
27 up sequence begins to the time the audio reaches a full-scale output.
[all …]
/Documentation/devicetree/bindings/mfd/
Dx-powers,axp152.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mfd/x-powers,axp152.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: X-Powers AXP PMIC
10 - Chen-Yu Tsai <wens@csie.org>
13 - if:
18 - x-powers,axp152
19 - x-powers,axp202
20 - x-powers,axp209
[all …]
/Documentation/sound/soc/
Ddapm.rst11 management frameworks and, as such, can easily co-exist with them.
32 The graph for the STM32MP1-DK1 sound card is shown in picture:
34 .. kernel-figure:: dapm-graph.svg
100 Regulator
101 External regulator that supplies power to audio components.
139 (Widgets are defined in include/sound/soc-dapm.h)
142 There are convenience macros defined in soc-dapm.h that can be used to quickly
150 ---------------------
179 -------------------
208 ----------------------
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]