Searched full:require (Results 1 – 25 of 490) sorted by relevance
12345678910>>...20
| /Documentation/devicetree/bindings/nvmem/layouts/ |
| D | nvmem-layout.yaml | 15 Most NVMEM layouts are static and thus do not require additional description
17 define and might require dynamic reading of the NVMEM device in order to
|
| /Documentation/admin-guide/perf/ |
| D | arm-ccn.rst | 26 Crosspoint PMU events require "xp" (index), "bus" (bus number)
30 require "xp" and "vc" as above plus "port" (device port index),
40 not require any other settings.
|
| D | arm-ni.rst | 13 domain. These require qualifying with the "eventid" and "nodeid" parameters
|
| /Documentation/arch/powerpc/ |
| D | vmemmap_dedup.rst | 14 With 2M PMD level mapping, we require 32 struct pages and a single 64K vmemmap
18 With 1G PUD level mapping, we require 16384 struct pages and a single 64K
20 require 16 64K pages in vmemmap to map the struct page for 1G PUD level mapping.
48 require 8 4K pages in vmemmap to map the struct page for 2M pmd level mapping.
74 With 1G PUD level mapping, we require 262144 struct pages and a single 4K
76 require 4096 4K pages in vmemmap to map the struct pages for 1G PUD level
|
| /Documentation/scheduler/ |
| D | membarrier.rst | 14 require each architecture to have a full memory barrier after coming from
24 require each architecture to have a full memory barrier after updating rq->curr,
|
| /Documentation/ABI/testing/ |
| D | sysfs-devices-power_resources_wakeup | 7 require ACPI power resources for wakeup signaling.
|
| D | devlink-resource-mlxsw | 11 require reload before the changes take effect.
|
| /Documentation/networking/dsa/ |
| D | bcm_sf2.rst | 63 driver require a struct device to be bound to a struct device_node, but things
70 Broadcom switches connected to a SF2 require the use of the DSA user MDIO bus
82 MoCA interfaces are fairly specific and require the use of a firmware blob which
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | nuvoton,nct7802.yaml | 67 # For channels RTD1, RTD2 and RTD3, require sensor-type to be set.
86 # For channels RTD1 and RTD2 and if sensor-type is "temperature", require
|
| /Documentation/devicetree/bindings/net/ |
| D | smsc-lan87xx.txt | 3 Some boards require special tuning values. Configure them
|
| /Documentation/filesystems/ |
| D | virtiofs.rst | 17 Guests often require access to files residing on the host or remote systems.
23 tasks, they require configuration steps that are hard to automate and they
|
| /Documentation/userspace-api/gpio/ |
| D | gpio-v2-get-line-ioctl.rst | 66 The drive flags, ``GPIO_V2_LINE_FLAG_OPEN_xxx``, require the
75 The edge flags, ``GPIO_V2_LINE_FLAG_EDGE_xxx``, require
125 configuration for platforms that support internal bias as those that require
|
| D | gpio-get-linehandle-ioctl.rst | 68 The drive flags, ``GPIOHANDLE_REQUEST_OPEN_xxx``, require the
106 configuration for platforms that support internal bias as those that require
|
| /Documentation/devicetree/bindings/reset/ |
| D | brcm,bcm63138-pmb.txt | 7 Require properties:
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | clockdomain.txt | 5 only needs this information for specific clocks which require
|
| /Documentation/devicetree/bindings/powerpc/4xx/ |
| D | hsta.txt | 13 Require properties:
|
| /Documentation/process/ |
| D | development-process.rst | 12 discussion which does not require a deep knowledge of kernel programming to
|
| /Documentation/devicetree/bindings/sound/ |
| D | nvidia,tegra30-ahub.txt | 33 Tegra114 and later additionally require:
36 Tegra124 and later additionally require:
|
| /Documentation/dev-tools/kunit/ |
| D | faq.rst | 20 require installing the kernel on a test machine or in a virtual machine. All
21 testing frameworks require tests to be written in userspace and run on the
37 In short, yes, you can run KUnit on other architectures, but it might require
|
| /Documentation/userspace-api/media/dvb/ |
| D | dvb-fe-read-status.rst | 22 Most statistics require the demodulator to be fully locked
|
| /Documentation/devicetree/bindings/fpga/ |
| D | altera-passive-serial.txt | 5 The passive serial link is not technically SPI, and might require extra
|
| /Documentation/devicetree/bindings/clock/ |
| D | samsung,exynos-ext-clock.yaml | 16 Samsung SoCs require an external clock supplied through XXTI or XusbXTI pins.
|
| /Documentation/arch/arm/samsung/ |
| D | gpio.rst | 16 specific calls for the items that require Samsung specific handling, such
|
| /Documentation/devicetree/bindings/gpu/ |
| D | aspeed-gfx.txt | 8 * In addition, the ASPEED pinctrl bindings require the 'syscon' property to
|
| /Documentation/userspace-api/media/mediactl/ |
| D | media-controller-intro.rst | 30 applications really require based on limited information, thereby
|
12345678910>>...20