Searched +full:riscv +full:- +full:sbi (Results 1 – 7 of 7) sorted by relevance
| /Documentation/devicetree/bindings/perf/ |
| D | riscv,pmu.yaml | 1 # SPDX-License-Identifier: BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/perf/riscv,pmu.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: RISC-V SBI PMU events
10 - Atish Patra <atishp@rivosinc.com>
13 The SBI PMU extension allows supervisor software to configure, start and
15 capabilities of performance analysis tools, such as perf, if the SBI PMU
20 Without the event to counter mappings, the SBI PMU extension cannot be used.
29 For information on the SBI specification see the section "Performance
[all …]
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | riscv,cpu-intc.yaml | 1 # SPDX-License-Identifier: GPL-2.0 OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/interrupt-controller/riscv,cpu-intc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: RISC-V Hart-Level Interrupt Controller (HLIC)
10 RISC-V cores include Control Status Registers (CSRs) which are local to
11 each CPU core (HART in RISC-V terminology) and can be read or written by
16 The RISC-V supervisor ISA manual specifies three interrupt sources that are
19 cores. The timer interrupt comes from an architecturally mandated real-
20 time timer that is controlled via Supervisor Binary Interface (SBI) calls
[all …]
|
| /Documentation/devicetree/bindings/cpu/ |
| D | idle-states.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/cpu/idle-states.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
11 - Anup Patel <anup@brainfault.org>
15 1 - Introduction
18 ARM and RISC-V systems contain HW capable of managing power consumption
19 dynamically, where cores can be put in different low-power states (ranging
22 run-time, can be specified through device tree bindings representing the
[all …]
|
| /Documentation/devicetree/bindings/timer/ |
| D | riscv,timer.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/timer/riscv,timer.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: RISC-V timer
10 - Anup Patel <anup@brainfault.org>
13 RISC-V platforms always have a RISC-V timer device for the supervisor-mode
14 based on the time CSR defined by the RISC-V privileged specification. The
15 timer interrupts of this device are configured using the RISC-V SBI Time
16 extension or the RISC-V Sstc extension.
[all …]
|
| /Documentation/arch/riscv/ |
| D | boot.rst | 1 .. SPDX-License-Identifier: GPL-2.0
4 RISC-V Kernel Boot Requirements and Constraints
10 This document describes what the RISC-V kernel expects from bootloaders and
16 Pre-kernel Requirements and Constraints
19 The RISC-V kernel expects the following of bootloaders and platform firmware:
22 --------------
24 The RISC-V kernel expects:
30 ---------
32 The RISC-V kernel expects:
37 -------------------------------------
[all …]
|
| /Documentation/virt/kvm/ |
| D | api.rst | 1 .. SPDX-License-Identifier: GPL-2.0
4 The Definitive KVM (Kernel-based Virtual Machine) API Documentation
13 - System ioctls: These query and set global attributes which affect the
17 - VM ioctls: These query and set attributes that affect an entire virtual
24 - vcpu ioctls: These query and set attributes that control the operation
32 - device ioctls: These query and set attributes that control the operation
80 facility that allows backward-compatible extensions to the API to be
104 the ioctl returns -ENOTTY.
122 -----------------------
139 -----------------
[all …]
|
| /Documentation/admin-guide/ |
| D | kernel-parameters.txt | 16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]
|