Searched +full:rx +full:- +full:max +full:- +full:burst (Results 1 – 11 of 11) sorted by relevance
| /Documentation/devicetree/bindings/usb/ |
| D | snps,dwc3.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Felipe Balbi <balbi@kernel.org> 14 be presented as a standalone DT node with an optional vendor-specific 18 - $ref: usb-drd.yaml# 19 - if: 25 - dr_mode 29 $ref: usb-xhci.yaml# 35 - const: snps,dwc3 [all …]
|
| D | chipidea,usb2-common.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/usb/chipidea,usb2-common.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Xu Yang <xu.yang_2@nxp.com> 25 clock-names: 31 power-domains: 37 reset-names: 40 "#reset-cells": 45 itc-setting: [all …]
|
| /Documentation/devicetree/bindings/dma/ |
| D | renesas,nbpfaxi.txt | 1 * Renesas "Type-AXI" NBPFAXI* DMA controllers 7 - compatible: must be one of 17 - #dma-cells: must be 2: the first integer is a terminal number, to which this 26 - max-burst-mem-read: limit burst size for memory reads 28 than using the maximum burst size allowed by the hardware's buffer size. 29 - max-burst-mem-write: limit burst size for memory writes 31 than using the maximum burst size allowed by the hardware's buffer size. 32 If both max-burst-mem-read and max-burst-mem-write are set, DMA_MEM_TO_MEM 35 You can use dma-channels and dma-requests as described in dma.txt, although they 40 dma: dma-controller@48000000 { [all …]
|
| D | img-mdc-dma.txt | 1 * IMG Multi-threaded DMA Controller (MDC) 4 - compatible: Must be "img,pistachio-mdc-dma". 5 - reg: Must contain the base address and length of the MDC registers. 6 - interrupts: Must contain all the per-channel DMA interrupts. 7 - clocks: Must contain an entry for each entry in clock-names. 8 See ../clock/clock-bindings.txt for details. 9 - clock-names: Must include the following entries: 10 - sys: MDC system interface clock. 11 - img,cr-periph: Must contain a phandle to the peripheral control syscon 13 - img,max-burst-multiplier: Must be the maximum supported burst size multiplier. [all …]
|
| /Documentation/devicetree/bindings/net/ |
| D | snps,dwmac.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Alexandre Torgue <alexandre.torgue@foss.st.com> 11 - Giuseppe Cavallaro <peppe.cavallaro@st.com> 12 - Jose Abreu <joabreu@synopsys.com> 23 - snps,dwmac 24 - snps,dwmac-3.40a 25 - snps,dwmac-3.50a 26 - snps,dwmac-3.610 [all …]
|
| D | ibm,emac.txt | 8 correct clock-frequency property. 13 - device_type : "network" 15 - compatible : compatible list, contains 2 entries, first is 16 "ibm,emac-CHIP" where CHIP is the host ASIC (440gx, 18 "ibm,emac4". For Axon, thus, we have: "ibm,emac-axon", 20 - interrupts : <interrupt mapping for EMAC IRQ and WOL IRQ> 21 - reg : <registers mapping> 22 - local-mac-address : 6 bytes, MAC address 23 - mal-device : phandle of the associated McMAL node 24 - mal-tx-channel : 1 cell, index of the tx channel on McMAL associated [all …]
|
| /Documentation/networking/ |
| D | pktgen.rst | 1 .. SPDX-License-Identifier: GPL-2.0 7 Enable CONFIG_NET_PKTGEN to compile and build pktgen either in-kernel 27 Tuning NIC for max performance 31 overload type of benchmarking, as this could hurt the normal use-case. 35 # ethtool -G ethX tx 1024 44 ring-buffers for various performance reasons, and packets stalling 48 (Intel 82599 chip). This driver (ixgbe) combines TX+RX ring cleanups, 49 and the cleanup interval is affected by the ethtool --coalesce setting 50 of parameter "rx-usecs". 54 # ethtool -C ethX rx-usecs 30 [all …]
|
| D | ethtool-netlink.rst | 27 wake-on-lan password) omitted. 37 number 1 but any non-zero value should be understood as "true" by recipient. 44 Attributes that need to be filled-in by device drivers and that are dumped to 98 representing bit values and mask of affected bits) and bit-by-bit (list of 101 Verbose (bit-by-bit) bitsets allow sending symbolic names for bits together 126 rounded up to a multiple of 32 bits. They consist of 32-bit words in host byte 141 Bit-by-bit form: nested (bitset) attribute contents: 143 +------------------------------------+--------+-----------------------------+ 145 +------------------------------------+--------+-----------------------------+ 147 +------------------------------------+--------+-----------------------------+ [all …]
|
| /Documentation/netlink/specs/ |
| D | ethtool.yaml | 1 # SPDX-License-Identifier: ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 5 protocol: genetlink-legacy 10 - 11 name: udp-tunnel-type 12 enum-name: 14 entries: [ vxlan, geneve, vxlan-gpe ] 15 - 19 - 20 name: header-flags 22 entries: [ compact-bitsets, omit-reply, stats ] [all …]
|
| D | devlink.yaml | 1 # SPDX-License-Identifier: ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 5 protocol: genetlink-legacy 10 - 12 name: sb-pool-type 14 - 16 - 18 - 20 name: port-type 22 - 24 - [all …]
|
| /Documentation/networking/device_drivers/ethernet/stmicro/ |
| D | stmmac.rst | 1 .. SPDX-License-Identifier: GPL-2.0+ 13 - In This Release 14 - Feature List 15 - Kernel Configuration 16 - Command Line Parameters 17 - Driver Information and Notes 18 - Debug Information 19 - Support 33 (and older) and DesignWare(R) Cores Ethernet Quality-of-Service version 4.0 35 DesignWare(R) Cores XGMAC - 10G Ethernet MAC and DesignWare(R) Cores [all …]
|