Home
last modified time | relevance | path

Searched full:smp2p (Results 1 – 13 of 13) sorted by relevance

/Documentation/devicetree/bindings/soc/qcom/
Dqcom,smp2p.yaml4 $id: http://devicetree.org/schemas/soc/qcom/qcom,smp2p.yaml#
15 The Shared Memory Point to Point (SMP2P) protocol facilitates communication
23 const: qcom,smp2p
43 remote end of the smp2p edge.
67 Each SMP2P pair contain a set of inbound and outbound entries, these are
68 described in subnodes of the smp2p device node. The node names are not
122 # The following example shows the SMP2P setup with the wireless processor,
129 compatible = "qcom,smp2p";
/Documentation/devicetree/bindings/mailbox/
Dqcom-ipcc.yaml17 Modem's interrupts via Shared Memory Point to Point (SMP2P) interface. In such
19 SMP2P (signal-id is 2). The SMP2P itself falls under the Multiprocessor (MPROC)
/Documentation/devicetree/bindings/net/
Dqcom,ipa.yaml23 See also soc/qcom/qcom,smp2p.txt and interconnect/interconnect.txt. See
88 - description: Modem clock query interrupt (smp2p interrupt)
89 - description: Modem setup ready interrupt (smp2p interrupt)
130 description: The names of the state bits used for SMP2P output
217 smp2p-mpss {
218 compatible = "qcom,smp2p";
/Documentation/devicetree/bindings/remoteproc/
Dqcom,pas-common.yaml62 description: The names of the state bits used for SMP2P output
Dqcom,qcs404-cdsp-pil.yaml97 description: The names of the state bits used for SMP2P output
Dqcom,sdm845-adsp-pil.yaml97 description: The names of the state bits used for SMP2P output
Dqcom,sc7280-adsp-pil.yaml96 description: The names of the state bits used for SMP2P output
Dqcom,sc7280-wpss-pil.yaml109 description: The names of the state bits used for SMP2P output
Dqcom,sc7180-mss-pil.yaml139 description: The names of the state bits used for SMP2P output
Dqcom,wcnss-pil.yaml87 description: The names of the state bits used for SMP2P output
Dqcom,sc7280-mss-pil.yaml153 description: The names of the state bits used for SMP2P output
/Documentation/devicetree/bindings/net/wireless/
Dqcom,ath10k.yaml144 description: The names of the state bits used for SMP2P output.
146 - const: wlan-smp2p-out
Dqcom,ath11k.yaml80 description: The names of the state bits used for SMP2P output.
82 - const: wlan-smp2p-out
459 qcom,smem-state-names = "wlan-smp2p-out";