Home
last modified time | relevance | path

Searched +full:tbi +full:- +full:handle (Results 1 – 6 of 6) sorted by relevance

/Documentation/devicetree/bindings/net/
Dfsl-tsec-phy.txt5 the definition of the PHY node in booting-without-of.txt for an example
9 - reg : Offset and length of the register set for the device, and optionally
10 the offset and length of the TBIPA register (TBI PHY address
14 - compatible : Should define the compatible device type for the
16 - "fsl,gianfar-tbi"
17 - "fsl,gianfar-mdio"
18 - "fsl,etsec2-tbi"
19 - "fsl,etsec2-mdio"
20 - "fsl,ucc-mdio"
21 - "fsl,fman-mdio"
[all …]
Dfsl,fman-dtsec.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/net/fsl,fman-dtsec.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Madalin Bucur <madalin.bucur@nxp.com>
15 10/100/1000 MBit/s speeds, and the 10-Gigabit Ethernet Media Access Controller
17 Ethernet Media Access Controller (mEMAC) to handle all speeds.
22 - fsl,fman-dtsec
23 - fsl,fman-xgec
24 - fsl,fman-memac
[all …]
Dethernet-controller.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/net/ethernet-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - David S. Miller <davem@davemloft.net>
19 local-mac-address:
22 $ref: /schemas/types.yaml#/definitions/uint8-array
26 mac-address:
31 local-mac-address property.
32 $ref: /schemas/types.yaml#/definitions/uint8-array
[all …]
Dfsl,fman.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Frank Li <Frank.Li@nxp.com>
13 Due to the fact that the FMan is an aggregation of sub-engines (ports, MACs,
19 - fsl,fman
26 cell-index:
31 The cell-index value may be used by the SoC, to identify the
33 there's a description of the cell-index use in each SoC:
35 - P1023:
[all …]
Dibm,emac.txt8 correct clock-frequency property.
13 - device_type : "network"
15 - compatible : compatible list, contains 2 entries, first is
16 "ibm,emac-CHIP" where CHIP is the host ASIC (440gx,
18 "ibm,emac4". For Axon, thus, we have: "ibm,emac-axon",
20 - interrupts : <interrupt mapping for EMAC IRQ and WOL IRQ>
21 - reg : <registers mapping>
22 - local-mac-address : 6 bytes, MAC address
23 - mal-device : phandle of the associated McMAL node
24 - mal-tx-channel : 1 cell, index of the tx channel on McMAL associated
[all …]
/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/
Ducc.txt4 - device_type : should be "network", "hldc", "uart", "transparent"
6 - compatible : could be "ucc_geth" or "fsl_atm" and so on.
7 - cell-index : the ucc number(1-8), corresponding to UCCx in UM.
8 - reg : Offset and length of the register set for the device
9 - interrupts : <a b> where a is the interrupt number and b is a
14 - pio-handle : The phandle for the Parallel I/O port configuration.
15 - port-number : for UART drivers, the port number to use, between 0 and 3.
18 CPM UART driver, the port-number is required for the QE UART driver.
19 - soft-uart : for UART drivers, if specified this means the QE UART device
20 driver should use "Soft-UART" mode, which is needed on some SOCs that have
[all …]