Searched full:transmitting (Results  1 – 25 of 64) sorted by relevance
123
| /Documentation/devicetree/bindings/serial/ | 
| D | nvidia,tegra194-tcu.yaml | 17   for transmitting and one for receiving, that is used to communicate 40       transmitting data from and to the hardware UART. 43       - description: mailbox for transmitting data to hardware UART
  | 
| /Documentation/devicetree/bindings/leds/ | 
| D | allwinner,sun50i-a100-ledc.yaml | 70     description: Length of high pulse when transmitting a "0" bit 74     description: Length of low pulse when transmitting a "0" bit 78     description: Length of high pulse when transmitting a "1" bit 82     description: Length of low pulse when transmitting a "1" bit
  | 
| /Documentation/userspace-api/media/rc/ | 
| D | lirc-get-send-mode.rst | 34     The mode used for transmitting. 65        -  Device does not support transmitting.
  | 
| D | lirc-get-features.rst | 52     :ref:`LIRC_MODE_PULSE <lirc-mode-pulse>` can only be used for transmitting.
  | 
| /Documentation/scsi/ | 
| D | cxgb3i.rst | 18 	  On transmitting, Chelsio S3 h/w computes and inserts the Header and 32 	  On transmitting, S3 h/w accepts the complete PDU (header + data)
  | 
| /Documentation/devicetree/bindings/media/ | 
| D | st-rc.txt | 14 	  protocol used for transmitting remote control signals. tx-mode should
  | 
| /Documentation/devicetree/bindings/display/ | 
| D | lvds.yaml | 27       data lanes, transmitting bits for slots 6 to 0 instead of 0 to 6.
  | 
| /Documentation/devicetree/bindings/iio/health/ | 
| D | ti,afe4404.yaml | 20     description: Supply to transmitting LEDs.
  | 
| D | ti,afe4403.yaml | 20     description: Supply to transmitting LEDs.
  | 
| /Documentation/devicetree/bindings/soc/fsl/cpm_qe/ | 
| D | fsl,ucc-hdlc.yaml | 83       slots used for transmitting and receiving. 90       slots used for transmitting and receiving.
  | 
| /Documentation/devicetree/bindings/net/ | 
| D | airoha,en8811h.yaml | 37       Reverse tx polarity of SERDES. This is the transmitting
  | 
| /Documentation/devicetree/bindings/sound/ | 
| D | imx-audio-hdmi.yaml | 29       This is a boolean property. If present, the transmitting function
  | 
| D | fsl,rpmsg.yaml | 76       This is a boolean property. If present, the transmitting function
  | 
| /Documentation/userspace-api/media/cec/ | 
| D | cec-pin-error-inj.rst | 93 receiving CEC messages and those relating to transmitting CEC messages. In 158     keeps transmitting after the first byte was NACKed. 190     stop transmitting ('Arbitration Lost'). This is very hard to test, 200     This setting changes the behavior of transmitting CEC messages. Normally 293     Just stop transmitting after this bit.  If <op> specifies a specific CEC
  | 
| D | cec-ioc-receive.rst | 148 	transmitting the message. Ignored by :ref:`ioctl CEC_RECEIVE <CEC_RECEIVE>`. 176 	transmitting the Poll message. 227       - Normally CEC messages are validated before transmitting them. If this
  | 
| /Documentation/devicetree/bindings/phy/ | 
| D | allwinner,sun6i-a31-mipi-dphy.yaml | 52       - "tx" for transmitting (e.g. when used with MIPI DSI).
  | 
| /Documentation/devicetree/bindings/dsp/ | 
| D | mediatek,mt8186-dsp.yaml | 52       - description: mailbox for transmitting requests to audio DSP.
  | 
| D | mediatek,mt8195-dsp.yaml | 54       - description: mailbox for transmitting requests to audio DSP.
  | 
| /Documentation/userspace-api/media/v4l/ | 
| D | field-order.rst | 16 rates similar to film the image would fade out too quickly. Transmitting 21 at a time, merely transmitting the frames separated into fields. The
  | 
| /Documentation/bpf/ | 
| D | redirect.rst | 28     Not all drivers support transmitting frames after a redirect, and for
  | 
| /Documentation/input/ | 
| D | userio.rst | 61 Registers the port with the serio driver and begins transmitting data back and
  | 
| /Documentation/userspace-api/media/drivers/ | 
| D | cx2341x-uapi.rst | 23 transmitting this block the first line of the block on the right to the 31 second line of 8 UV pairs of the top-left block, etc. After transmitting
  | 
| /Documentation/networking/mac80211_hwsim/ | 
| D | mac80211_hwsim.rst | 44 currently enabled and on the same channel as the transmitting
  | 
| /Documentation/networking/ | 
| D | xsk-tx-metadata.rst | 7 This document describes how to enable offloads when transmitting packets
  | 
| /Documentation/devicetree/bindings/mailbox/ | 
| D | ti,omap-mailbox.yaml | 69       two such channels - one for transmitting (Tx) and one for receiving (Rx). 72           mailbox fifo id used either for transmitting on ti,mbox-tx channel or
  | 
        123