Searched full:turbo (Results 1 – 25 of 25) sorted by relevance
| /Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7944.yaml | 108 turbo-gpios:
110 GPIO connected to the TURBO line. If omitted, it is assumed that the TURBO
111 line is hard-wired and the state is determined by the adi,always-turbo
115 adi,always-turbo:
118 When present, this property indicates that the TURBO line is hard-wired
119 and the state is always high. If neither this property nor turbo-gpios is
120 present, the TURBO line is assumed to be hard-wired and the state is
162 # chain mode has lower SCLK max rate and doesn't work when TURBO is enabled
173 adi,always-turbo: false
179 # turbo-gpios and adi,always-turbo are mutually exclusive
[all …]
|
| /Documentation/ABI/testing/ |
| D | sysfs-platform-msi-laptop | 46 Contains either 0 or 1 and indicates if turbo mode is turned
47 on. In turbo mode power LED is orange and processor is
48 overclocked. Turbo mode is available only if charging. It is
49 only possible to toggle turbo mode state by pressing Fn+F10,
51 If user presses Fn+F10 too frequent, turbo mode state is not
70 * 0 -> Turbo mode is off
71 * 1 -> Turbo mode is on, cannot be turned off yet
72 * 2 -> Turbo mode is off, cannot be turned on yet
73 * 3 -> Turbo mode is on
|
| D | sysfs-devices-system-cpu | 335 no_turbo: limits the driver to selecting P states below the turbo
436 frequency is throttled to lower frequency in turbo (at and above
440 max frequency is throttled to lower frequency in sub-turbo(below
|
| /Documentation/admin-guide/pm/ |
| D | intel_pstate.rst | 222 the so-called "turbo" frequency ranges). In other words, in the passive mode
232 Turbo P-states Support
238 will be referred to as the "turbo threshold" in what follows.
240 The P-states above the turbo threshold are referred to as "turbo P-states" and
241 the whole sub-range of P-states they belong to is referred to as the "turbo
242 range". These names are related to the Turbo Boost technology allowing a
247 Specifically, if software sets the P-state of a CPU core within the turbo range
248 (that is, above the turbo threshold), the processor is permitted to take over
249 performance scaling control for that core and put it into turbo P-states of its
253 the given core, even if it is within the turbo range, whereas all of the later
[all …]
|
| D | intel-speed-select.rst | 75 Intel(R) SST-TF (feature turbo-freq) is supported
155 speed-select-turbo-freq:disabled
184 speed-select-turbo-freq:disabled
216 workload, disable turbo::
292 (Intel(R) SST-BF) and Intel(R) Speed Select Technology - Turbo Frequency (Intel
299 speed-select-turbo-freq:disabled
303 speed-select-turbo-freq:disabled
312 "speed-select-turbo-freq" (Intel(R) SST-TF) is supported at both performance
468 clos-max:Max Turbo frequency
478 clos-max:Max Turbo frequency
[all …]
|
| D | cpufreq_drivers.rst | 236 This is due to "turbo boost" available on recent Intel processors. If certain
|
| D | cpufreq.rst | 610 For Intel processors it is referred to as "Turbo Boost", AMD calls it
611 "Turbo-Core" or (in technical documentation) "Core Performance Boost" and so on.
|
| /Documentation/devicetree/bindings/misc/ |
| D | xlnx,sd-fec.yaml | 15 which provides high-throughput LDPC and Turbo Code implementations.
17 customer specified Quasi-cyclic (QC) codes. The Turbo decode functionality
67 decoding and encoding and Turbo code decoding. The LDPC codes used are
69 a codeword-by-codeword basis. The Turbo code decoding is required by LTE
73 enum: [ ldpc, turbo ]
|
| /Documentation/scheduler/ |
| D | schedutil.rst | 68 4C-turbo; if available and turbo enabled
69 f_max := { 1C-turbo; if turbo enabled
76 We pick 4C turbo over 1C turbo to make it slightly more sustainable.
|
| /Documentation/misc-devices/ |
| D | xilinx_sdfec.rst | 21 - Configuration of Turbo decoding
49 - Load the configuration parameters for either Turbo decode or LDPC encode or decode
58 the Turbo decode or LDPC encode or decode. The role of the driver is to allow
111 - Set Turbo decode, LPDC encode or decode parameters, depending on how the
161 Set Turbo Decode
164 …Turbo decode parameters is done by using the ioctl :c:macro:`XSDFEC_SET_TURBO` using auto-generate…
166 Adding Turbo decode can only be done if the following restrictions are met:
168 …` filled by the ioctl :c:macro:`XSDFEC_GET_CONFIG` indicates the SD-FEC core is configured as TURBO
179 …l :c:macro:`XSDFEC_GET_CONFIG` indicates the SD-FEC core is configured as TURBO then the enabling …
|
| /Documentation/hwmon/ |
| D | oxp-sensors.rst | 22 of the "Turbo/Silent" button of the device. It will change the key event
55 "Turbo/Silent" button behaviour toggle is only supported on:
85 Read Write. Read this attribute to check the status of the turbo/silent
|
| /Documentation/translations/zh_CN/scheduler/ |
| D | schedutil.rst | 68 4C-turbo; 如果可用并且使能了turbo
69 f_max := { 1C-turbo; 如果使能了turbo
76 我们选择4C turbo而不是1C turbo，以使其更持久性略微更强。
|
| /Documentation/userspace-api/media/dvb/ |
| D | frontend-property-satellite-systems.rst | 71 Turbo code delivery system
74 In addition to all parameters valid for DVB-S, turbo code supports the
|
| D | frontend.rst | 18 - Satellite systems: DVB-S, DVB-S2, DVB Turbo, ISDB-S, DSS
|
| /Documentation/devicetree/bindings/opp/ |
| D | opp-v2-base.yaml | 148 turbo-mode:
150 Marks the OPP to be used only for turbo modes. Turbo mode is available
|
| D | opp-v2.yaml | 75 turbo-mode;
159 turbo-mode;
239 turbo-mode;
265 turbo-mode;
|
| D | operating-points-v2-ti-cpu.yaml | 50 turbo-mode: true
|
| /Documentation/admin-guide/media/ |
| D | dvb-usb-rtl28xxu-cardlist.rst | 65 * - TURBO-X Pure TV Tuner DTT-2000
|
| /Documentation/iio/ |
| D | ad4000.rst | 35 CS mode, 3-wire turbo mode
41 "CS Mode, 3-Wire Turbo Mode" connection in datasheets.
|
| D | ad7944.rst | 109 - ``TURBO`` mode
|
| /Documentation/input/devices/ |
| D | bcm5974.rst | 19 :Copyright: |copy| 2005 Frank Arnold (frank@scirocco-5v-turbo.de)
|
| D | joystick-parport.rst | 115 connectors. Anyway, if you've got a gamepad, and it has buttons A, B, Turbo
116 A, Turbo B, Select and Start, and is connected through 5 wires, then it is
|
| /Documentation/networking/ |
| D | plip.rst | 26 LapLink null-printer cable [can also work in turbo mode, with a PLIP
138 "Null Printer" or "Turbo Laplink" cable. It can be constructed with
|
| /Documentation/timers/ |
| D | no_hz.rst | 247 this parameter effectively disables Turbo Mode on Intel
|
| /Documentation/input/joydev/ |
| D | joystick.rst | 517 * AVB Mag Turbo Force
|