Searched +full:tx +full:- +full:max +full:- +full:burst (Results 1 – 12 of 12) sorted by relevance
| /Documentation/devicetree/bindings/usb/ |
| D | snps,dwc3.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Felipe Balbi <balbi@kernel.org> 14 be presented as a standalone DT node with an optional vendor-specific 18 - $ref: usb-drd.yaml# 19 - if: 25 - dr_mode 29 $ref: usb-xhci.yaml# 35 - const: snps,dwc3 [all …]
|
| D | chipidea,usb2-common.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/usb/chipidea,usb2-common.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Xu Yang <xu.yang_2@nxp.com> 25 clock-names: 31 power-domains: 37 reset-names: 40 "#reset-cells": 45 itc-setting: [all …]
|
| /Documentation/devicetree/bindings/dma/ |
| D | renesas,nbpfaxi.txt | 1 * Renesas "Type-AXI" NBPFAXI* DMA controllers 7 - compatible: must be one of 17 - #dma-cells: must be 2: the first integer is a terminal number, to which this 26 - max-burst-mem-read: limit burst size for memory reads 28 than using the maximum burst size allowed by the hardware's buffer size. 29 - max-burst-mem-write: limit burst size for memory writes 31 than using the maximum burst size allowed by the hardware's buffer size. 32 If both max-burst-mem-read and max-burst-mem-write are set, DMA_MEM_TO_MEM 35 You can use dma-channels and dma-requests as described in dma.txt, although they 40 dma: dma-controller@48000000 { [all …]
|
| D | img-mdc-dma.txt | 1 * IMG Multi-threaded DMA Controller (MDC) 4 - compatible: Must be "img,pistachio-mdc-dma". 5 - reg: Must contain the base address and length of the MDC registers. 6 - interrupts: Must contain all the per-channel DMA interrupts. 7 - clocks: Must contain an entry for each entry in clock-names. 8 See ../clock/clock-bindings.txt for details. 9 - clock-names: Must include the following entries: 10 - sys: MDC system interface clock. 11 - img,cr-periph: Must contain a phandle to the peripheral control syscon 13 - img,max-burst-multiplier: Must be the maximum supported burst size multiplier. [all …]
|
| /Documentation/devicetree/bindings/net/ |
| D | snps,dwmac.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Alexandre Torgue <alexandre.torgue@foss.st.com> 11 - Giuseppe Cavallaro <peppe.cavallaro@st.com> 12 - Jose Abreu <joabreu@synopsys.com> 23 - snps,dwmac 24 - snps,dwmac-3.40a 25 - snps,dwmac-3.50a 26 - snps,dwmac-3.610 [all …]
|
| D | ibm,emac.txt | 8 correct clock-frequency property. 13 - device_type : "network" 15 - compatible : compatible list, contains 2 entries, first is 16 "ibm,emac-CHIP" where CHIP is the host ASIC (440gx, 18 "ibm,emac4". For Axon, thus, we have: "ibm,emac-axon", 20 - interrupts : <interrupt mapping for EMAC IRQ and WOL IRQ> 21 - reg : <registers mapping> 22 - local-mac-address : 6 bytes, MAC address 23 - mal-device : phandle of the associated McMAL node 24 - mal-tx-channel : 1 cell, index of the tx channel on McMAL associated [all …]
|
| /Documentation/networking/ |
| D | pktgen.rst | 1 .. SPDX-License-Identifier: GPL-2.0 7 Enable CONFIG_NET_PKTGEN to compile and build pktgen either in-kernel 27 Tuning NIC for max performance 31 overload type of benchmarking, as this could hurt the normal use-case. 33 Specifically increasing the TX ring buffer in the NIC:: 35 # ethtool -G ethX tx 1024 37 A larger TX ring can improve pktgen's performance, while it can hurt 38 in the general case, 1) because the TX ring buffer might get larger 43 TX ring cause delay. Drivers usually delay cleaning up the 44 ring-buffers for various performance reasons, and packets stalling [all …]
|
| D | ethtool-netlink.rst | 27 wake-on-lan password) omitted. 37 number 1 but any non-zero value should be understood as "true" by recipient. 44 Attributes that need to be filled-in by device drivers and that are dumped to 98 representing bit values and mask of affected bits) and bit-by-bit (list of 101 Verbose (bit-by-bit) bitsets allow sending symbolic names for bits together 126 rounded up to a multiple of 32 bits. They consist of 32-bit words in host byte 141 Bit-by-bit form: nested (bitset) attribute contents: 143 +------------------------------------+--------+-----------------------------+ 145 +------------------------------------+--------+-----------------------------+ 147 +------------------------------------+--------+-----------------------------+ [all …]
|
| D | ip-sysctl.rst | 1 .. SPDX-License-Identifier: GPL-2.0 10 ip_forward - BOOLEAN 11 - 0 - disabled (default) 12 - not 0 - enabled 20 ip_default_ttl - INTEGER 25 ip_no_pmtu_disc - INTEGER 27 fragmentation-required ICMP is received, the PMTU to this 38 accept fragmentation-needed errors if the underlying protocol 48 Possible values: 0-3 52 min_pmtu - INTEGER [all …]
|
| /Documentation/netlink/specs/ |
| D | ethtool.yaml | 1 # SPDX-License-Identifier: ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 5 protocol: genetlink-legacy 10 - 11 name: udp-tunnel-type 12 enum-name: 14 entries: [ vxlan, geneve, vxlan-gpe ] 15 - 19 - 20 name: header-flags 22 entries: [ compact-bitsets, omit-reply, stats ] [all …]
|
| D | devlink.yaml | 1 # SPDX-License-Identifier: ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 5 protocol: genetlink-legacy 10 - 12 name: sb-pool-type 14 - 16 - 18 - 20 name: port-type 22 - 24 - [all …]
|
| /Documentation/networking/device_drivers/ethernet/stmicro/ |
| D | stmmac.rst | 1 .. SPDX-License-Identifier: GPL-2.0+ 13 - In This Release 14 - Feature List 15 - Kernel Configuration 16 - Command Line Parameters 17 - Driver Information and Notes 18 - Debug Information 19 - Support 33 (and older) and DesignWare(R) Cores Ethernet Quality-of-Service version 4.0 35 DesignWare(R) Cores XGMAC - 10G Ethernet MAC and DesignWare(R) Cores [all …]
|