Home
last modified time | relevance | path

Searched +full:valid +full:- +full:wakeup +full:- +full:mask (Results 1 – 11 of 11) sorted by relevance

/Documentation/devicetree/bindings/interrupt-controller/
Darm,vic.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/interrupt-controller/arm,vic.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Rob Herring <robh@kernel.org>
15 be nested or have the outputs wire-OR'd together.
18 - $ref: /schemas/interrupt-controller.yaml#
23 - arm,pl190-vic
24 - arm,pl192-vic
25 - arm,versatile-vic
[all …]
Dbrcm,bcm7038-l1-intc.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/interrupt-controller/brcm,bcm7038-l1-intc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Broadcom BCM7038-style Level 1 interrupt controller
11 directly to one of the HW INT lines on each CPU. Every BCM7xxx set-top chip
16 - 64, 96, 128, or 160 incoming level IRQ lines
18 - Most onchip peripherals are wired directly to an L1 input
20 - A separate instance of the register set for each CPU, allowing individual
23 - Atomic mask/unmask operations
[all …]
/Documentation/ABI/testing/
Dsysfs-class-rc6 The rc/ class sub-directory belongs to the Remote Controller
33 Writing "-proto" will remove a protocol from the list of enabled
51 expected value of the bits set in the filter mask.
63 Sets the scancode filter mask of bits to compare.
66 value. A value of 0 disables the filter to allow all valid
81 for the wakeup filter, something like::
83 "rc-5 nec nec-x rc-6-0 rc-6-6a-24 [rc-6-6a-32] rc-6-mce"
86 "rc-5", "rc-6" have their different bit length encodings
89 The enabled wakeup protocol is shown in [] brackets.
93 Writing "proto" will use "proto" for wakeup events.
[all …]
/Documentation/userspace-api/media/rc/
Drc-sysfs-nodes.rst1 .. SPDX-License-Identifier: GPL-2.0 OR GFDL-1.1-no-invariants-or-later
9 As defined at ``Documentation/ABI/testing/sysfs-class-rc``, those are
18 The ``/sys/class/rc/`` class sub-directory belongs to the Remote
45 Writing "-proto" will remove a protocol from the list of enabled
64 expected value of the bits set in the filter mask. If the hardware
76 Sets the scancode filter mask of bits to compare. Use in combination
79 filter to allow all valid scancodes to be processed.
93 wakeup filter, something like::
95 rc-5 nec nec-x rc-6-0 rc-6-6a-24 [rc-6-6a-32] rc-6-mce
97 Note that protocol variants are listed, so ``nec``, ``sony``, ``rc-5``, ``rc-6``
[all …]
/Documentation/devicetree/bindings/usb/
Dmediatek,mtu3.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Chunfeng Yun <chunfeng.yun@mediatek.com>
14 - $ref: usb-drd.yaml
23 - enum:
24 - mediatek,mt2712-mtu3
25 - mediatek,mt8173-mtu3
26 - mediatek,mt8183-mtu3
27 - mediatek,mt8186-mtu3
[all …]
/Documentation/driver-api/pm/
Dcpuidle.rst1 .. SPDX-License-Identifier: GPL-2.0
18 cores) is idle after an interrupt or equivalent wakeup event, which means that
89 code, and that causes the kernel to run the architecture-specific
91 until the ``->enable()`` governor callback is invoked for that CPU
103 It is expected to reverse any changes made by the ``->enable()``
143 selection made by the ``->select()`` callback (when it was invoked last
148 quality of service (PM QoS) constraints on the processor wakeup latency into
150 PM QoS wakeup latency constraint for a given CPU, a ``CPUIdle`` governor is
152 :c:func:`cpuidle_governor_latency_req()`. Then, the governor's ``->select()``
190 state to start executing the first instruction after a wakeup from it,
[all …]
/Documentation/driver-api/
Dparport-lowlevel.rst5 :Time-stamp: <2000-02-24 13:30:20 twaugh>
34 Port functions (can be overridden by low-level drivers):
37 port->ops->read_data
38 port->ops->write_data
39 port->ops->read_status
40 port->ops->read_control
41 port->ops->write_control
42 port->ops->frob_control
43 port->ops->enable_irq
44 port->ops->disable_irq
[all …]
/Documentation/arch/powerpc/
Dcxl.rst28 +----------+ +---------+
34 +----------+ +---------+
36 | +------+ | PSL |
37 | | CAPP |<------>| |
38 +---+------+ PCIE +---------+
65 - POWER8 and PSL Version 8 are compliant to the CAIA Version 1.0.
66 - POWER9 and PSL Version 9 are compliant to the CAIA Version 2.0.
72 * Supports sending ASB_Notify messages for host thread wakeup.
123 The WED is a 64-bit parameter passed to the AFU when a context is
157 https://github.com/ibm-capi/libcxl
[all …]
/Documentation/virt/kvm/
Dapi.rst1 .. SPDX-License-Identifier: GPL-2.0
4 The Definitive KVM (Kernel-based Virtual Machine) API Documentation
13 - System ioctls: These query and set global attributes which affect the
17 - VM ioctls: These query and set attributes that affect an entire virtual
24 - vcpu ioctls: These query and set attributes that control the operation
32 - device ioctls: These query and set attributes that control the operation
80 facility that allows backward-compatible extensions to the API to be
104 the ioctl returns -ENOTTY.
122 -----------------------
139 -----------------
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
72 The debug_level mask defaults to "info". See
[all …]
/Documentation/scsi/
DChangeLog.lpfc2 * Please read the associated RELEASE-NOTES file !!!
8 * Fixed build warning for 2.6.12-rc2 kernels: mempool_alloc now
19 * Removed FC_TRANSPORT_PATCHESxxx defines. They're in 2.6.12-rc1.
26 * Added PCI ID for LP10000-S.
31 * Zero-out response sense length in lpfc_scsi_prep_cmnd to prevent
33 - was causing spurious 0710 messages.
55 - stop using volatile. if you need special ordering use memory
57 - switch lpfc_sli_pcimem_bcopy to take void * arguments.
58 - remove typecast for constants - a U postfix marks them
60 - add a MAILBOX_CMD_SIZE macro, as most users of
[all …]