Home
last modified time | relevance | path

Searched +full:wp +full:- +full:inverted (Results 1 – 5 of 5) sorted by relevance

/Documentation/devicetree/bindings/mmc/
Dmmc-controller.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mmc/mmc-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Ulf Hansson <ulf.hansson@linaro.org>
25 "#address-cells":
30 "#size-cells":
37 broken-cd:
42 cd-gpios:
47 non-removable:
[all …]
Dfsl,esdhc.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
14 - Frank Li <Frank.Li@nxp.com>
19 - enum:
20 - fsl,mpc8536-esdhc
21 - fsl,mpc8378-esdhc
22 - fsl,p2020-esdhc
23 - fsl,p4080-esdhc
24 - fsl,t1040-esdhc
[all …]
Datmel-hsmci.txt7 by mmc.txt and the properties used by the atmel-mci driver.
12 - compatible: should be "atmel,hsmci"
13 - #address-cells: should be one. The cell is the slot id.
14 - #size-cells: should be zero.
15 - at least one slot node
16 - clock-names: tuple listing input clock names.
18 - clocks: phandles to input clocks.
28 #address-cells = <1>;
29 #size-cells = <0>;
30 clock-names = "mci_clk";
[all …]
/Documentation/devicetree/bindings/mtd/
Draw-nand-chip.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/raw-nand-chip.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Miquel Raynal <miquel.raynal@bootlin.com>
13 - $ref: nand-chip.yaml#
21 The interpretation of these parameters is implementation-defined, so
28 pattern: "^nand@[a-f0-9]$"
32 Contains the chip-select IDs.
34 nand-ecc-placement:
[all …]
/Documentation/devicetree/bindings/gpio/
Dgpio.txt5 -----------------
7 GPIO properties should be named "[<name>-]gpios", with <name> being the purpose
8 of this GPIO for the device. While a non-existent <name> is considered valid
10 for new bindings. Also, GPIO properties named "[<name>-]gpio" are valid and old
24 and bit-banged data signals:
27 gpio-controller;
28 #gpio-cells = <2>;
32 data-gpios = <&gpio1 12 0>,
39 such as if the consumer desire the line to be active low (inverted) or open
44 recommended to use the two-cell approach.
[all …]