Searched +full:zynq +full:- +full:gpio +full:- +full:1 (Results 1 – 5 of 5) sorted by relevance
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-zynq.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/gpio/gpio-zynq.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Xilinx Zynq GPIO controller 10 - Michal Simek <michal.simek@amd.com> 15 - xlnx,zynq-gpio-1.0 16 - xlnx,zynqmp-gpio-1.0 17 - xlnx,versal-gpio-1.0 18 - xlnx,pmc-gpio-1.0 [all …]
|
| /Documentation/devicetree/bindings/reset/ |
| D | zynq-reset.txt | 1 Xilinx Zynq Reset Manager 3 The Zynq AP-SoC has several different resets. 5 See Chapter 26 of the Zynq TRM (UG585) for more information about Zynq resets. 8 - compatible: "xlnx,zynq-reset" 9 - reg: SLCR offset and size taken via syscon <0x200 0x48> 10 - syscon: <&slcr> 11 This should be a phandle to the Zynq's SLCR registers. 12 - #reset-cells: Must be 1 14 The Zynq Reset Manager needs to be a childnode of the SLCR. 18 compatible = "xlnx,zynq-reset"; [all …]
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | xlnx,pinctrl-zynq.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause 3 --- 4 $id: http://devicetree.org/schemas/pinctrl/xlnx,pinctrl-zynq.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Xilinx Zynq Pinctrl 10 - Sai Krishna Potthuri <sai.krishna.potthuri@amd.com> 13 Please refer to pinctrl-bindings.txt in this directory for details of the 17 Zynq's pin configuration nodes act as a container for an arbitrary number of 21 parameters, such as pull-up, slew rate, etc. 31 const: xlnx,pinctrl-zynq [all …]
|
| /Documentation/devicetree/bindings/firmware/xilinx/ |
| D | xlnx,zynqmp-firmware.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/firmware/xilinx/xlnx,zynqmp-firmware.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Nava kishore Manne <nava.kishore.manne@amd.com> 12 description: The zynqmp-firmware node describes the interface to platform 23 - description: For implementations complying for Zynq Ultrascale+ MPSoC. 24 const: xlnx,zynqmp-firmware 26 - description: For implementations complying for Versal. 27 const: xlnx,versal-firmware [all …]
|
| /Documentation/devicetree/bindings/fpga/ |
| D | fpga-region.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 4 $id: http://devicetree.org/schemas/fpga/fpga-region.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Michal Simek <michal.simek@amd.com> 14 - Introduction 15 - Terminology 16 - Sequence 17 - FPGA Region 18 - Supported Use Models [all …]
|