Searched full:backup (Results 1 – 25 of 78) sorted by relevance
1234
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-palmas.txt | 10 - ti,backup-battery-chargeable: The Palmas series device like TPS65913 or
11 TPS80036 supports the backup battery for powering the RTC when main
12 battery is removed or in very low power state. The backup battery
16 - ti,backup-battery-charge-high-current: Enable high current charging in
17 backup battery. Device supports the < 100uA and > 100uA charging.
28 ti,backup-battery-chargeable;
29 ti,backup-battery-charge-high-current;
|
| D | abracon,abx80x.yaml | 39 Required to enable charging backup battery.
51 Required to enable charging backup battery.
|
| D | epson,rx8900.yaml | 28 Disable voltage detector. Should be set if no backup battery is used.
|
| D | st,stm32-rtc.yaml | 42 access control register at offset, and change the dbp (Disable Backup
43 Protection) bit represented by the mask, mandatory to disable/enable backup
|
| /Documentation/ABI/testing/ |
| D | sysfs-driver-bd9571mwv-regulator | 5 Description: Read/write the current state of DDR Backup Mode, which controls
11 Backup Mode is enabled by default when available, as the
16 1. Configure PMIC for backup mode, to change the role of
26 DDR Backup Mode must be explicitly enabled by the user,
|
| D | rtc-cdev | 38 status of the main and backup voltages.
41 need user interaction when the backup power provider is
|
| D | sysfs-devices-platform-trackpoint | 21 (RW) Backup range for z-axis press.
82 (RW) When the skipback bit is set, backup cursor movement during
|
| /Documentation/device-mapper/ |
| D | dm-bow.txt | 1 dm_bow (backup on write)
55 BACKUP
61 writes from the true sector zero are redirected to. Note that like any backup
68 to or used for backup. On being written to, a FREE sector is changed to CHANGED.
71 without further backup.
73 BACKUP means that this is a free sector being used as a backup. On being written
76 All backup operations are logged to the first sector. The log sector has the
|
| /Documentation/devicetree/bindings/mfd/ |
| D | rohm,bd9571mwv.yaml | 34 rohm,ddr-backup-power:
39 Value to use for DDR-Backup Power (default 0).
41 powered when backup mode is entered, for system suspend:
114 rohm,ddr-backup-power = <0xf>;
|
| D | atmel-gpbr.txt | 1 * Device tree bindings for Atmel GPBR (General Purpose Backup Registers)
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | twl4030-charger.yaml | 34 description: microvolts for charging the backup battery
38 description: microamps for charging the backup battery
|
| D | qcom,pm8941-coincell.yaml | 11 used to provide power backup for certain features of the power management
|
| /Documentation/devicetree/bindings/mtd/partitions/ |
| D | brcm,bcm947xx-cfe-partitions.yaml | 28 5) Backup TRX firmware used after failed upgrade
31 configuration. For example both: main firmware and backup firmware use the
|
| /Documentation/hwmon/ |
| D | mc13783-adc.rst | 54 6 General Purpose ADIN6 / Backup Voltage (LICELL) 0 - 2.30V / No /
81 6 General Purpose ADIN6 / Backup Voltage (LICELL) 0 - 2.4V / No
82 Backup Voltage (LICELL) 0 - 3.6V x2/3
|
| D | da9052.rst | 36 Channel 9 VBBAT - measurement of the backup battery voltage
52 The backup battery voltage is calculated as:
|
| /Documentation/netlink/specs/ |
| D | mptcp_pm.yaml | 60 daddr6, sport, dport, backup, if-idx [, error].
67 daddr6, sport, dport, backup, if-idx [, error].
74 daddr6, sport, dport, backup, if-idx [, error].
246 name: backup
|
| /Documentation/networking/ |
| D | bonding.rst | 173 (active-backup, balance-alb and balance-tlb). Possible values
344 backup or 2
346 Validation is performed only for backup slaves.
365 only for backup slaves.
374 that they were generated by an arp_ip_target. Since backup slaves
376 for backup slaves is on the broadcast ARP request sent out via the
378 configurations may result in situations wherein the backup slaves
380 of backup slaves must be disabled.
382 The validation of ARP requests on backup slaves is mainly helping
385 backup slave will work if it's selected as the next active slave.
[all …]
|
| /Documentation/driver-api/mtd/ |
| D | spi-intel.rst | 48 5) Make backup of the existing image first::
55 6) Verify the backup::
|
| /Documentation/arch/arm/stm32/ |
| D | stm32f746-overview.rst | 12 - 1MB internal flash, 320KBytes internal RAM (+4KB of backup SRAM)
|
| D | stm32f769-overview.rst | 12 - 2MB internal flash, 512KBytes internal RAM (+4KB of backup SRAM)
|
| /Documentation/filesystems/ |
| D | btrfs.rst | 28 * Efficient incremental backup and FS mirroring (send/receive)
|
| /Documentation/devicetree/bindings/gnss/ |
| D | mediatek.yaml | 43 Regulator providing backup voltage, pin names such as VBAT or VBACKUP.
|
| D | u-blox,neo-6m.yaml | 46 Backup voltage regulator
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | ti,palmas-gpadc.yaml | 24 8 Backup Battery voltage
|
| /Documentation/devicetree/bindings/firmware/ |
| D | gunyah-cma-mem.yaml | 15 contiguous memory to backup Virtual Machines running on Gunyah. These
|
1234