Searched +full:disable +full:- +full:hibernation +full:- +full:mode (Results 1 – 10 of 10) sorted by relevance
| /Documentation/devicetree/bindings/net/ |
| D | qca,ar803x.yaml | 1 # SPDX-License-Identifier: GPL-2.0+
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Andrew Lunn <andrew@lunn.ch>
11 - Florian Fainelli <f.fainelli@gmail.com>
12 - Heiner Kallweit <hkallweit1@gmail.com>
18 - $ref: ethernet-phy.yaml#
21 qca,clk-out-frequency:
26 qca,clk-out-strength:
31 qca,disable-smarteee:
[all …]
|
| /Documentation/power/ |
| D | userland-swsusp.rst | 25 reading, it is considered to be in the suspend mode. Otherwise it is
26 assumed to be in the resume mode. The device cannot be open for simultaneous
71 return the actual size of the hibernation image
96 swap files (see Documentation/power/swsusp-and-swap-files.rst for
100 enable/disable the hibernation platform support,
104 make the kernel transition the system to the hibernation
109 immediately enter the suspend-to-RAM state, so this call must always
112 is needed to implement the suspend-to-both mechanism in which the
121 - you cannot read() more than one virtual memory page at a time
122 - read()s across page boundaries are impossible (ie. if you read() 1/2 of
[all …]
|
| /Documentation/arch/x86/ |
| D | tdx.rst | 1 .. SPDX-License-Identifier: GPL-2.0
10 mode sits between the host and the guest and manages the guest/host
16 TDX introduces a new CPU mode called Secure Arbitration Mode (SEAM) and
18 CPU-attested software module called 'the TDX module' runs inside the new
22 TDX also leverages Intel Multi-Key Total Memory Encryption (MKTME) to
23 provide crypto-protection to the VMs. TDX reserves part of MKTME KeyIDs
24 as TDX private KeyIDs, which are only accessible within the SEAM mode.
32 TDX boot-time detection
33 -----------------------
41 ---------------------------------------
[all …]
|
| /Documentation/ABI/testing/ |
| D | sysfs-power | 15 labels, which may be "mem" (suspend), "standby" (power-on
16 suspend), "freeze" (suspend-to-idle) and "disk" (hibernation).
21 See Documentation/admin-guide/pm/sleep-states.rst for more
28 The /sys/power/mem_sleep file controls the operating mode of
31 supported). The mode that will be used on subsequent attempts
35 Writing one of the above strings to this file causes the mode
39 See Documentation/admin-guide/pm/sleep-states.rst for more
46 The /sys/power/disk file controls the operating mode of the
47 suspend-to-disk mechanism. Reading from this file returns
51 'firmware' - means that the memory image will be saved to disk
[all …]
|
| D | sysfs-devices-power | 16 RAM) and hibernation (suspend to disk), and to enable or disable
40 space to control the run-time power management of the device.
61 with the main suspend/resume thread) during system-wide power
62 transitions (eg. suspend to RAM, hibernation).
86 attribute is read-only. If the device is not capable to wake up
98 is read-only. If the device is not capable to wake up the
110 state in progress. This attribute is read-only. If the device
122 read-only. If the device is not capable to wake up the system
133 the device is being processed (1). This attribute is read-only.
145 device, in milliseconds. This attribute is read-only. If the
[all …]
|
| /Documentation/admin-guide/ |
| D | kernel-parameters.txt | 16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
45 If set to native, use the device's native backlight mode.
[all …]
|
| /Documentation/admin-guide/laptops/ |
| D | thinkpad-acpi.rst | 9 - Borislav Deianov <borislav@users.sf.net>
10 - Henrique de Moraes Holschuh <hmh@hmh.eng.br>
12 http://ibm-acpi.sf.net/
19 This driver used to be named ibm-acpi until kernel 2.6.21 and release
20 0.13-20070314. It used to be in the drivers/acpi tree, but it was
21 moved to the drivers/misc tree and renamed to thinkpad-acpi for kernel
25 The driver is named "thinkpad-acpi". In some places, like module
29 "tpacpi" is used as a shorthand where "thinkpad-acpi" would be too
33 ------
38 - Fn key combinations
[all …]
|
| /Documentation/driver-api/usb/ |
| D | power-management.rst | 1 .. _usb-power-management:
7 :Date: Last-updated: February 2014
11 ---------
17 * Changing the default idle-delay time
31 -------------------------
35 component is ``suspended`` it is in a nonfunctional low-power state; it
37 ``resumed`` (returned to a functional full-power state) when the kernel
67 ----------------------
85 --------------------------
101 -------------------
[all …]
|
| /Documentation/scsi/ |
| D | ChangeLog.megaraid_sas | 1 Release Date : Thu. Jun 19, 2014 17:00:00 PST 2014 -
2 (emaild-id:megaraidlinux@lsi.com)
7 Current Version : 06.803.02.00-rc1
8 Old Version : 06.803.01.00-rc1
14 -------------------------------------------------------------------------------
15 Release Date : Mon. Mar 10, 2014 17:00:00 PST 2014 -
16 (emaild-id:megaraidlinux@lsi.com)
20 Current Version : 06.803.01.00-rc1
21 Old Version : 06.700.06.00-rc1
25 4. Add Dell PowerEdge VRTX SR-IOV VF device support.
[all …]
|
| /Documentation/virt/kvm/ |
| D | api.rst | 1 .. SPDX-License-Identifier: GPL-2.0
4 The Definitive KVM (Kernel-based Virtual Machine) API Documentation
13 - System ioctls: These query and set global attributes which affect the
17 - VM ioctls: These query and set attributes that affect an entire virtual
24 - vcpu ioctls: These query and set attributes that control the operation
32 - device ioctls: These query and set attributes that control the operation
80 facility that allows backward-compatible extensions to the API to be
104 the ioctl returns -ENOTTY.
122 -----------------------
139 -----------------
[all …]
|