Searched +full:freeze +full:- +full:bridge +full:- +full:controller (Results 1 – 9 of 9) sorted by relevance
| /Documentation/devicetree/bindings/fpga/ |
| D | altr,freeze-bridge-controller.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/fpga/altr,freeze-bridge-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Altera Freeze Bridge Controller
10 The Altera Freeze Bridge Controller manages one or more freeze bridges.
11 The controller can freeze/disable the bridges which prevents signal
12 changes from passing through the bridge. The controller can also
13 unfreeze/enable the bridges which allows traffic to pass through the bridge
17 - Xu Yilun <yilun.xu@intel.com>
[all …]
|
| D | fpga-region.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/fpga/fpga-region.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Michal Simek <michal.simek@amd.com>
14 - Introduction
15 - Terminology
16 - Sequence
17 - FPGA Region
18 - Supported Use Models
[all …]
|
| /Documentation/i2c/busses/ |
| D | i2c-sis630.rst | 2 Kernel driver i2c-sis630
7 630 chipset (Datasheet: available at http://www.sfr-fresh.com/linux)
13 - Alexander Malysh <amalysh@web.de>
14 - Amaury Decrême <amaury.decreme@gmail.com> - SiS964 support
17 -----------------
27 faster, but freeze some systems (i.e. my Laptop).
33 -----------
40 00:00.0 Host bridge: Silicon Integrated Systems [SiS] 630 Host (rev 31)
41 00:01.0 ISA bridge: Silicon Integrated Systems [SiS] 85C503/5513
45 00:00.0 Host bridge: Silicon Integrated Systems [SiS] 730 Host (rev 02)
[all …]
|
| /Documentation/arch/powerpc/ |
| D | pci_iov_resource_on_powernv.rst | 25 to freeze a device that is causing errors in order to limit the possibility
34 captures things like the details of the error that caused the freeze etc., but
41 (IODA2). Keep in mind that this is all per PHB (PCI host bridge). Each PHB
57 - For DMA we then provide an entire address space for each PE that can
63 - For MSIs, we have two windows in the address space (one at the top of
64 the 32-bit space and one much higher) which, via a combination of the
66 bridge being triggered. There's a PE# in the interrupt controller
70 - Error messages just use the RTT.
81 - The M32 window:
87 32-bit PCIe accesses. We configure that window at boot from FW and
[all …]
|
| /Documentation/power/ |
| D | pci.rst | 13 power management refer to Documentation/driver-api/pm/devices.rst and
27 1.1. Native and Platform-Based Power Management
28 -----------------------------------------------
31 devices into states in which they draw less power (low-power states) at the
34 Usually, a device is put into a low-power state when it is underutilized or
36 again, it has to be put back into the "fully functional" state (full-power
41 PCI devices may be put into low-power states in two ways, by using the device
53 to put the device that sent it into the full-power state. However, the PCI Bus
68 Thus in many situations both the native and the platform-based power management
72 --------------------------------
[all …]
|
| /Documentation/driver-api/ |
| D | libata.rst | 12 transports for ATA and ATAPI devices, and SCSI<->ATA translation for ATA
16 internals, and a couple sample ATA low-level drivers.
22 is defined for every low-level libata
23 hardware driver, and it controls how the low-level driver interfaces
26 FIS-based drivers will hook into the system with ``->qc_prep()`` and
27 ``->qc_issue()`` high-level hooks. Hardware which behaves in a manner
33 ----------------------------------------------------------
35 Post-IDENTIFY device configuration
44 Typically used to apply device-specific fixups prior to issue of SET
45 FEATURES - XFER MODE, and prior to operation.
[all …]
|
| /Documentation/admin-guide/ |
| D | kernel-parameters.txt | 16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]
|
| /Documentation/sound/ |
| D | alsa-configuration.rst | 2 Advanced Linux Sound Architecture - Driver Configuration guide
38 ----------
47 limiting card index for auto-loading (1-8);
49 For auto-loading more than one card, specify this option
50 together with snd-card-X aliases.
63 Module snd-pcm-oss
64 ------------------
86 regarding opening the device. When this option is non-zero,
90 Module snd-rawmidi
91 ------------------
[all …]
|
| /Documentation/admin-guide/media/ |
| D | bttv.rst | 1 .. SPDX-License-Identifier: GPL-2.0
8 ----------------------
12 ./scripts/config -e PCI
13 ./scripts/config -m I2C
14 ./scripts/config -m INPUT
15 ./scripts/config -m MEDIA_SUPPORT
16 ./scripts/config -e MEDIA_PCI_SUPPORT
17 ./scripts/config -e MEDIA_ANALOG_TV_SUPPORT
18 ./scripts/config -e MEDIA_DIGITAL_TV_SUPPORT
19 ./scripts/config -e MEDIA_RADIO_SUPPORT
[all …]
|