Home
last modified time | relevance | path

Searched +full:gpio +full:- +full:latch (Results 1 – 11 of 11) sorted by relevance

/Documentation/devicetree/bindings/gpio/
Dsprd,gpio-eic.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
5 $id: http://devicetree.org/schemas/gpio/sprd,gpio-eic.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Orson Zhai <orsonzhai@gmail.com>
12 - Baolin Wang <baolin.wang7@gmail.com>
13 - Chunyan Zhang <zhang.lyra@gmail.com>
19 controller contains 4 sub-modules, i.e. EIC-debounce, EIC-latch, EIC-async and
20 EIC-sync. But the PMIC EIC controller contains only one EIC-debounce sub-
23 The EIC-debounce sub-module provides up to 8 source input signal
[all …]
Dgpio-latch.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/gpio/gpio-latch.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: GPIO latch controller
10 - Sascha Hauer <s.hauer@pengutronix.de>
13 This binding describes a GPIO multiplexer based on latches connected to
16 CLK0 ----------------------. ,--------.
17 CLK1 -------------------. `--------|> #0 |
19 OUT0 ----------------+--|-----------|D0 Q0|-----|<
[all …]
/Documentation/devicetree/bindings/clock/
Darmada3700-xtal-clock.txt4 reading the gpio latch register.
7 of the GPIO block where the gpio latch is located.
8 See Documentation/devicetree/bindings/pinctrl/marvell,armada-37xx-pinctrl.txt
11 - compatible : shall be one of the following:
12 "marvell,armada-3700-xtal-clock"
13 - #clock-cells : from common clock binding; shall be set to 0
16 - clock-output-names : from common clock binding; allows overwrite default clock
20 pinctrl_nb: pinctrl-nb@13800 {
21 compatible = "armada3710-nb-pinctrl", "syscon", "simple-mfd";
24 xtalclk: xtal-clk {
[all …]
/Documentation/devicetree/bindings/mtd/
Dfsl-upm-nand.txt4 - compatible : "fsl,upm-nand".
5 - reg : should specify localbus chip select and size used for the chip.
6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
10 - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
13 (R/B#). For multi-chip devices, "n" GPIO definitions are required
17 - fsl,upm-wait-flags : add chip-dependent short delays after running the
20 - chip-delay : chip dependent delay for transferring data from array to
24 Each flash chip described may optionally contain additional sub-nodes
[all …]
Datmel-nand.txt4 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt).
11 - compatible: should be one of the following
12 "atmel,at91rm9200-nand-controller"
13 "atmel,at91sam9260-nand-controller"
14 "atmel,at91sam9261-nand-controller"
15 "atmel,at91sam9g45-nand-controller"
16 "atmel,sama5d3-nand-controller"
17 "microchip,sam9x60-nand-controller"
18 - ranges: empty ranges property to forward EBI ranges definitions.
19 - #address-cells: should be set to 2.
[all …]
/Documentation/devicetree/bindings/iio/adc/
Dmaxim,max34408.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Ivan Mikhaylov <fr0st61te@gmail.com>
13 The MAX34408/MAX34409 are two- and four-channel current monitors that are
15 unidirectional current sensor offers precision high-side operation with a
16 low full-scale sense voltage. The devices automatically sequence through
17 two or four channels and collect the current-sense samples and average them
19 user-programmable digital thresholds to indicate overcurrent conditions.
24 https://www.analog.com/media/en/technical-documentation/data-sheets/MAX34408-MAX34409.pdf
[all …]
/Documentation/devicetree/bindings/pinctrl/
Dmarvell,armada-37xx-pinctrl.txt1 * Marvell Armada 37xx SoC pin and gpio controller
3 Each Armada 37xx SoC come with two pin and gpio controller one for the
6 Inside this set of register the gpio latch allows exposing some
11 GPIO and pin controller:
12 ------------------------
16 Refer to pinctrl-bindings.txt in this directory for details of the
22 - compatible: "marvell,armada3710-sb-pinctrl", "syscon, "simple-mfd"
24 "marvell,armada3710-nb-pinctrl", "syscon, "simple-mfd"
26 - reg: The first set of register are for pinctrl/gpio and the second
28 - interrupts: list of the interrupt use by the gpio
[all …]
/Documentation/devicetree/bindings/iio/dac/
Dmicrochip,mcp4821.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
13 +---------+--------------+-------------+
15 |---------|--------------|-------------|
16 | MCP4801 | 8-bit | 1 |
17 | MCP4802 | 8-bit | 2 |
18 | MCP4811 | 10-bit | 1 |
19 | MCP4812 | 10-bit | 2 |
20 | MCP4821 | 12-bit | 1 |
[all …]
/Documentation/devicetree/bindings/mmc/
Dmtk-sd.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mmc/mtk-sd.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Chaotian Jing <chaotian.jing@mediatek.com>
11 - Wenbin Mei <wenbin.mei@mediatek.com>
16 - enum:
17 - mediatek,mt2701-mmc
18 - mediatek,mt2712-mmc
19 - mediatek,mt6779-mmc
[all …]
/Documentation/driver-api/
Dmtdnand.rst10 The generic NAND driver supports almost all NAND and AG-AND based chips
31 --------------------------
37 - [MTD Interface]
43 - [NAND Interface]
48 - [GENERIC]
53 - [DEFAULT]
65 -------------------------------
71 - [INTERN]
77 - [REPLACEABLE]
86 - [BOARDSPECIFIC]
[all …]
/Documentation/scsi/
Dncr53c8xx.rst1 .. SPDX-License-Identifier: GPL-2.0
11 95170 DEUIL LA BARRE - FRANCE
64 10.4 PCI configuration fix-up boot option
81 16.1 Synchronous timings for 53C875 and 53C860 Ultra-SCSI controllers
82 16.2 Synchronous timings for fast SCSI-2 53C8XX controllers
97 - Gerard Roudier <groudier@free.fr>
101 - Wolfgang Stanglmeier <wolf@cologne.de>
102 - Stefan Esser <se@mi.Uni-Koeln.de>
106 - ncr53c8xx generic driver that supports all the SYM53C8XX family including
109 - sym53c8xx enhanced driver (a.k.a. 896 drivers) that drops support of oldest
[all …]