| /kernel/linux/linux-5.10/drivers/clk/ti/ |
| D | clkt_dpll.c | 228 * DPLLs can be locked or bypassed - basically, enabled or disabled.
230 * bypassed, on OMAP2xxx, the output rate is either the 32KiHz clock
232 * 2 are bypassed with dpll1_fclk and dpll2_fclk respectively
235 * locked, or the appropriate bypass rate if the DPLL is bypassed, or 0
248 /* Return bypass rate if DPLL is bypassed */ in omap2_get_dpll_rate()
|
| /kernel/linux/linux-4.19/drivers/clk/ti/ |
| D | clkt_dpll.c | 231 * DPLLs can be locked or bypassed - basically, enabled or disabled.
233 * bypassed, on OMAP2xxx, the output rate is either the 32KiHz clock
235 * 2 are bypassed with dpll1_fclk and dpll2_fclk respectively
238 * locked, or the appropriate bypass rate if the DPLL is bypassed, or 0
251 /* Return bypass rate if DPLL is bypassed */ in omap2_get_dpll_rate()
|
| /kernel/linux/linux-4.19/Documentation/netlabel/ |
| D | lsm_interface.txt | 46 NetLabel translation mechanisms bypassed but the LSM translation mechanisms are
47 bypassed as well which should result in a significant reduction in overhead.
|
| /kernel/linux/linux-4.19/drivers/regulator/ |
| D | qcom-rpmh-regulator.c | 99 * @bypassed: Boolean indicating if the regulator is in
114 bool bypassed; member
249 unsigned int mode, bool bypassed) in rpmh_regulator_vrm_set_mode_bypass() argument
263 if (bypassed) in rpmh_regulator_vrm_set_mode_bypass()
280 ret = rpmh_regulator_vrm_set_mode_bypass(vreg, mode, vreg->bypassed); in rpmh_regulator_vrm_set_mode()
324 if (vreg->bypassed == enable) in rpmh_regulator_vrm_set_bypass()
329 vreg->bypassed = enable; in rpmh_regulator_vrm_set_bypass()
339 *enable = vreg->bypassed; in rpmh_regulator_vrm_get_bypass()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/hwmon/ |
| D | adt7475.yaml | 46 set to 1 the attenuator is bypassed if set to 0 the attenuator is
47 not bypassed. If the property is absent then the attenuator
|
| /kernel/linux/linux-5.10/Documentation/netlabel/ |
| D | lsm_interface.rst | 52 NetLabel translation mechanisms bypassed but the LSM translation mechanisms are
53 bypassed as well which should result in a significant reduction in overhead.
|
| /kernel/linux/linux-4.19/Documentation/devicetree/bindings/devfreq/ |
| D | rk3399_dmc.txt | 62 DDR3 DLL will be bypassed. Note: if DLL was bypassed,
67 DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/devfreq/ |
| D | rk3399_dmc.txt | 64 DDR3 DLL will be bypassed. Note: if DLL was bypassed,
69 DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed.
|
| /kernel/linux/linux-4.19/drivers/md/ |
| D | dm-mpath.c | 62 bool bypassed:1; /* Temporarily bypass this PG? */ member
380 unsigned bypassed = 1; in choose_pgpath() local
413 * First time we skip PGs marked 'bypassed'. in choose_pgpath()
419 if (pg->bypassed == !!bypassed) in choose_pgpath()
423 if (!bypassed) in choose_pgpath()
428 } while (bypassed--); in choose_pgpath()
1332 bool bypassed) in bypass_pg() argument
1338 pg->bypassed = bypassed; in bypass_pg()
1365 pg->bypassed = false; in switch_pg_num()
1380 * Set/clear bypassed status of a PG.
[all …]
|
| /kernel/linux/linux-5.10/drivers/md/ |
| D | dm-mpath.c | 66 bool bypassed:1; /* Temporarily bypass this PG? */ member
398 unsigned bypassed = 1; in choose_pgpath() local
433 * First time we skip PGs marked 'bypassed'. in choose_pgpath()
439 if (pg->bypassed == !!bypassed) in choose_pgpath()
443 if (!bypassed) { in choose_pgpath()
451 } while (bypassed--); in choose_pgpath()
1436 bool bypassed) in bypass_pg() argument
1442 pg->bypassed = bypassed; in bypass_pg()
1469 pg->bypassed = false; in switch_pg_num()
1484 * Set/clear bypassed status of a PG.
[all …]
|
| /kernel/linux/linux-5.10/drivers/regulator/ |
| D | qcom-rpmh-regulator.c | 113 * @bypassed: Boolean indicating if the regulator is in
128 bool bypassed; member
263 unsigned int mode, bool bypassed) in rpmh_regulator_vrm_set_mode_bypass() argument
277 if (bypassed) in rpmh_regulator_vrm_set_mode_bypass()
294 ret = rpmh_regulator_vrm_set_mode_bypass(vreg, mode, vreg->bypassed); in rpmh_regulator_vrm_set_mode()
338 if (vreg->bypassed == enable) in rpmh_regulator_vrm_set_bypass()
343 vreg->bypassed = enable; in rpmh_regulator_vrm_set_bypass()
353 *enable = vreg->bypassed; in rpmh_regulator_vrm_get_bypass()
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-block-bcache | 51 What: /sys/block/<disk>/bcache/bypassed
55 Sum of all reads and writes that have bypassed the cache (due
|
| /kernel/linux/linux-4.19/Documentation/ABI/testing/ |
| D | sysfs-block-bcache | 51 What: /sys/block/<disk>/bcache/bypassed
55 Sum of all reads and writes that have bypassed the cache (due
|
| /kernel/linux/linux-5.10/arch/sh/include/asm/ |
| D | segment.h | 16 * get_fs() == KERNEL_DS, checking is bypassed.
|
| /kernel/linux/linux-4.19/arch/sh/include/asm/ |
| D | segment.h | 16 * get_fs() == KERNEL_DS, checking is bypassed.
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/nouveau/include/nvkm/core/ |
| D | tegra.h | 39 * bypassed). A value of 0 means an IOMMU is never used.
|
| /kernel/linux/linux-4.19/drivers/gpu/drm/nouveau/include/nvkm/core/ |
| D | tegra.h | 39 * bypassed). A value of 0 means an IOMMU is never used.
|
| /kernel/linux/linux-4.19/tools/perf/pmu-events/arch/x86/skylakex/ |
| D | uncore-other.json | 766 …": "Counts reads in which direct to core transactions (which would have bypassed the CHA) were ove…
775 …t to Intel Ultra Path Interconnect (UPI) transactions (which would have bypassed the CHA) were ove…
1039 "BriefDescription": "FLITs received which bypassed the Slot0 Receive Buffer",
1044 …"PublicDescription": "Counts incoming FLITs (FLow control unITs) which bypassed the slot0 RxQ buff…
1049 "BriefDescription": "FLITs received which bypassed the Slot0 Receive Buffer",
1054 …"PublicDescription": "Counts incoming FLITs (FLow control unITs) which bypassed the slot1 RxQ buff…
1059 "BriefDescription": "FLITs received which bypassed the Slot0 Recieve Buffer",
1064 …"PublicDescription": "Counts incoming FLITs (FLow control unITs) whcih bypassed the slot2 RxQ buff…
1108 "BriefDescription": "FLITs that bypassed the TxL Buffer",
1113 …"PublicDescription": "Counts incoming FLITs (FLow control unITs) which bypassed the TxL(transmit) …
|
| /kernel/linux/linux-4.19/drivers/md/bcache/ |
| D | stats.c | 51 read_attribute(bypassed);
69 sysfs_hprint(bypassed, var(sectors_bypassed) << 9); in SHOW()
|
| /kernel/linux/linux-5.10/drivers/md/bcache/ |
| D | stats.c | 51 read_attribute(bypassed);
69 sysfs_hprint(bypassed, var(sectors_bypassed) << 9); in SHOW()
|
| /kernel/linux/linux-4.19/Documentation/xtensa/ |
| D | atomctl.txt | 31 with the cache being bypassed; for example studying cache alias problems.
|
| /kernel/linux/linux-4.19/Documentation/filesystems/ |
| D | fuse-io.txt | 11 In direct-io mode the page cache is completely bypassed for reads and writes.
|
| /kernel/linux/linux-5.10/Documentation/filesystems/ |
| D | fuse-io.rst | 17 In direct-io mode the page cache is completely bypassed for reads and writes.
|
| /kernel/linux/linux-5.10/Documentation/xtensa/ |
| D | atomctl.rst | 35 with the cache being bypassed; for example studying cache alias problems.
|
| /kernel/linux/linux-4.19/Documentation/thermal/ |
| D | nouveau_thermal | 57 * pwm1_max: The maximum PWM speed allowed (bypassed when hitting Fan_boost);
|