1 /****************************************************************************** 2 * 3 * Copyright 2009-2012 Broadcom Corporation 4 * 5 * Licensed under the Apache License, Version 2.0 (the "License"); 6 * you may not use this file except in compliance with the License. 7 * You may obtain a copy of the License at: 8 * 9 * http://www.apache.org/licenses/LICENSE-2.0 10 * 11 * Unless required by applicable law or agreed to in writing, software 12 * distributed under the License is distributed on an "AS IS" BASIS, 13 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. 14 * See the License for the specific language governing permissions and 15 * limitations under the License. 16 * 17 ******************************************************************************/ 18 19 // This module manages the serial port over which HCI commands 20 // and data are sent/received. 21 22 #ifndef BT_VENDOR_USERIAL_H 23 #define BT_VENDOR_USERIAL_H 24 25 #include <stdbool.h> 26 #include <stdint.h> 27 28 typedef enum { 29 USERIAL_PORT_1, 30 USERIAL_PORT_2, 31 USERIAL_PORT_3, 32 USERIAL_PORT_4, 33 USERIAL_PORT_5, 34 USERIAL_PORT_6, 35 USERIAL_PORT_7, 36 USERIAL_PORT_8, 37 USERIAL_PORT_9, 38 USERIAL_PORT_10, 39 USERIAL_PORT_11, 40 USERIAL_PORT_12, 41 USERIAL_PORT_13, 42 USERIAL_PORT_14, 43 USERIAL_PORT_15, 44 USERIAL_PORT_16, 45 USERIAL_PORT_17, 46 USERIAL_PORT_18, 47 } userial_port_t; 48 49 // Initializes the userial module. This function should only be called once. 50 // It returns true if the module was initialized, false if there was an error. 51 bool userial_init(void); 52 53 // Opens the given serial port. Returns true if successful, false otherwise. 54 // Once this function is called, the userial module will begin producing 55 // buffers from data read off the serial port. If you wish to pause the 56 // production of buffers, call |userial_pause_reading|. You can then resume 57 // by calling |userial_resume_reading|. This function returns true if the 58 // serial port was successfully opened and buffer production has started. It 59 // returns false if there was an error. 60 bool userial_open(userial_port_t port); 61 void userial_close(void); 62 void userial_close_reader(void); 63 64 // Reads a maximum of |len| bytes from the serial port into |p_buffer|. 65 // This function returns the number of bytes actually read, which may be 66 // less than |len|. This function will not block. 67 uint16_t userial_read(uint16_t msg_id, uint8_t *p_buffer, uint16_t len); 68 69 // Writes a maximum of |len| bytes from |p_data| to the serial port. 70 // This function returns the number of bytes actually written, which may be 71 // less than |len|. This function may block. 72 uint16_t userial_write(uint16_t msg_id, const uint8_t *p_data, uint16_t len); 73 #endif