Searched refs:char_num (Results 1 – 6 of 6) sorted by relevance
| /device/soc/esp/esp32/components/hal/include/hal/ |
| D | uart_hal.h | 97 …ine uart_hal_get_at_cmd_char(hal, cmd_char, char_num) uart_ll_get_at_cmd_char((hal)->dev, cmd_cha… argument
|
| D | uart_types.h | 120 uint8_t char_num; /*!< AT cmd char repeat number*/ member
|
| /device/soc/esp/esp32/components/hal/esp32/include/hal/ |
| D | uart_ll.h | 547 hw->at_cmd_char.char_num = cmd_char->char_num; in uart_ll_set_at_cmd_char()
730 FORCE_INLINE_ATTR void uart_ll_get_at_cmd_char(uart_dev_t *hw, uint8_t *cmd_char, uint8_t *char_num) in uart_ll_get_at_cmd_char() argument
733 *char_num = hw->at_cmd_char.char_num; in uart_ll_get_at_cmd_char()
|
| /device/soc/esp/esp32/components/bt/host/bluedroid/btc/profile/std/gatt/ |
| D | btc_gattc.c | 361 uint16_t char_num = 0; in btc_ble_gattc_get_all_char() local
362 BTA_GATTC_GetAllChar(conn_id, start_handle, end_handle, &db, &char_num); in btc_ble_gattc_get_all_char()
364 if ((status = btc_gattc_check_valid_param((int)char_num, offset)) != ESP_GATT_OK) { in btc_ble_gattc_get_all_char()
371 …btc_gattc_fill_gatt_db_conversion(*count, char_num, ESP_GATT_DB_CHARACTERISTIC, offset, (void *)re… in btc_ble_gattc_get_all_char()
374 *count = char_num; in btc_ble_gattc_get_all_char()
419 uint16_t char_num = 0; in btc_ble_gattc_get_char_by_uuid() local
422 BTA_GATTC_GetCharByUUID(conn_id, start_handle, end_handle, bta_uuid, &db, &char_num); in btc_ble_gattc_get_char_by_uuid()
424 if ((status = btc_gattc_check_valid_param((int)char_num, 0)) != ESP_GATT_OK) { in btc_ble_gattc_get_char_by_uuid()
431 …btc_gattc_fill_gatt_db_conversion(*count, char_num, ESP_GATT_DB_CHARACTERISTIC, 0, (void *)result,… in btc_ble_gattc_get_char_by_uuid()
434 *count = char_num; in btc_ble_gattc_get_char_by_uuid()
|
| /device/soc/esp/esp32/components/soc/esp32/include/soc/ |
| D | uart_struct.h | 305 …uint32_t char_num: 8; /*This register is used to configure the number of continu… member
|
| /device/soc/esp/esp32/components/driver/ |
| D | uart.c | 497 at_cmd.char_num = chr_num; in uart_enable_pattern_det_intr()
518 at_cmd.char_num = chr_num; in uart_enable_pattern_det_baud_intr()
|