/kernel/linux/linux-5.10/drivers/mtd/nand/raw/ |
D | au1550nd.c | 177 if ((this->options & NAND_BUSWIDTH_16) && in au1550nd_exec_instr() 187 if ((this->options & NAND_BUSWIDTH_16) && in au1550nd_exec_instr() 309 this->options |= NAND_BUSWIDTH_16; in au1550nd_probe()
|
D | nand_ids.c | 11 #define LP_OPTIONS16 (LP_OPTIONS | NAND_BUSWIDTH_16) 14 #define SP_OPTIONS16 (SP_OPTIONS | NAND_BUSWIDTH_16)
|
D | gpio.c | 103 if ((chip->options & NAND_BUSWIDTH_16) && in gpio_nand_exec_instr() 114 if ((chip->options & NAND_BUSWIDTH_16) && in gpio_nand_exec_instr() 195 plat->options |= NAND_BUSWIDTH_16; in gpio_nand_get_config_of()
|
D | orion_nand.c | 46 if (nc->options & NAND_BUSWIDTH_16) in orion_nand_cmd_ctrl() 169 nc->options |= NAND_BUSWIDTH_16; in orion_nand_probe()
|
D | nand_legacy.c | 281 if (chip->options & NAND_BUSWIDTH_16 && in nand_command() 410 if (chip->options & NAND_BUSWIDTH_16 && in nand_command_lp() 582 unsigned int busw = chip->options & NAND_BUSWIDTH_16; in nand_legacy_set_defaults()
|
D | omap2.c | 351 if (info->nand.options & NAND_BUSWIDTH_16) in omap_read_buf_pref() 364 if (info->nand.options & NAND_BUSWIDTH_16) in omap_read_buf_pref() 411 if (info->nand.options & NAND_BUSWIDTH_16) in omap_write_buf_pref() 519 if (info->nand.options & NAND_BUSWIDTH_16) in omap_nand_dma_transfer() 652 if (info->nand.options & NAND_BUSWIDTH_16) in omap_read_buf_irq_pref() 711 if (info->nand.options & NAND_BUSWIDTH_16) in omap_write_buf_irq_pref() 948 unsigned int dev_width = (chip->options & NAND_BUSWIDTH_16) ? 1 : 0; in omap_enable_hwecc() 1109 dev_width = (chip->options & NAND_BUSWIDTH_16) ? 1 : 0; in omap_enable_hwecc_bch() 1824 !(chip->options & NAND_BUSWIDTH_16)) in omap_ooblayout_ecc() 1844 !(chip->options & NAND_BUSWIDTH_16)) in omap_ooblayout_free() [all …]
|
D | sh_flctl.c | 232 if (flctl->chip.options & NAND_BUSWIDTH_16) in set_addr() 565 if (flctl->chip.options & NAND_BUSWIDTH_16) in set_cmd_regs() 575 if (flctl->chip.options & NAND_BUSWIDTH_16) in set_cmd_regs() 770 if (flctl->chip.options & NAND_BUSWIDTH_16) in flctl_cmdfunc() 812 if (flctl->chip.options & NAND_BUSWIDTH_16) in flctl_cmdfunc() 997 if (chip->options & NAND_BUSWIDTH_16) in flctl_chip_attach_chip() 1178 nand->options |= NAND_BUSWIDTH_16; in flctl_probe()
|
D | stm32_fmc2_nand.c | 324 if (chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_setup() 812 if (chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_rw_page_init() 1178 if (force_8bit && chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_read_data() 1214 if (force_8bit && chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_read_data() 1225 if (force_8bit && chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_write_data() 1261 if (force_8bit && chip->options & NAND_BUSWIDTH_16) in stm32_fmc2_nfc_write_data() 1632 chip->ecc.bytes = chip->options & NAND_BUSWIDTH_16 ? 4 : 3; in stm32_fmc2_nfc_nand_callbacks_setup() 1634 chip->ecc.bytes = chip->options & NAND_BUSWIDTH_16 ? 14 : 13; in stm32_fmc2_nfc_nand_callbacks_setup() 1636 chip->ecc.bytes = chip->options & NAND_BUSWIDTH_16 ? 8 : 7; in stm32_fmc2_nfc_nand_callbacks_setup()
|
D | nand_jedec.c | 118 chip->options |= NAND_BUSWIDTH_16; in nand_jedec_detect()
|
D | fsl_ifc_nand.c | 107 !(chip->options & NAND_BUSWIDTH_16)) { in fsl_ifc_ooblayout_free() 478 if (chip->options & NAND_BUSWIDTH_16) in fsl_ifc_cmdfunc() 896 chip->options |= NAND_BUSWIDTH_16; in fsl_ifc_chip_init() 911 if (!(chip->options & NAND_BUSWIDTH_16)) { in fsl_ifc_chip_init()
|
D | vf610_nfc.c | 438 if (force8bit && (chip->options & NAND_BUSWIDTH_16)) in vf610_nfc_cmd() 455 if (force8bit && (chip->options & NAND_BUSWIDTH_16)) in vf610_nfc_cmd() 725 if (nfc->chip.options & NAND_BUSWIDTH_16) in vf610_nfc_init_controller()
|
D | nand_base.c | 466 if (chip->options & NAND_BUSWIDTH_16) { in nand_default_block_markbad() 984 if (chip->options & NAND_BUSWIDTH_16) { in nand_fill_column_cycles() 1030 !(chip->options & NAND_BUSWIDTH_16)) in nand_sp_exec_read_page_op() 1328 !(chip->options & NAND_BUSWIDTH_16)) in nand_exec_prog_page_op() 2784 int busw = (chip->options & NAND_BUSWIDTH_16) ? 2 : 1; in nand_read_subpage() 4538 chip->options |= NAND_BUSWIDTH_16; in nand_decode_ext_id() 4575 if (mtd->writesize > 512 || (chip->options & NAND_BUSWIDTH_16)) in nand_decode_bbm_options() 4760 busw = chip->options & NAND_BUSWIDTH_16; in nand_detect() 4766 chip->options &= ~NAND_BUSWIDTH_16; in nand_detect() 4818 WARN_ON(busw & NAND_BUSWIDTH_16); in nand_detect() [all …]
|
D | mpc5121_nfc.c | 384 if (chip->options & NAND_BUSWIDTH_16) in mpc5121_nfc_command() 579 chip->options |= NAND_BUSWIDTH_16; in mpc5121_nfc_read_hw_config()
|
D | fsmc_nand.c | 275 if (host->nand.options & NAND_BUSWIDTH_16) in fsmc_nand_setup() 736 if (chip->options & NAND_BUSWIDTH_16) in fsmc_read_page_hwecc() 865 nand->options |= NAND_BUSWIDTH_16; in fsmc_nand_probe_config_dt()
|
D | nand_onfi.c | 270 chip->options |= NAND_BUSWIDTH_16; in nand_onfi_detect()
|
D | hisi504_nand.c | 402 if (chip->options & NAND_BUSWIDTH_16 && in set_addr() 599 | ((chip->options & NAND_BUSWIDTH_16) ? in hisi_nfc_host_init()
|
D | denali.c | 202 iowrite32(chip->options & NAND_BUSWIDTH_16 ? 1 : 0, in denali_select_target() 1129 chip->options & NAND_BUSWIDTH_16); in denali_exec_instr() 1136 chip->options & NAND_BUSWIDTH_16); in denali_exec_instr()
|
D | txx9ndfmc.c | 359 chip->options |= NAND_BUSWIDTH_16; in txx9ndfmc_probe()
|
D | mxc_nand.c | 907 if (nand_chip->options & NAND_BUSWIDTH_16) { in mxc_nand_read_byte() 1326 if (!(chip->options & NAND_BUSWIDTH_16)) in preset_v3() 1848 this->options |= NAND_BUSWIDTH_16; in mxcnd_probe()
|
D | qcom_nandc.c | 666 if (chip->options & NAND_BUSWIDTH_16) in set_address() 2224 if (chip->options & NAND_BUSWIDTH_16) in qcom_nandc_block_bad() 2477 wide_bus = chip->options & NAND_BUSWIDTH_16 ? true : false; in qcom_nand_attach_chip()
|
/kernel/linux/linux-5.10/drivers/mtd/nand/raw/ingenic/ |
D | ingenic_nand_drv.c | 274 !(chip->options & NAND_BUSWIDTH_16)) in ingenic_nand_exec_instr() 285 !(chip->options & NAND_BUSWIDTH_16)) in ingenic_nand_exec_instr()
|
/kernel/linux/linux-5.10/arch/arm/mach-davinci/ |
D | board-omapl138-hawk.c | 212 .options = NAND_BUSWIDTH_16,
|
D | board-mityomapl138.c | 437 .options = NAND_BUSWIDTH_16,
|
/kernel/linux/linux-5.10/drivers/mtd/nand/raw/atmel/ |
D | nand-controller.c | 489 if ((nand->base.options & NAND_BUSWIDTH_16) && !force_8bit) in atmel_nand_data_in() 513 if ((nand->base.options & NAND_BUSWIDTH_16) && !force_8bit) in atmel_nand_data_out() 1459 if (nand->base.options & NAND_BUSWIDTH_16) in atmel_smc_nand_prepare_smcconf()
|
/kernel/linux/linux-5.10/include/linux/mtd/ |
D | rawnand.h | 108 #define NAND_BUSWIDTH_16 BIT(1) macro
|