1 /* 2 * Copyright (c) 2020 HiSilicon (Shanghai) Technologies CO., LIMITED. 3 * Licensed under the Apache License, Version 2.0 (the "License"); 4 * you may not use this file except in compliance with the License. 5 * You may obtain a copy of the License at 6 * 7 * http://www.apache.org/licenses/LICENSE-2.0 8 * 9 * Unless required by applicable law or agreed to in writing, software 10 * distributed under the License is distributed on an "AS IS" BASIS, 11 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. 12 * See the License for the specific language governing permissions and 13 * limitations under the License. 14 * Description: wifi_p2p_config.h 的头文件 15 */ 16 17 18 #ifndef SERVICE_WIFI_P2P_CONFIG_C_H 19 #define SERVICE_WIFI_P2P_CONFIG_C_H 20 21 #include "wifi_device_config.h" 22 23 #ifdef __cplusplus 24 #if __cplusplus 25 extern "C" { 26 #endif 27 #endif 28 29 /** 30 * @defgroup middleware_service_wifi_p2p_config WiFi P2P Config 31 * @ingroup middleware_service_wifi 32 * @{ 33 */ 34 35 /** 36 * @if Eng 37 * @brief Maximum length of the WPS device name. 38 * @else 39 * @brief device名称最大长度。 40 * @endif 41 */ 42 #define WPS_DEV_NAME_LEN 33 43 44 45 /** 46 * @if Eng 47 * @brief WPS connection mode. 48 * @else 49 * @brief wps连接方式。 50 * @endif 51 */ 52 typedef enum { 53 WPS_PBC, /*!< @if Eng PBC connection. 54 @else PBC方式连接。 @endif */ 55 WPS_PIN_DISPLAY, /*!< @if Eng Connected in PIN DISPLAY mode, which is not supported in 92. 56 @else PIN DISPLAY方式连接,92不支持。 @endif */ 57 WPS_PIN_KEYPAD, /*!< @if Eng Connected in PIN KEYPAD mode, which is not supported in 92. 58 @else PIN KEYPAD方式连接,92不支持。 @endif */ 59 WPS_PIN_LABEL, /*!< @if Eng Connected in PIN LABEL mode, which is not supported in 92. 60 @else PIN LABEL方式连接,92不支持。 @endif */ 61 WPS_OTHER, /*!< @if Eng Connected in other mode, which is not supported in 92. 62 @else 其他方式连接,92不支持。 @endif */ 63 } wps_method_enum; 64 65 66 /** 67 * @if Eng 68 * @brief P2P mode. 69 * @else 70 * @brief p2p模式。 71 * @endif 72 */ 73 typedef enum { 74 P2P_MODE_GC, /*!< @if Eng P2P GC mode. 75 @else P2P GC模式。 @endif */ 76 P2P_MODE_GO, /*!< @if Eng P2P GO mode. 77 @else P2P GO模式。 @endif */ 78 P2P_MODE_DEVICE_ONLY, /*!< @if Eng P2P not negotiated GO. 79 @else P2P未协商GO。 @endif */ 80 P2P_MODE_BUTT, 81 } p2p_mode_enum; 82 83 84 /** 85 * @if Eng 86 * @brief P2P association status. 87 * @else 88 * @brief p2p关联状态。 89 * @endif 90 */ 91 typedef enum { 92 P2P_DISCONNECTED, /*!< @if Eng Disconnected. 93 @else 断连。 @endif */ 94 P2P_CONNECTED, /*!< @if Eng Connected. 95 @else 已连接。 @endif */ 96 P2P_CONNECTING, /*!< @if Eng Connecting. 97 @else 连接中。 @endif */ 98 P2P_CONN_STATUS_BUTT, 99 } p2p_conn_state_enum; 100 101 102 /** 103 * @if Eng 104 * @brief WFD-related information structure. 105 * @else 106 * @brief WFD相关信息结构体。 107 * @endif 108 */ 109 typedef struct wfd_info_stru { 110 int16_t device_info; /*!< @if Eng WFD Device Type. 111 @else WFD设备类型。 @endif */ 112 int16_t ctrl_port; /*!< @if Eng Control port number. 113 @else 控制端口号。 @endif */ 114 int16_t max_throughput; /*!< @if Eng Maximum throughput. 115 @else 最大吞吐量。 @endif */ 116 int8_t reserved[2]; 117 } wfd_info_stru; 118 119 120 /** 121 * @if Eng 122 * @brief P2P scanning result. 123 * @else 124 * @brief p2p扫描结果。 125 * @endif 126 */ 127 typedef struct p2p_device_stru { 128 int8_t name[WPS_DEV_NAME_LEN]; /*!< @if Eng Device name. 129 @else 设备device名称。 @endif */ 130 uint8_t bssid[WIFI_MAC_LEN]; /*!< @if Eng Device MAC address. 131 @else 设备device MAC地址。 @endif */ 132 uint8_t wps_method; /*!< @if Eng WPS connection mode supported. 133 - Bit 0 indicates the PBC, 134 - bit 1 indicates the PIN LABEL, 135 - bit 2 indicates the PIN DISPLAY, 136 - bit 3 indicates the PIN KEYPAD, 137 - bit 4 indicates other modes. 138 @else 支持的WPS连接方式， 139 - bit0表示PBC 140 - bit1表示PIN LABEL 141 - bit2表示PIN DISPLAY 142 - bit3表示PIN KEYPAD 143 - bit4表示其他方式。 @endif */ 144 uint8_t is_go : 1; /*!< @if Eng Check whether the scanned device is a P2P go device. 145 @else 扫描出来的设备是否是p2p go。 @endif */ 146 uint8_t enable_add_group : 1; /*!< @if Eng Indicates whether to allow GC to be added to the group corresponding 147 to the scanned go. 148 @else 扫描出的go对应的group，是否允许添加gc。 @endif */ 149 uint8_t reserved : 6; 150 int8_t reserved1[3]; 151 wfd_info_stru wfd_info; /*!< @if Eng Not used temporarily. 152 @else 暂不使用。 @endif */ 153 } p2p_device_stru; 154 155 156 /** 157 * @if Eng 158 * @brief P2P association configuration information. 159 * @else 160 * @brief p2p关联的配置信息。 161 * @endif 162 */ 163 typedef struct p2p_config_stru { 164 uint8_t bssid[WIFI_MAC_LEN]; /*!< @if Eng Device MAC address of the peer. 165 @else peer的device MAC地址。 @endif */ 166 int8_t pin[WIFI_WPS_PIN_MAX_LEN_NUM]; /*!< @if Eng Pin Code of WPS. 167 @else WPS的Pin码。 @endif */ 168 uint8_t wps_method; /*!< @if Eng Connection mode of WPS. 169 @else WPS的连接方式。 @endif */ 170 uint8_t go_intent; /*!< @if Eng Go intent, the value ranges from 0 to 15. 171 @else go intent，有效范围0~15。 @endif */ 172 uint8_t persistent; /*!< @if Eng 1: Persistent network storage; 173 0: not based on permanent network storage. 174 @else 1:按照永久网络存储;0:不按照永久网络存储。 @endif */ 175 int8_t reserved[2]; 176 } p2p_config_stru; 177 178 179 /** 180 * @if Eng 181 * @brief P2P association status information. 182 * @else 183 * @brief p2p设置信息。 184 * @endif 185 */ 186 typedef struct p2p_status_info_stru { 187 int32_t operation_channel; /*!< @if Eng Center frequency of the working channel after the GO/GC 188 connection. 189 This parameter is valid when wpa_state is set to CONNECTED. 190 @else GO/GC连接之后工作信道的中心频点，在wpa_state为CONNECTED时有效。 @endif */ 191 uint8_t mode; /*!< @if Eng P2P mode, which corresponds to P2pMode. 192 @else P2P模式, 和P2pMode对应。 @endif */ 193 uint8_t wpa_state; /*!< @if Eng P2P association status, which corresponds to P2pConnState. 194 @else p2p关联状态，和P2pConnState对应.。 @endif */ 195 int8_t group_ssid[WPS_DEV_NAME_LEN]; /*!< @if Eng Group SSID, valid only when wpa_state is set to CONNECTED 196 and P2P WPS succeeds. 197 @else Group SSID，并且P2P的WPS关联成功（当前阶段组协商成功）时有效。 @endif */ 198 uint8_t group_bssid[WIFI_MAC_LEN]; /*!< @if Eng Group BSSID==go bssid, valid only when wpa_state is set to 199 CONNECTED and P2P WPS succeeds. 200 @else Group BSSID==go bssid，在wpa_state为CONNECTED， 201 并且P2P的WPS关联成功（当前阶段组协商成功）时有效。 @endif */ 202 int8_t reserved[3]; 203 } p2p_status_info_stru; 204 205 206 /** 207 * @if Eng 208 * @brief P2P connected GC information. 209 * @else 210 * @brief p2p已连接的gc信息。 211 * @endif 212 */ 213 typedef struct p2p_client_info_stru { 214 uint8_t gc_bssid[WIFI_MAC_LEN]; /*!< @if Eng MAC address of the client connected to the GO. 215 @else 与go相连的client mac地址。 @endif */ 216 uint8_t gc_device_bssid[WIFI_MAC_LEN]; /*!< @if Eng Device address of the client connected to the GO. 217 @else 与go相连的client dev地址。 @endif */ 218 int8_t gc_device_name[WPS_DEV_NAME_LEN]; /*!< @if Eng Client device name. 219 @else client 设备名称。 @endif */ 220 int8_t reserved[3]; 221 } p2p_client_info_stru; 222 223 224 /** 225 * @if Eng 226 * @brief P2P device information. 227 * @else 228 * @brief p2p设备信息。 229 * @endif 230 */ 231 typedef struct { 232 int8_t dev_name[WPS_DEV_NAME_LEN]; /*!< @if Eng Device name. 233 @else 设备名称。 @endif */ 234 uint8_t wps_method; /*!< @if Eng WPS connection mode supported.The options are WpsMethod. 235 The options are 0, 1, 2, and 3. 236 @else 支持的WPS连接方式，可选项为WpsMethod,仅支持配置0/1/2/3。 @endif */ 237 int32_t listen_channel; /*!< @if Eng Channel for replying to the probe response. 238 @else 回复probe response的信道。 @endif */ 239 int32_t oper_channel; /*!< @if Eng Recommended working channel: 0 indicates a random channel. 240 A non-zero valid value indicates the recommended channel. 241 @else 建议的工作信道：0表示随机信道；非0有效值表示建议的信道。 @endif */ 242 } p2p_device_config_stru; 243 244 /** 245 * @} 246 */ 247 248 #ifdef __cplusplus 249 #if __cplusplus 250 } 251 #endif 252 #endif 253 254 #endif // SERVICE_WIFI_P2P_CONFIG_C_H 255