| /kernel/linux/linux-5.10/drivers/ata/ |
| D | pata_ixp4xx_cf.c | 103 ioaddr->cmd_addr = data->cs0; in ixp4xx_setup_port()
138 struct resource *cs0, *cs1; in ixp4xx_pata_probe() local
145 cs0 = platform_get_resource(pdev, IORESOURCE_MEM, 0); in ixp4xx_pata_probe()
148 if (!cs0 || !cs1) in ixp4xx_pata_probe()
161 data->cs0 = devm_ioremap(&pdev->dev, cs0->start, 0x1000); in ixp4xx_pata_probe()
164 if (!data->cs0 || !data->cs1) in ixp4xx_pata_probe()
185 ixp4xx_setup_port(ap, data, cs0->start, cs1->start); in ixp4xx_pata_probe()
|
| D | pata_octeon_cf.c | 55 unsigned int cs0; member
170 octeon_cf_set_boot_reg_cfg(cf_port->cs0, div); in octeon_cf_set_piomode()
178 reg_tim.u64 = cvmx_read_csr(CVMX_MIO_BOOT_REG_TIMX(cf_port->cs0)); in octeon_cf_set_piomode()
207 cvmx_write_csr(CVMX_MIO_BOOT_REG_TIMX(cf_port->cs0), reg_tim.u64); in octeon_cf_set_piomode()
843 void __iomem *cs0; in octeon_cf_probe() local
877 cf_port->cs0 = be32_to_cpup(cs_num); in octeon_cf_probe()
932 cs0 = devm_ioremap(&pdev->dev, res_cs0->start, in octeon_cf_probe()
934 if (!cs0) in octeon_cf_probe()
951 base = cs0 + 0x800; in octeon_cf_probe()
959 base = cs0; in octeon_cf_probe()
[all …]
|
| /kernel/linux/linux-6.6/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-sx9324 | 6 SX9324 has 3 inputs, CS0, CS1 and CS2. Hardware layout
18 By default, during the first phase, [PH0], CS0 is measured,
21 [PH1], CS1 is measured, CS0 and CS2 are shield:
23 [PH2], CS2 is measured, CS0 and CS1 are shield:
|
| D | sysfs-class-watchdog | 110 chip at CS0 after booting from the alternate
114 from (CS0->CS1, CS1->CS0) to (CS0->CS0,
119 the SoC is in normal mapping state (i.e. booted from CS0),
|
| /kernel/linux/linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-class-watchdog | 97 chip at CS0 after booting from the alternate
101 from (CS0->CS1, CS1->CS0) to (CS0->CS0,
106 the SoC is in normal mapping state (i.e. booted from CS0),
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/iio/proximity/ |
| D | semtech,sx9310.yaml | 46 semtech,cs0-ground:
47 description: Indicates the CS0 sensor is connected to ground.
56 0 1 - CS0 + CS1
58 0 1 2 3 - CS0 + CS1 + CS2 + CS3
124 semtech,cs0-ground;
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-370-pinctrl.txt | 29 mpp12 12 gpio, ge0(rxd1), i2c1(sda), sd0(d0), spi1(cs0),
45 mpp24 24 gpio, ge0(col), ge1(txctl), spi1(cs0)
53 mpp32 32 gpio, spi0(cs0)
54 mpp33 33 gpio, dev(bootcs), spi0(cs0)
71 mpp49 49 gpio, dev(ad10), pcie(clkreq1), sd0(d0), spi1(cs0),
86 mpp58 58 gpio, dev(cs0), uart1(rts), tdm(int), audio(extclk),
|
| D | marvell,armada-38x-pinctrl.txt | 36 mpp18 18 gpio, ge0(rxerr), ptp(trig), ua1(txd), spi0(cs0)
43 mpp25 25 gpio, spi0(cs0), ua0(rts), ua1(txd), sd0(d5), dev(cs0)
77 mpp59 59 gpio, pcie0(rstout), i2c1(sda), spi1(cs0), sd0(d2)
|
| D | marvell,armada-39x-pinctrl.txt | 36 mpp18 18 gpio, ua1(txd), spi0(cs0), i2c2(sck)
44 mpp25 25 gpio, spi0(cs0), ua0(rts), ua1(txd), sd0(d5), dev(cs0)
81 mpp59 59 gpio, pcie0(rstout), i2c1(sda), spi1(cs0), sd0(d2)
|
| D | marvell,armada-375-pinctrl.txt | 24 mpp8 8 gpio, dev (bootcs), spi0(cs0), spi1(cs0)
46 mpp30 30 gpio, ge1(txd0), spi1(cs0)
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-370-pinctrl.txt | 29 mpp12 12 gpio, ge0(rxd1), i2c1(sda), sd0(d0), spi1(cs0),
45 mpp24 24 gpio, ge0(col), ge1(txctl), spi1(cs0)
53 mpp32 32 gpio, spi0(cs0)
54 mpp33 33 gpio, dev(bootcs), spi0(cs0)
71 mpp49 49 gpio, dev(ad10), pcie(clkreq1), sd0(d0), spi1(cs0),
86 mpp58 58 gpio, dev(cs0), uart1(rts), tdm(int), audio(extclk),
|
| D | marvell,armada-39x-pinctrl.txt | 36 mpp18 18 gpio, ua1(txd), spi0(cs0), i2c2(sck)
44 mpp25 25 gpio, spi0(cs0), ua0(rts), ua1(txd), sd0(d5), dev(cs0)
81 mpp59 59 gpio, pcie0(rstout), i2c1(sda), spi1(cs0), sd0(d2)
|
| D | marvell,armada-38x-pinctrl.txt | 36 mpp18 18 gpio, ge0(rxerr), ptp(trig), ua1(txd), spi0(cs0)
43 mpp25 25 gpio, spi0(cs0), ua0(rts), ua1(txd), sd0(d5), dev(cs0)
77 mpp59 59 gpio, pcie0(rstout), i2c1(sda), spi1(cs0), sd0(d2)
|
| D | marvell,armada-375-pinctrl.txt | 24 mpp8 8 gpio, dev (bootcs), spi0(cs0), spi1(cs0)
46 mpp30 30 gpio, ge1(txd0), spi1(cs0)
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/ti/omap/ |
| D | omap3-n950-n9.dtsi | 359 ranges = <0 0 0x04000000 0x1000000>; /* CS0: 16MB for OneNAND */
365 reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */
372 * gpmc cs0 before gpmc_cs_program_settings:
373 * cs0 GPMC_CS_CONFIG1: 0xfd001202
374 * cs0 GPMC_CS_CONFIG2: 0x00181800
375 * cs0 GPMC_CS_CONFIG3: 0x00030300
376 * cs0 GPMC_CS_CONFIG4: 0x18001804
377 * cs0 GPMC_CS_CONFIG5: 0x03171d1d
378 * cs0 GPMC_CS_CONFIG6: 0x97080000
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | omap3-n950-n9.dtsi | 359 ranges = <0 0 0x04000000 0x1000000>; /* CS0: 16MB for OneNAND */
365 reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */
372 * gpmc cs0 before gpmc_cs_program_settings:
373 * cs0 GPMC_CS_CONFIG1: 0xfd001202
374 * cs0 GPMC_CS_CONFIG2: 0x00181800
375 * cs0 GPMC_CS_CONFIG3: 0x00030300
376 * cs0 GPMC_CS_CONFIG4: 0x18001804
377 * cs0 GPMC_CS_CONFIG5: 0x03171d1d
378 * cs0 GPMC_CS_CONFIG6: 0x97080000
|
| /kernel/linux/linux-5.10/drivers/watchdog/ |
| D | aspeed_wdt.c | 171 /* access_cs0 shows if cs0 is accessible, hence the reverted bit */
204 * ast2400: a way to get access to the primary SPI flash chip at CS0
207 * (CS0->CS1, CS1->CS0) to (CS0->CS0, CS1->CS1).
211 * mapping state (i.e. booted from CS0), clearing those bits does nothing for
|
| /kernel/linux/linux-5.10/drivers/staging/fbtft/ |
| D | fb_agm1264k-fl.c | 32 #define CS0 gpio.aux[0] macro
114 if (!par->CS0) { in verify_gpios()
116 "Missing info about 'cs0' gpio. Aborting.\n"); in verify_gpios()
143 } else if (strcasecmp(gpio->name, "cs0") == 0) { in request_gpios_match()
145 par->CS0 = gpio->gpio; in request_gpios_match()
197 gpiod_set_value(par->CS0, 0); in write_reg8_bus8()
200 /* cs0 */ in write_reg8_bus8()
201 gpiod_set_value(par->CS0, 1); in write_reg8_bus8()
400 gpiod_set_value(par->CS0, 0); in write_vmem()
|
| /kernel/linux/linux-6.6/drivers/staging/fbtft/ |
| D | fb_agm1264k-fl.c | 32 #define CS0 gpio.aux[0] macro
101 if (!par->CS0) { in verify_gpios()
103 "Missing info about 'cs0' gpio. Aborting.\n"); in verify_gpios()
130 } else if (strcasecmp(gpio->name, "cs0") == 0) { in request_gpios_match()
132 par->CS0 = gpio->gpio; in request_gpios_match()
184 gpiod_set_value(par->CS0, 0); in write_reg8_bus8()
187 /* cs0 */ in write_reg8_bus8()
188 gpiod_set_value(par->CS0, 1); in write_reg8_bus8()
387 gpiod_set_value(par->CS0, 0); in write_vmem()
|
| /kernel/linux/linux-6.6/drivers/watchdog/ |
| D | aspeed_wdt.c | 291 /* access_cs0 shows if cs0 is accessible, hence the reverted bit */
324 * ast2400: a way to get access to the primary SPI flash chip at CS0
327 * (CS0->CS1, CS1->CS0) to (CS0->CS0, CS1->CS1).
331 * mapping state (i.e. booted from CS0), clearing those bits does nothing for
|
| /kernel/linux/linux-5.10/drivers/bus/ |
| D | imx-weim.c | 86 05, /* CS0(128M) CS1(0M) CS2(0M) CS3(0M) */ in imx_weim_gpr_setup()
87 033, /* CS0(64M) CS1(64M) CS2(0M) CS3(0M) */ in imx_weim_gpr_setup()
88 0113, /* CS0(64M) CS1(32M) CS2(32M) CS3(0M) */ in imx_weim_gpr_setup()
89 01111, /* CS0(32M) CS1(32M) CS2(32M) CS3(32M) */ in imx_weim_gpr_setup()
|
| /kernel/linux/linux-6.6/arch/hexagon/kernel/ |
| D | ptrace.c | 64 membuf_store(&to, regs->cs0); in genregs_get()
112 INEXT(®s->cs0, cs0); in genregs_set()
|
| D | signal.c | 54 err |= __put_user(regs->cs0, &sc->sc_regs.cs0); in setup_sigcontext()
84 err |= __get_user(regs->cs0, &sc->sc_regs.cs0); in restore_sigcontext()
|
| /kernel/linux/linux-5.10/arch/hexagon/kernel/ |
| D | ptrace.c | 64 membuf_store(&to, regs->cs0); in genregs_get()
112 INEXT(®s->cs0, cs0); in genregs_set()
|
| D | signal.c | 55 err |= __put_user(regs->cs0, &sc->sc_regs.cs0); in setup_sigcontext()
85 err |= __get_user(regs->cs0, &sc->sc_regs.cs0); in restore_sigcontext()
|