Home
last modified time | relevance | path

Searched refs:NOR (Results 1 – 25 of 187) sorted by relevance

12345678

/external/u-boot/drivers/spi/
DKconfig25 access the SPI NOR flash on platforms embedding this Altera
41 to access SPI NOR flash and other SPI peripherals. This driver
58 access the SPI NOR flash on platforms embedding this Broadcom
66 access the SPI NOR flash on platforms embedding these Broadcom
73 used to access the SPI NOR flash on platforms embedding this
80 access the SPI NOR flash on platforms embedding this Designware
87 access the SPI NOR flash on platforms embedding this Samsung
94 access the SPI NOR flash and SPI Data flash on platforms embedding
102 access the SPI NOR flash on platforms embedding this Intel
110 used to access the SPI NOR flash on platforms embedding this
[all …]
/external/u-boot/board/ti/am335x/
DKconfig15 config NOR config
16 bool "Support for NOR flash"
18 The AM335x SoC supports having a NOR flash connected to the GPMC.
19 In practice this is seen as a NOR flash module connected to the
/external/u-boot/board/freescale/c29xpcie/
DREADME13 - 64 Mbyte NOR flash single-chip memory
35 0xf_ec00_0000 - 0xf_efff_ffff 64MB NOR flash
52 SW5[1:4]= 1111 and SW5[6]=0 for boot from 16bit NOR flash
56 Build and program U-Boot to NOR flash
63 2. Program u-boot.bin into NOR flash
71 Alternate NOR bank
74 1. Program u-boot.bin into alternate NOR bank
80 2. Switch to alternate NOR bank
/external/swiftshader/third_party/llvm-7.0/llvm/test/MC/Mips/
Dinstalias-imm-expanding.s344 # MIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
347 # MICROMIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
351 # MIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
354 # MICROMIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
358 # MIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
361 # MICROMIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
365 # MIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
368 # MICROMIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
372 # MIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
375 # MICROMIPS-NEXT: # <MCInst #{{[0-9]+}} NOR
[all …]
/external/u-boot/board/Arcturus/ucp1020/
DREADME3 DDR3, NOR Flash, eMMC NAND Flash and/or SPI Flash.
15 SPI Flash or NOR flash
19 NOR boot image:
47 NOR Flash Partition declarations and scripts
50 into defined NOR flash partitions. Examples:
/external/u-boot/board/freescale/p1010rdb/
DREADME.P1010RDB-PA15 - 32 Mbyte NOR flash single-chip memory
62 0xee00_0000 0xefff_ffff NOR Flash 32M non-cacheable
82 SW4[1:4]= 1111 and SW6[4]=0 for boot from 16bit NOR flash
98 Build and burn U-Boot to NOR flash
105 2. Burn u-boot.bin into NOR flash
114 Alternate NOR bank
116 1. Burn u-boot.bin into alternate NOR bank
122 2. Switch to alternate NOR bank
129 CPLD NOR bank selection register address 0xFFB00009 Bit[0]:
173 If change boot ROM location to NOR or NAND flash, need write the IFC_CS0
[all …]
DREADME.P1010RDB-PB16 - 32M bytes NOR flash single-chip memory
44 0xee00_0000 0xefff_ffff NOR Flash 32M non-cacheable
73 SW4[1:4]= 1111 and SW3[3:4]= 00 for 16bit NOR boot
82 => run boot_bank0 (boot from NOR bank0)
83 => run boot_bank1 (boot from NOR bank1)
113 To enable SDHC in case of NOR/NAND/SPI boot
134 1. For NOR boot
149 1. NOR boot
/external/u-boot/board/freescale/mpc8313erdb/
DREADME8 To boot the image at 0xFE000000 in NOR flash, use these DIP
42 0xfe00_0000 0xfe7f_ffff NOR FLASH (CS0) 8M
44 When booting from NAND, NAND flash is CS0 and NOR flash
65 33 - 33 MHz oscillator, boot from NOR flash
66 66 - 66 MHz oscillator, boot from NOR flash
75 NOR flash:
/external/u-boot/board/boundary/nitrogen6x/
DREADME.mx6qsabrelite11 boards boot from the SPI NOR flash. These boards need to be reflashed with
13 will be flashed into the SPI NOR. The board will still boot from SPI NOR, but
22 To update the SPI-NOR on the SabreLite board without the Freescale
38 (the default one the board is shipped with, starting from the SPI NOR) and
50 the Freescale manufacturing tool in order to reflash the SPI-NOR.
DREADME8 1. Boot source, boot from SPI NOR
15 In particular, this image supports booting from SPI NOR
16 and saving the environment to SPI NOR.
36 2. Maintaining the SPI NOR
43 in SPI NOR. The search is the same as for
/external/u-boot/doc/
DREADME.spear19 6. Serial NOR ctrl
30 4. EMI (Parallel NOR interface)
37 location i.e. Serial NOR device
40 for CFI compliant parallel NOR flash. Environment variables are
41 placed in Parallel NOR device
DREADME.b4860qds79 - 16-bit NOR Flash / PROMJet
80 - QIXIS 8-bit NOR Flash Emulator
128 Note: Boot location: NOR flash.
137 b) NOR boot
153 Note: Boot location: NOR flash.
162 b) NOR boot
183 0xF_E800_0000 0xF_EFFF_FFFF IFC NOR Flash 128 MB
213 0xF_E800_0000 0xF_EFFF_FFFF IFC NOR Flash 128 MB
227 NOR Flash memory Map on B4860 and B4420QDS
282 5. Switching between NOR and NAND boot(RCW src changed from NOR <-> NAND)
[all …]
/external/u-boot/board/theobroma-systems/puma_rk3399/
DREADME21 * NOR Flash: onboard SPI NOR
60 Creating a SPL image for SPI-NOR
68 Copy the SPL to offset 32k for SD/eMMC, offset 0 for NOR-Flash and the FIT
91 NOR-Flash
94 Writing the SPI NOR Flash requires a running U-Boot. For the sake of simplicity
/external/u-boot/board/renesas/sh7785lcr/
DREADME.sh7785lcr12 - NOR Flash 64MB
25 0x00000000 - 0x03ffffff(CS0) | NOR Flash | NOR Flash
56 0xa0000000 | 0x00000000 | 64MB | NOR Flash
121 NOR Flash and USB Host on U-Boot when you run this command.
/external/u-boot/board/freescale/ls2080ardb/
DREADME29 - 128 MB NOR flash 16-bit data bus
72 0x30000000 - 0x37ffffff : 128MB : NOR flash
79 0x5_8000_0000..0x5_bfff_ffff IFC CS0 1GB (NOR/Promjet)
80 0x5_C000_0000..0x5_ffff_ffff IFC CS1 1GB (NOR/Promjet)
84 a) NOR boot
88 Memory map for NOR boot
/external/u-boot/arch/arm/cpu/armv8/fsl-layerscape/doc/
DREADME.lsch341 is shown below considering a 32MB NOR flash device present on most
63 32-MB NOR flash layout for pre-silicon platforms (simulator and emulator)
66 is shown below considering a 128MB NOR flash device present on QDS and RDB
114 128-MB NOR flash layout for QDS and RDB boards
125 from the location where it is stored(NOR, NAND, SD, SATA, USB)during
133 using NOR Flash i.e. MC, DPL, and DPC is stored in the NOR flash:
147 and 0x580700000 are addresses in NOR where these are copied. It is to be
156 The difference between NAND boot RCW image and NOR boot image is the PBI
209 The difference between SD boot RCW image and QSPI-NOR boot image is the
224 In the example above, 1MB. This is same as QSPI-NOR.
[all …]
/external/u-boot/board/freescale/mx28evk/
DREADME26 To boot MX28EVK from SPI NOR flash, set the boot mode DIP switches as:
48 "make mx28evk_spi_config" - store environment variables into SPI NOR flash
56 mx28evk does not come with SPI NOR flash populated from the factory either.
62 to generate a binary to be flashed into SPI NOR.
/external/u-boot/board/freescale/t102xrdb/
DREADME87 - NOR: 128MB 16-bit NOR Flash
115 - NOR: 128MB S29GL01GS110TFIV10 Spansion NOR Flash
137 0xF_E800_0000 0xF_EFFF_FFFF IFC - NOR Flash 128MB
145 128MB NOR Flash Memory Layout
186 1. NOR boot:
187 a. build NOR boot image
190 b. program u-boot.bin image to NOR flash
194 set SW1[1:8] = '00010011', SW2[1] = '1', SW3[4] = '0' for NOR boot
196 set SW1[1:8] = '00010111', SW2[1] = '1', SW3[4] = '0' for NOR boot
198 Switching between default bank0 and alternate bank4 on NOR flash
/external/u-boot/board/freescale/t208xrdb/
DREADME32 - Integrated Flash Controller supporting NAND and NOR flash
69 - NOR: 128MB 16-bit NOR Flash
98 0xF_E800_0000 0xF_EFFF_FFFF IFC - NOR Flash 128MB
107 128M NOR Flash memory Map
147 1. NOR boot:
148 a. build NOR boot image
151 b. program u-boot.bin image to NOR flash
154 set SW1[1:8] = '00010011', SW2[1] = '1', SW3[4] = '0' for NOR boot
156 Switching between default bank and alternate bank on NOR flash
/external/u-boot/board/freescale/mpc8315erdb/
DREADME8 To boot the image at 0xFE000000 in NOR flash, use these DIP
39 0xfe00_0000 0xfe7f_ffff NOR FLASH (CS0) 8M
41 When booting from NAND, NAND flash is CS0 and NOR flash
68 NOR flash:
/external/u-boot/board/freescale/mx35pdk/
DREADME43 and for NOR:
74 U-Boot should be stored on the NOR flash.
82 Saving U-Boot in the NOR flash
85 Check the partition for boot in the NOR flash. Setting the mtdparts as reported,
102 To boot from NOR, you have to select the switches as follows:
/external/u-boot/tools/env/
Dfw_env.config4 # Notice, that the "Number of sectors" is not required on NOR and SPI-dataflash.
6 # be the same as the Environment size, which is valid for NOR and SPI-dataflash
9 # NOR example
/external/u-boot/board/freescale/mpc837xemds/
DREADME29 SW6[1-8]= 0000_1000 (HRCW is read from NOR FLASH)
34 J10 removed, CS0 connect to NOR flash; when mounted, CS0 connect to NAND
35 J11 removed, Hardware Reset Configuration Word load from FLASH(NOR or NAND)
55 0xfe00_0000 0xffff_ffff NOR Flash on CS0 32M
/external/u-boot/board/freescale/t208xqds/
DREADME32 - Integrated Flash Controller supporting NAND and NOR flash
67 - 128MB NOR Flash, 512MB NAND Flash, PromJet debug port and FPGA
133 0xF_E800_0000 0xF_EFFF_FFFF IFC - NOR Flash 128MB
142 128M NOR Flash memory Map
164 1. NOR boot:
165 a. build NOR boot image
168 b. program u-boot.bin image to NOR flash
171 set SW1[1:8] = '00010011', SW2[1] = '1', SW6[1:4] = '0000' for NOR boot
173 Switching between default bank0 and alternate bank4 on NOR flash
/external/u-boot/drivers/mtd/
DKconfig12 bool "Enable parallel NOR flash support"
14 Enable support for parallel NOR flash.
33 NOR flash to parallel flash interface. Please find details on the

12345678