• Home
  • Line#
  • Scopes#
  • Navigate#
  • Raw
  • Download
1Intel x86 PINCTRL/GPIO controller
2
3Pin-muxing on broadwell devices can be described with a node for the PINCTRL
4master node and a set of child nodes for each required pin state on the SoC.
5These pin states use phandles and are referred to but a configuration section
6which lists all pins in the device.
7
8The PINCTRL master node requires the following properties:
9- compatible : "intel,x86-broadwell-pinctrl"
10
11Pin state nodes must be sub-nodes of the pinctrl master node. The must have
12a phandle. They can contain the following optional properties:
13- mode-gpio	- forces the pin into GPIO mode
14- output-value	- sets the default output value of the GPIO, 0 (low, default)
15			or 1 (high)
16- direction	- sets the direction of the gpio, either PIN_INPUT (default)
17			or PIN_OUTPUT
18- invert	- the input pin is inverted
19- trigger	- sets the trigger type, either TRIGGER_EDGE (default) or
20			TRIGGER_LEVEL
21- sense-disable - the input state sense is disabled
22- owner		0 sets the owner of the pin, either OWNER_ACPI (default) or
23			ONWER_GPIO
24- route		- sets whether the pin is routed, either PIRQ_APIC_MASK or
25			PIRQ_APIC_ROUTE
26- irq-enable	- the interrupt is enabled
27- reset-rsmrst	- the pin will only be reset by RSMRST
28- pirq-apic	- the pin will be routed to the IOxAPIC
29
30The first pin state will be the default, so pins without a configuration will
31use that.
32
33The pin configuration node is also a sub-node of the pinctrl master node, but
34does not have a phandle. It has a single property:
35
36- config	- configuration to use for each pin. Each entry has of 3 cells:
37			- GPIO number (0..94)
38			- phandle of configuration (above)
39			- interrupt number (0..15)
40
41		  There should be one entry for each pin (i.e. 95 entries).
42		  But missing pins will receive the default configuration.
43
44Example:
45
46pch_pinctrl {
47	compatible = "intel,x86-broadwell-pinctrl";
48
49	/* Put this first: it is the default */
50	gpio_unused: gpio-unused {
51		mode-gpio;
52		direction = <PIN_INPUT>;
53		owner = <OWNER_GPIO>;
54		sense-disable;
55	};
56
57	gpio_acpi_sci: acpi-sci {
58		mode-gpio;
59		direction = <PIN_INPUT>;
60		invert;
61		route = <ROUTE_SCI>;
62	};
63
64	gpio_acpi_smi: acpi-smi {
65		mode-gpio;
66		direction = <PIN_INPUT>;
67		invert;
68		route = <ROUTE_SMI>;
69	};
70
71	gpio_input: gpio-input {
72		mode-gpio;
73		direction = <PIN_INPUT>;
74		owner = <OWNER_GPIO>;
75	};
76
77	gpio_input_invert: gpio-input-invert {
78		mode-gpio;
79		direction = <PIN_INPUT>;
80		owner = <OWNER_GPIO>;
81		invert;
82	};
83
84	gpio_native: gpio-native {
85	};
86
87	gpio_out_high: gpio-out-high {
88		mode-gpio;
89		direction = <PIN_OUTPUT>;
90		output-value = <1>;
91		owner = <OWNER_GPIO>;
92		sense-disable;
93	};
94
95	gpio_out_low: gpio-out-low {
96		mode-gpio;
97		direction = <PIN_OUTPUT>;
98		output-value = <0>;
99		owner = <OWNER_GPIO>;
100		sense-disable;
101	};
102
103	gpio_pirq: gpio-pirq {
104		mode-gpio;
105		direction = <PIN_INPUT>;
106		owner = <OWNER_GPIO>;
107		pirq-apic = <PIRQ_APIC_ROUTE>;
108	};
109
110	soc_gpio@0 {
111		config =
112			<0 &gpio_unused 0>,	/* unused */
113			<1 &gpio_unused 0>,	/* unused */
114			<2 &gpio_unused 0>,	/* unused */
115			<3 &gpio_unused 0>,	/* unused */
116			<4 &gpio_native 0>,	/* native: i2c0_sda_gpio4 */
117			<5 &gpio_native 0>,	/* native: i2c0_scl_gpio5 */
118			<6 &gpio_native 0>,	/* native: i2c1_sda_gpio6 */
119			<7 &gpio_native 0>,	/* native: i2c1_scl_gpio7 */
120			<8 &gpio_acpi_sci 0>,	/* pch_lte_wake_l */
121			<9 &gpio_input_invert 0>,/* trackpad_int_l (wake) */
122			<10 &gpio_acpi_sci 0>,	/* pch_wlan_wake_l */
123			<11 &gpio_unused 0>,	/* unused */
124			<12 &gpio_unused 0>,	/* unused */
125			<13 &gpio_pirq 3>,	/* trackpad_int_l (pirql) */
126			<14 &gpio_pirq 4>,	/* touch_int_l (pirqm) */
127			<15 &gpio_unused 0>,	/* unused (strap) */
128			<16 &gpio_input 0>,	/* pch_wp */
129			<17 &gpio_unused 0>,	/* unused */
130			<18 &gpio_unused 0>,	/* unused */
131			<19 &gpio_unused 0>,	/* unused */
132			<20 &gpio_native 0>,	/* pcie_wlan_clkreq_l */
133			<21 &gpio_out_high 0>,	/* pp3300_ssd_en */
134			<22 &gpio_unused 0>,	/* unused */
135			<23 &gpio_out_low 0>,	/* pp3300_autobahn_en */
136			<24 &gpio_unused 0>,	/* unused */
137			<25 &gpio_input 0>,	/* ec_in_rw */
138			<26 &gpio_unused 0>,	/* unused */
139			<27 &gpio_acpi_sci 0>,	/* pch_wake_l */
140			<28 &gpio_unused 0>,	/* unused */
141			<29 &gpio_unused 0>,	/* unused */
142			<30 &gpio_native 0>,	/* native: pch_suswarn_l */
143			<31 &gpio_native 0>,	/* native: acok_buf */
144			<32 &gpio_native 0>,	/* native: lpc_clkrun_l */
145			<33 &gpio_native 0>,	/* native: ssd_devslp */
146			<34 &gpio_acpi_smi 0>,	/* ec_smi_l */
147			<35 &gpio_acpi_smi 0>,	/* pch_nmi_dbg_l (route in nmi_en) */
148			<36 &gpio_acpi_sci 0>,	/* ec_sci_l */
149			<37 &gpio_unused 0>,	/* unused */
150			<38 &gpio_unused 0>,	/* unused */
151			<39 &gpio_unused 0>,	/* unused */
152			<40 &gpio_native 0>,	/* native: pch_usb1_oc_l */
153			<41 &gpio_native 0>,	/* native: pch_usb2_oc_l */
154			<42 &gpio_unused 0>,	/* wlan_disable_l */
155			<43 &gpio_out_high 0>,	/* pp1800_codec_en */
156			<44 &gpio_unused 0>,	/* unused */
157			<45 &gpio_acpi_sci 0>,	/* dsp_int - codec wake */
158			<46 &gpio_pirq 6>,	/* hotword_det_l_3v3 (pirqo) - codec irq */
159			<47 &gpio_out_low 0>,	/* ssd_reset_l */
160			<48 &gpio_unused 0>,	/* unused */
161			<49 &gpio_unused 0>,	/* unused */
162			<50 &gpio_unused 0>,	/* unused */
163			<51 &gpio_unused 0>,	/* unused */
164			<52 &gpio_input 0>,	/* sim_det */
165			<53 &gpio_unused 0>,	/* unused */
166			<54 &gpio_unused 0>,	/* unused */
167			<55 &gpio_unused 0>,	/* unused */
168			<56 &gpio_unused 0>,	/* unused */
169			<57 &gpio_out_high 0>,	/* codec_reset_l */
170			<58 &gpio_unused 0>,	/* unused */
171			<59 &gpio_out_high 0>,	/* lte_disable_l */
172			<60 &gpio_unused 0>,	/* unused */
173			<61 &gpio_native 0>,	/* native: pch_sus_stat */
174			<62 &gpio_native 0>,	/* native: pch_susclk */
175			<63 &gpio_native 0>,	/* native: pch_slp_s5_l */
176			<64 &gpio_unused 0>,	/* unused */
177			<65 &gpio_input 0>,	/* ram_id3 */
178			<66 &gpio_input 0>,	/* ram_id3_old (strap) */
179			<67 &gpio_input 0>,	/* ram_id0 */
180			<68 &gpio_input 0>,	/* ram_id1 */
181			<69 &gpio_input 0>,	/* ram_id2 */
182			<70 &gpio_unused 0>,	/* unused */
183			<71 &gpio_native 0>,	/* native: modphy_en */
184			<72 &gpio_unused 0>,	/* unused */
185			<73 &gpio_unused 0>,	/* unused */
186			<74 &gpio_unused 0>,	/* unused */
187			<75 &gpio_unused 0>,	/* unused */
188			<76 &gpio_unused 0>,	/* unused */
189			<77 &gpio_unused 0>,	/* unused */
190			<78 &gpio_unused 0>,	/* unused */
191			<79 &gpio_unused 0>,	/* unused */
192			<80 &gpio_unused 0>,	/* unused */
193			<81 &gpio_unused 0>,	/* unused */
194			<82 &gpio_native 0>,	/* native: ec_rcin_l */
195			<83 &gpio_native 0>,	/* gspi0_cs */
196			<84 &gpio_native 0>,	/* gspi0_clk */
197			<85 &gpio_native 0>,	/* gspi0_miso */
198			<86 &gpio_native 0>,	/* gspi0_mosi (strap) */
199			<87 &gpio_unused 0>,	/* unused */
200			<88 &gpio_unused 0>,	/* unused */
201			<89 &gpio_out_high 0>,	/* pp3300_sd_en */
202			<90 &gpio_unused 0>,	/* unused */
203			<91 &gpio_unused 0>,	/* unused */
204			<92 &gpio_unused 0>,	/* unused */
205			<93 &gpio_unused 0>,	/* unused */
206			<94 &gpio_unused 0 >;	/* unused */
207	};
208};
209