1 /*
2 *
3 * BRIEF MODULE DESCRIPTION
4 * IT8172 IDE controller support
5 *
6 * Copyright (C) 2000 MontaVista Software Inc.
7 * Copyright (C) 2008 Shane McDonald
8 *
9 * This program is free software; you can redistribute it and/or modify it
10 * under the terms of the GNU General Public License as published by the
11 * Free Software Foundation; either version 2 of the License, or (at your
12 * option) any later version.
13 *
14 * THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
15 * WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
16 * MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
17 * NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
18 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
19 * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
20 * USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
21 * ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
22 * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
23 * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
24 *
25 * You should have received a copy of the GNU General Public License along
26 * with this program; if not, write to the Free Software Foundation, Inc.,
27 * 675 Mass Ave, Cambridge, MA 02139, USA.
28 */
29
30 #include <linux/module.h>
31 #include <linux/types.h>
32 #include <linux/kernel.h>
33 #include <linux/ioport.h>
34 #include <linux/pci.h>
35 #include <linux/ide.h>
36 #include <linux/init.h>
37
38 #define DRV_NAME "IT8172"
39
it8172_set_pio_mode(ide_drive_t * drive,const u8 pio)40 static void it8172_set_pio_mode(ide_drive_t *drive, const u8 pio)
41 {
42 ide_hwif_t *hwif = drive->hwif;
43 struct pci_dev *dev = to_pci_dev(hwif->dev);
44 u16 drive_enables;
45 u32 drive_timing;
46
47 /*
48 * The highest value of DIOR/DIOW pulse width and recovery time
49 * that can be set in the IT8172 is 8 PCI clock cycles. As a result,
50 * it cannot be configured for PIO mode 0. This table sets these
51 * parameters to the maximum supported by the IT8172.
52 */
53 static const u8 timings[] = { 0x3f, 0x3c, 0x1b, 0x12, 0x0a };
54
55 pci_read_config_word(dev, 0x40, &drive_enables);
56 pci_read_config_dword(dev, 0x44, &drive_timing);
57
58 /*
59 * Enable port 0x44. The IT8172 spec is confused; it calls
60 * this register the "Slave IDE Timing Register", but in fact,
61 * it controls timing for both master and slave drives.
62 */
63 drive_enables |= 0x4000;
64
65 drive_enables &= drive->dn ? 0xc006 : 0xc060;
66 if (drive->media == ide_disk)
67 /* enable prefetch */
68 drive_enables |= 0x0004 << (drive->dn * 4);
69 if (ata_id_has_iordy(drive->id))
70 /* enable IORDY sample-point */
71 drive_enables |= 0x0002 << (drive->dn * 4);
72
73 drive_timing &= drive->dn ? 0x00003f00 : 0x000fc000;
74 drive_timing |= timings[pio] << (drive->dn * 6 + 8);
75
76 pci_write_config_word(dev, 0x40, drive_enables);
77 pci_write_config_dword(dev, 0x44, drive_timing);
78 }
79
it8172_set_dma_mode(ide_drive_t * drive,const u8 speed)80 static void it8172_set_dma_mode(ide_drive_t *drive, const u8 speed)
81 {
82 ide_hwif_t *hwif = drive->hwif;
83 struct pci_dev *dev = to_pci_dev(hwif->dev);
84 int a_speed = 3 << (drive->dn * 4);
85 int u_flag = 1 << drive->dn;
86 int u_speed = 0;
87 u8 reg48, reg4a;
88
89 pci_read_config_byte(dev, 0x48, ®48);
90 pci_read_config_byte(dev, 0x4a, ®4a);
91
92 if (speed >= XFER_UDMA_0) {
93 u8 udma = speed - XFER_UDMA_0;
94 u_speed = udma << (drive->dn * 4);
95
96 pci_write_config_byte(dev, 0x48, reg48 | u_flag);
97 reg4a &= ~a_speed;
98 pci_write_config_byte(dev, 0x4a, reg4a | u_speed);
99 } else {
100 const u8 mwdma_to_pio[] = { 0, 3, 4 };
101 u8 pio;
102
103 pci_write_config_byte(dev, 0x48, reg48 & ~u_flag);
104 pci_write_config_byte(dev, 0x4a, reg4a & ~a_speed);
105
106 pio = mwdma_to_pio[speed - XFER_MW_DMA_0];
107
108 it8172_set_pio_mode(drive, pio);
109 }
110 }
111
112
113 static const struct ide_port_ops it8172_port_ops = {
114 .set_pio_mode = it8172_set_pio_mode,
115 .set_dma_mode = it8172_set_dma_mode,
116 };
117
118 static const struct ide_port_info it8172_port_info __devinitdata = {
119 .name = DRV_NAME,
120 .port_ops = &it8172_port_ops,
121 .enablebits = { {0x41, 0x80, 0x80}, {0x00, 0x00, 0x00} },
122 .host_flags = IDE_HFLAG_SINGLE,
123 .pio_mask = ATA_PIO4 & ~ATA_PIO0,
124 .mwdma_mask = ATA_MWDMA2,
125 .udma_mask = ATA_UDMA2,
126 };
127
it8172_init_one(struct pci_dev * dev,const struct pci_device_id * id)128 static int __devinit it8172_init_one(struct pci_dev *dev,
129 const struct pci_device_id *id)
130 {
131 if ((dev->class >> 8) != PCI_CLASS_STORAGE_IDE)
132 return -ENODEV; /* IT8172 is more than an IDE controller */
133 return ide_pci_init_one(dev, &it8172_port_info, NULL);
134 }
135
136 static struct pci_device_id it8172_pci_tbl[] = {
137 { PCI_VDEVICE(ITE, PCI_DEVICE_ID_ITE_8172), 0 },
138 { 0, },
139 };
140 MODULE_DEVICE_TABLE(pci, it8172_pci_tbl);
141
142 static struct pci_driver it8172_pci_driver = {
143 .name = "IT8172_IDE",
144 .id_table = it8172_pci_tbl,
145 .probe = it8172_init_one,
146 .remove = ide_pci_remove,
147 .suspend = ide_pci_suspend,
148 .resume = ide_pci_resume,
149 };
150
it8172_ide_init(void)151 static int __init it8172_ide_init(void)
152 {
153 return ide_pci_register_driver(&it8172_pci_driver);
154 }
155
it8172_ide_exit(void)156 static void __exit it8172_ide_exit(void)
157 {
158 pci_unregister_driver(&it8172_pci_driver);
159 }
160
161 module_init(it8172_ide_init);
162 module_exit(it8172_ide_exit);
163
164 MODULE_AUTHOR("Steve Longerbeam");
165 MODULE_DESCRIPTION("PCI driver module for ITE 8172 IDE");
166 MODULE_LICENSE("GPL");
167