• Home
  • Line#
  • Scopes#
  • Navigate#
  • Raw
  • Download
1 /* stnic.c : A SH7750 specific part of driver for NS DP83902A ST-NIC.
2  *
3  * This file is subject to the terms and conditions of the GNU General Public
4  * License.  See the file "COPYING" in the main directory of this archive
5  * for more details.
6  *
7  * Copyright (C) 1999 kaz Kojima
8  */
9 
10 #include <linux/module.h>
11 #include <linux/kernel.h>
12 #include <linux/errno.h>
13 #include <linux/interrupt.h>
14 #include <linux/ioport.h>
15 #include <linux/netdevice.h>
16 #include <linux/etherdevice.h>
17 #include <linux/init.h>
18 #include <linux/delay.h>
19 
20 #include <asm/system.h>
21 #include <asm/io.h>
22 #include <mach-se/mach/se.h>
23 #include <asm/machvec.h>
24 #ifdef CONFIG_SH_STANDARD_BIOS
25 #include <asm/sh_bios.h>
26 #endif
27 
28 #include "8390.h"
29 
30 #define DRV_NAME "stnic"
31 
32 #define byte	unsigned char
33 #define half	unsigned short
34 #define word	unsigned int
35 #define vbyte	volatile unsigned char
36 #define vhalf	volatile unsigned short
37 #define vword	volatile unsigned int
38 
39 #define STNIC_RUN	0x01	/* 1 == Run, 0 == reset. */
40 
41 #define START_PG	0	/* First page of TX buffer */
42 #define STOP_PG		128	/* Last page +1 of RX ring */
43 
44 /* Alias */
45 #define STNIC_CR	E8390_CMD
46 #define PG0_RSAR0	EN0_RSARLO
47 #define PG0_RSAR1	EN0_RSARHI
48 #define PG0_RBCR0	EN0_RCNTLO
49 #define PG0_RBCR1	EN0_RCNTHI
50 
51 #define CR_RRD		E8390_RREAD
52 #define CR_RWR		E8390_RWRITE
53 #define CR_PG0		E8390_PAGE0
54 #define CR_STA		E8390_START
55 #define CR_RDMA		E8390_NODMA
56 
57 /* FIXME! YOU MUST SET YOUR OWN ETHER ADDRESS.  */
58 static byte stnic_eadr[6] =
59 {0x00, 0xc0, 0x6e, 0x00, 0x00, 0x07};
60 
61 static struct net_device *stnic_dev;
62 
63 static void stnic_reset (struct net_device *dev);
64 static void stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
65 			   int ring_page);
66 static void stnic_block_input (struct net_device *dev, int count,
67 			       struct sk_buff *skb , int ring_offset);
68 static void stnic_block_output (struct net_device *dev, int count,
69 				const unsigned char *buf, int start_page);
70 
71 static void stnic_init (struct net_device *dev);
72 
73 /* SH7750 specific read/write io. */
74 static inline void
STNIC_DELAY(void)75 STNIC_DELAY (void)
76 {
77   vword trash;
78   trash = *(vword *) 0xa0000000;
79   trash = *(vword *) 0xa0000000;
80   trash = *(vword *) 0xa0000000;
81 }
82 
83 static inline byte
STNIC_READ(int reg)84 STNIC_READ (int reg)
85 {
86   byte val;
87 
88   val = (*(vhalf *) (PA_83902 + ((reg) << 1)) >> 8) & 0xff;
89   STNIC_DELAY ();
90   return val;
91 }
92 
93 static inline void
STNIC_WRITE(int reg,byte val)94 STNIC_WRITE (int reg, byte val)
95 {
96   *(vhalf *) (PA_83902 + ((reg) << 1)) = ((half) (val) << 8);
97   STNIC_DELAY ();
98 }
99 
stnic_probe(void)100 static int __init stnic_probe(void)
101 {
102   struct net_device *dev;
103   int i, err;
104 
105   /* If we are not running on a SolutionEngine, give up now */
106   if (! MACH_SE)
107     return -ENODEV;
108 
109   /* New style probing API */
110   dev = alloc_ei_netdev();
111   if (!dev)
112   	return -ENOMEM;
113 
114 #ifdef CONFIG_SH_STANDARD_BIOS
115   sh_bios_get_node_addr (stnic_eadr);
116 #endif
117   for (i = 0; i < ETHER_ADDR_LEN; i++)
118     dev->dev_addr[i] = stnic_eadr[i];
119 
120   /* Set the base address to point to the NIC, not the "real" base! */
121   dev->base_addr = 0x1000;
122   dev->irq = IRQ_STNIC;
123   dev->netdev_ops = &ei_netdev_ops;
124 
125   /* Snarf the interrupt now.  There's no point in waiting since we cannot
126      share and the board will usually be enabled. */
127   err = request_irq (dev->irq, ei_interrupt, 0, DRV_NAME, dev);
128   if (err)  {
129       printk (KERN_EMERG " unable to get IRQ %d.\n", dev->irq);
130       free_netdev(dev);
131       return err;
132     }
133 
134   ei_status.name = dev->name;
135   ei_status.word16 = 1;
136 #ifdef __LITTLE_ENDIAN__
137   ei_status.bigendian = 0;
138 #else
139   ei_status.bigendian = 1;
140 #endif
141   ei_status.tx_start_page = START_PG;
142   ei_status.rx_start_page = START_PG + TX_PAGES;
143   ei_status.stop_page = STOP_PG;
144 
145   ei_status.reset_8390 = &stnic_reset;
146   ei_status.get_8390_hdr = &stnic_get_hdr;
147   ei_status.block_input = &stnic_block_input;
148   ei_status.block_output = &stnic_block_output;
149 
150   stnic_init (dev);
151 
152   err = register_netdev(dev);
153   if (err) {
154     free_irq(dev->irq, dev);
155     free_netdev(dev);
156     return err;
157   }
158   stnic_dev = dev;
159 
160   printk (KERN_INFO "NS ST-NIC 83902A\n");
161 
162   return 0;
163 }
164 
165 static void
stnic_reset(struct net_device * dev)166 stnic_reset (struct net_device *dev)
167 {
168   *(vhalf *) PA_83902_RST = 0;
169   udelay (5);
170   if (ei_debug > 1)
171     printk (KERN_WARNING "8390 reset done (%ld).\n", jiffies);
172   *(vhalf *) PA_83902_RST = ~0;
173   udelay (5);
174 }
175 
176 static void
stnic_get_hdr(struct net_device * dev,struct e8390_pkt_hdr * hdr,int ring_page)177 stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
178 	       int ring_page)
179 {
180   half buf[2];
181 
182   STNIC_WRITE (PG0_RSAR0, 0);
183   STNIC_WRITE (PG0_RSAR1, ring_page);
184   STNIC_WRITE (PG0_RBCR0, 4);
185   STNIC_WRITE (PG0_RBCR1, 0);
186   STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
187 
188   buf[0] = *(vhalf *) PA_83902_IF;
189   STNIC_DELAY ();
190   buf[1] = *(vhalf *) PA_83902_IF;
191   STNIC_DELAY ();
192   hdr->next = buf[0] >> 8;
193   hdr->status = buf[0] & 0xff;
194 #ifdef __LITTLE_ENDIAN__
195   hdr->count = buf[1];
196 #else
197   hdr->count = ((buf[1] >> 8) & 0xff) | (buf[1] << 8);
198 #endif
199 
200   if (ei_debug > 1)
201     printk (KERN_DEBUG "ring %x status %02x next %02x count %04x.\n",
202 	    ring_page, hdr->status, hdr->next, hdr->count);
203 
204   STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
205 }
206 
207 /* Block input and output, similar to the Crynwr packet driver. If you are
208    porting to a new ethercard look at the packet driver source for hints.
209    The HP LAN doesn't use shared memory -- we put the packet
210    out through the "remote DMA" dataport. */
211 
212 static void
stnic_block_input(struct net_device * dev,int length,struct sk_buff * skb,int offset)213 stnic_block_input (struct net_device *dev, int length, struct sk_buff *skb,
214 		   int offset)
215 {
216   char *buf = skb->data;
217   half val;
218 
219   STNIC_WRITE (PG0_RSAR0, offset & 0xff);
220   STNIC_WRITE (PG0_RSAR1, offset >> 8);
221   STNIC_WRITE (PG0_RBCR0, length & 0xff);
222   STNIC_WRITE (PG0_RBCR1, length >> 8);
223   STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
224 
225   if (length & 1)
226     length++;
227 
228   while (length > 0)
229     {
230       val = *(vhalf *) PA_83902_IF;
231 #ifdef __LITTLE_ENDIAN__
232       *buf++ = val & 0xff;
233       *buf++ = val >> 8;
234 #else
235       *buf++ = val >> 8;
236       *buf++ = val & 0xff;
237 #endif
238       STNIC_DELAY ();
239       length -= sizeof (half);
240     }
241 
242   STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
243 }
244 
245 static void
stnic_block_output(struct net_device * dev,int length,const unsigned char * buf,int output_page)246 stnic_block_output (struct net_device *dev, int length,
247 		    const unsigned char *buf, int output_page)
248 {
249   STNIC_WRITE (PG0_RBCR0, 1);	/* Write non-zero value */
250   STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
251   STNIC_DELAY ();
252 
253   STNIC_WRITE (PG0_RBCR0, length & 0xff);
254   STNIC_WRITE (PG0_RBCR1, length >> 8);
255   STNIC_WRITE (PG0_RSAR0, 0);
256   STNIC_WRITE (PG0_RSAR1, output_page);
257   STNIC_WRITE (STNIC_CR, CR_RWR | CR_PG0 | CR_STA);
258 
259   if (length & 1)
260     length++;
261 
262   while (length > 0)
263     {
264 #ifdef __LITTLE_ENDIAN__
265       *(vhalf *) PA_83902_IF = ((half) buf[1] << 8) | buf[0];
266 #else
267       *(vhalf *) PA_83902_IF = ((half) buf[0] << 8) | buf[1];
268 #endif
269       STNIC_DELAY ();
270       buf += sizeof (half);
271       length -= sizeof (half);
272     }
273 
274   STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
275 }
276 
277 /* This function resets the STNIC if something screws up.  */
278 static void
stnic_init(struct net_device * dev)279 stnic_init (struct net_device *dev)
280 {
281   stnic_reset (dev);
282   NS8390_init (dev, 0);
283   return;
284 }
285 
stnic_cleanup(void)286 static void __exit stnic_cleanup(void)
287 {
288 	unregister_netdev(stnic_dev);
289 	free_irq(stnic_dev->irq, stnic_dev);
290 	free_netdev(stnic_dev);
291 }
292 
293 module_init(stnic_probe);
294 module_exit(stnic_cleanup);
295 MODULE_LICENSE("GPL");
296