1# 2# 1-wire slaves configuration 3# 4 5menu "1-wire Slaves" 6 7config W1_SLAVE_THERM 8 tristate "Thermal family implementation" 9 help 10 Say Y here if you want to connect 1-wire thermal sensors to your 11 wire. 12 13config W1_SLAVE_SMEM 14 tristate "Simple 64bit memory family implementation" 15 help 16 Say Y here if you want to connect 1-wire 17 simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire. 18 19config W1_SLAVE_DS2431 20 tristate "1kb EEPROM family support (DS2431)" 21 help 22 Say Y here if you want to use a 1-wire 23 1kb EEPROM family device (DS2431) 24 25config W1_SLAVE_DS2433 26 tristate "4kb EEPROM family support (DS2433)" 27 help 28 Say Y here if you want to use a 1-wire 29 4kb EEPROM family device (DS2433). 30 31config W1_SLAVE_DS2433_CRC 32 bool "Protect DS2433 data with a CRC16" 33 depends on W1_SLAVE_DS2433 34 select CRC16 35 help 36 Say Y here to protect DS2433 data with a CRC16. 37 Each block has 30 bytes of data and a two byte CRC16. 38 Full block writes are only allowed if the CRC is valid. 39 40config W1_SLAVE_DS2760 41 tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)" 42 depends on W1 43 help 44 If you enable this you will have the DS2760 battery monitor 45 chip support. 46 47 The battery monitor chip is used in many batteries/devices 48 as the one who is responsible for charging/discharging/monitoring 49 Li+ batteries. 50 51 If you are unsure, say N. 52 53config W1_SLAVE_BQ27000 54 tristate "BQ27000 slave support" 55 depends on W1 56 help 57 Say Y here if you want to use a hdq 58 bq27000 slave support. 59 60endmenu 61