1if NLM_XLP_BOARD || NLM_XLR_BOARD 2 3if NLM_XLP_BOARD 4config DT_XLP_EVP 5 bool "Built-in device tree for XLP EVP boards" 6 default y 7 help 8 Add an FDT blob for XLP EVP boards into the kernel. 9 This DTB will be used if the firmware does not pass in a DTB 10 pointer to the kernel. The corresponding DTS file is at 11 arch/mips/netlogic/dts/xlp_evp.dts 12 13config DT_XLP_SVP 14 bool "Built-in device tree for XLP SVP boards" 15 default y 16 help 17 Add an FDT blob for XLP VP boards into the kernel. 18 This DTB will be used if the firmware does not pass in a DTB 19 pointer to the kernel. The corresponding DTS file is at 20 arch/mips/netlogic/dts/xlp_svp.dts 21 22config NLM_MULTINODE 23 bool "Support for multi-chip boards" 24 depends on NLM_XLP_BOARD 25 default n 26 help 27 Add support for boards with 2 or 4 XLPs connected over ICI. 28 29if NLM_MULTINODE 30choice 31 prompt "Number of XLPs on the board" 32 default NLM_MULTINODE_2 33 help 34 In the multi-node case, specify the number of SoCs on the board. 35 36config NLM_MULTINODE_2 37 bool "Dual-XLP board" 38 help 39 Support boards with upto two XLPs connected over ICI. 40 41config NLM_MULTINODE_4 42 bool "Quad-XLP board" 43 help 44 Support boards with upto four XLPs connected over ICI. 45 46endchoice 47 48endif 49endif 50 51config NLM_COMMON 52 bool 53 54endif 55