1Kernel driver scx200_acb 2 3Author: Christer Weinigel <wingel@nano-system.com> 4 5The driver supersedes the older, never merged driver named i2c-nscacb. 6 7Module Parameters 8----------------- 9 10* base: up to 4 ints 11 Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices 12 13 By default the driver uses two base addresses 0x820 and 0x840. 14 If you want only one base address, specify the second as 0 so as to 15 override this default. 16 17Description 18----------- 19 20Enable the use of the ACCESS.bus controller on the Geode SCx200 and 21SC1100 processors and the CS5535 and CS5536 Geode companion devices. 22 23Device-specific notes 24--------------------- 25 26The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820. 27If the scx200_acb driver is built into the kernel, add the following 28parameter to your boot command line: 29 scx200_acb.base=0x810,0x820 30If the scx200_acb driver is built as a module, add the following line to 31a configuration file in /etc/modprobe.d/ instead: 32 options scx200_acb base=0x810,0x820 33