Searched full:encoder (Results 1 – 25 of 95) sorted by relevance
1234
| /Documentation/devicetree/bindings/input/ |
| D | rotary-encoder.txt | 1 Rotary encoder DT bindings 7 - linux,axis: the input subsystem axis to map to this rotary encoder. 9 - rotary-encoder,steps: Number of steps in a full turnaround of the 10 encoder. Only relevant for absolute axis. Defaults to 24 which is a 12 - rotary-encoder,relative-axis: register a relative axis rather than an 15 - rotary-encoder,rollover: Automatic rollover when the rotary value becomes 17 - rotary-encoder,steps-per-period: Number of steps (stable states) per period. 22 - wakeup-source: Boolean, rotary encoder can wake up the system. 23 - rotary-encoder,encoding: String, the method used to encode steps. 27 - rotary-encoder,half-period: Makes the driver work on half-period mode. [all …]
|
| /Documentation/media/uapi/v4l/ |
| D | vidioc-encoder-cmd.rst | 19 VIDIOC_ENCODER_CMD - VIDIOC_TRY_ENCODER_CMD - Execute an encoder command 44 These ioctls control an audio/video (usually MPEG-) encoder. 45 ``VIDIOC_ENCODER_CMD`` sends a command to the encoder, 61 call sends an implicit START command to the encoder if it has not been 65 call will restart the encoder. 69 the encoder, and all buffered data is discarded. 86 - The encoder command, see :ref:`encoder-cmds`. 89 - Flags to go with the command, see :ref:`encoder-flags`. If no 103 .. flat-table:: Encoder Commands 110 - Start the encoder. When the encoder is already running or paused, [all …]
|
| D | ext-ctrls-codec.rst | 49 here. Each hardware MPEG encoder tends to support different subsets 465 hardware, which can still produce a slight hiss, but in the encoder 647 Information. Applicable to the H264 encoder. 657 encoder. 706 Applicable to the H264 encoder. 710 Applicable to the H264 encoder. 719 Applicable to the H264 encoder. Possible values are: 795 the MPEG4 encoder. Possible values are: 828 The profile information for H264. Applicable to the H264 encoder. 910 The profile information for MPEG4. Applicable to the MPEG4 encoder. [all …]
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | renesas,lvds.txt | 1 Renesas R-Car LVDS Encoder 4 These DT bindings describe the LVDS encoder embedded in the Renesas R-Car 31 - On R8A77990, R8A77995 and R8A774C0, the LVDS encoder can use the EXTAL or 41 The LVDS encoder has two video ports. Their connections are modelled using the 51 - renesas,companion : phandle to the companion LVDS encoder. This property is 52 mandatory for the first LVDS encoder on D3 and E3 SoCs, and shall point to 53 the second encoder to be used as a companion in dual-link mode. It shall not 54 be set for any other LVDS encoder.
|
| D | lvds-transmitter.txt | 1 Parallel to LVDS Encoder 25 - compatible: Must be "lvds-encoder" 27 Any encoder compatible with this generic binding, but with additional 43 lvds-encoder { 44 compatible = "lvds-encoder";
|
| D | ti,ds90c185.txt | 11 "ti,ds90c185", "lvds-encoder" for the TI DS90C185 FPD-Link Serializer 12 "ti,ds90c187", "lvds-encoder" for the TI DS90C187 FPD-Link Serializer 30 lvds-encoder { 31 compatible = "ti,ds90c185", "lvds-encoder";
|
| D | dw_hdmi.txt | 1 Synopsys DesignWare HDMI TX Encoder 5 TX Encoder (DWC HDMI TX). It doesn't constitue a device tree binding
|
| D | ti,tfp410.txt | 1 TFP410 DPI to DVI encoder 39 tfp410: encoder@0 {
|
| /Documentation/input/devices/ |
| D | rotary-encoder.rst | 2 rotary-encoder - a generic driver for GPIO connected devices 60 When entering this state, the encoder is put into 'armed' state, 67 Parking position. If the encoder enters this state, a full transition 83 name 'rotary-encoder' and associate the IRQs and some specific platform 100 .dev_id = "rotary-encoder.0", 111 PROPERTY_ENTRY_U32("rotary-encoder,steps-per-period", 24), 113 PROPERTY_ENTRY_U32("rotary-encoder,relative_axis", 0), 118 .name = "rotary-encoder",
|
| /Documentation/devicetree/bindings/media/ |
| D | qcom,venus.txt | 1 * Qualcomm Venus video encoder/decoder accelerators 56 video-decoder and video-encoder, and one optional firmware subnode. 59 Every of video-encoder or video-decoder subnode should have: 64 Definition: Value should contain "venus-decoder" or "venus-encoder" 110 video-encoder { 111 compatible = "venus-encoder";
|
| D | allegro.txt | 2 ZynqMP SoC. The IP core may either be a H.264/H.265 encoder or H.264/H.265 11 "allegro,al5e-1.1", "allegro,al5e": encoder IP core
|
| /Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap-dss.txt | 12 a number of encoder modules. All DSS versions contain DSS Core and DISPC, but 13 the encoder modules vary. 21 The encoder modules encode the received RGB pixel stream to a video output like 29 and the properties for the ports and endpoints for each encoder are 68 hdmi: encoder@58006000 { 87 chip (MIPI DPI to DVI encoder) and a TPD12S015 chip (HDMI ESD protection & level 99 tfp410: encoder@0 { 141 tpd12s015: encoder@1 {
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-lptimer-stm32 | 6 preset value. Encoder counts continuously from 0 to preset 21 Encoder IN1 input servers as the count input (up 24 Encoder IN1 and IN2 inputs are mixed to get direction 37 Configure the device encoder/counter active edge: 43 In quadrature mode, encoder counting scenarios are as follows:
|
| D | sysfs-bus-iio-counter-104-quad-8 | 78 scale attribute selects the encoder phase division (scale of 1 83 The filter and decoder circuit are bypassed. Encoder A 89 Encoder A and B inputs are digitally filtered and 128 Intended for interfacing with encoder Index output in
|
| /Documentation/gpu/ |
| D | tve200.rst | 2 drm/tve200 Faraday TV Encoder 200 6 :doc: Faraday TV Encoder TVE200 DRM Driver
|
| D | vc4.rst | 33 HDMI encoder 39 DSI encoder 45 DPI encoder 51 VEC (Composite TV out) encoder
|
| /Documentation/devicetree/bindings/display/ |
| D | arm,hdlcd.txt | 6 digital encoder (DVI or HDMI). 20 - port: The HDLCD connection to an encoder chip. The connection is modeled 49 /* HDMI encoder on I2C bus */
|
| D | snps,arcpgu.txt | 5 framebuffer and sends it to a single digital encoder (usually HDMI). 16 - port: The PGU connection to an encoder chip.
|
| D | zte,vou.txt | 6 for typical output devices, like HDMI, TV Encoder, VGA, and RGB LCD. 52 * TV Encoder output device 59 to control TV Encoder DAC power, and the second cell is the bit mask.
|
| D | amlogic,meson-dw-hdmi.yaml | 34 selects either the ENCI encoder for the 576i or 480i formats or the ENCP 35 encoder for all the other formats including interlaced HD formats. 37 The VENC uses a DVI encoder on top of the ENCI or ENCP encoders to generate
|
| /Documentation/devicetree/bindings/counter/ |
| D | stm32-timer-cnt.txt | 1 STMicroelectronics STM32 Timer quadrature encoder 3 STM32 Timer provides quadrature encoder to detect
|
| D | stm32-lptimer-cnt.txt | 1 STMicroelectronics STM32 Low-Power Timer quadrature encoder and counter 4 - quadrature encoder to detect angular position and direction of rotary
|
| /Documentation/devicetree/bindings/display/sunxi/ |
| D | sun4i-drm.txt | 35 HDMI Encoder 38 The HDMI Encoder supports the HDMI video and audio outputs, and does 48 - clocks: phandles to the clocks feeding the HDMI encoder 55 - resets: phandle to the reset control for the HDMI encoder (A31 only) 56 - dmas: phandles to the DMA channels used by the HDMI encoder 67 DWC HDMI TX Encoder 86 - clocks: phandles to the clocks feeding the HDMI encoder 131 TV Encoder 134 The TV Encoder supports the composite and VGA output. It is one end of 138 - compatible: value should be "allwinner,sun4i-a10-tv-encoder". [all …]
|
| /Documentation/media/v4l-drivers/ |
| D | davinci-vpbe.rst | 47 When connected to an external encoder, vpbe controller is also responsible 59 at the port or LCD panel timings required. When external encoder/LCD panel 90 - add support for selecting external encoder as default at probe time.
|
| /Documentation/sound/designs/ |
| D | compress-offload.rst | 146 - Merge of encoder/decoder capabilities 157 When playing thru an album, the decoders have the ability to skip the encoder 164 music content. The decoder needs to know the encoder delay and encoder padding. 173 This routine sets the encoder delay and encoder padding. This can be used by
|
1234