1* Clock bindings for Freescale i.MX6 Quad 2 3Required properties: 4- compatible: Should be "fsl,imx6q-ccm" 5- reg: Address and length of the register set 6- interrupts: Should contain CCM interrupt 7- #clock-cells: Should be <1> 8 9Optional properties: 10- fsl,pmic-stby-poweroff: Configure CCM to assert PMIC_STBY_REQ signal 11 on power off. 12 Use this property if the SoC should be powered off by external power 13 management IC (PMIC) triggered via PMIC_STBY_REQ signal. 14 Boards that are designed to initiate poweroff on PMIC_ON_REQ signal should 15 be using "syscon-poweroff" driver instead. 16- clocks: list of clock specifiers, must contain an entry for each entry 17 in clock-names 18- clock-names: valid names are "osc", "ckil", "ckih1", "anaclk1" and "anaclk2" 19 20The clock consumer should specify the desired clock by having the clock 21ID in its "clocks" phandle cell. See include/dt-bindings/clock/imx6qdl-clock.h 22for the full list of i.MX6 Quad and DualLite clock IDs. 23 24Examples: 25 26#include <dt-bindings/clock/imx6qdl-clock.h> 27 28clks: ccm@20c4000 { 29 compatible = "fsl,imx6q-ccm"; 30 reg = <0x020c4000 0x4000>; 31 interrupts = <0 87 0x04 0 88 0x04>; 32 #clock-cells = <1>; 33}; 34 35uart1: serial@2020000 { 36 compatible = "fsl,imx6q-uart", "fsl,imx21-uart"; 37 reg = <0x02020000 0x4000>; 38 interrupts = <0 26 0x04>; 39 clocks = <&clks IMX6QDL_CLK_UART_IPG>, <&clks IMX6QDL_CLK_UART_SERIAL>; 40 clock-names = "ipg", "per"; 41}; 42