Home
last modified time | relevance | path

Searched refs:IP (Results 1 – 25 of 25) sorted by relevance

/arch/x86/kernel/
Dftrace_32.S111 subl $3*4, %esp # RET-IP + 3 gaps
117 pushl 7*4(%esp) # ip <- RET-IP
135 movl PT_EIP(%esp), %eax # 1st argument: IP
Dvm86_32.c81 #define IP(regs) (*(unsigned short *)&((regs)->pt.ip)) macro
557 pushw(ssp, sp, IP(regs), cannot_handle); in do_int()
560 IP(regs) = segoffs & 0xffff; in do_int()
608 ip = IP(regs); in handle_vm86_fault()
639 IP(regs) = ip; in handle_vm86_fault()
653 IP(regs) = ip; in handle_vm86_fault()
666 IP(regs) = ip; in handle_vm86_fault()
694 IP(regs) = newip; in handle_vm86_fault()
707 IP(regs) = ip; in handle_vm86_fault()
719 IP(regs) = ip; in handle_vm86_fault()
Dtraps.c282 #define IP ((void __user *)uprobe_get_trap_addr(regs)) macro
289 DO_ERROR(X86_TRAP_DE, SIGFPE, FPE_INTDIV, IP, "divide error", divide_error)
291 DO_ERROR(X86_TRAP_UD, SIGILL, ILL_ILLOPN, IP, "invalid opcode", invalid_op)
297 #undef IP
/arch/arm/boot/dts/
Danimeo_ip.dts3 * animeo_ip.dts - Device Tree file for Somfy Animeo IP Boards
12 model = "Somfy Animeo IP";
Dste-hrefv60plus.dtsi187 * LED on IP GPIO 4 (XENON_EN2) on altfunction C, that need bias
Dste-nomadik-stn8815.dtsi294 * IP AMBA bus clocks, driving the bus side of the
491 /* IP kernel clocks */
Dbcm283x.dtsi169 * The GPIO IP block is designed for 3 banks of GPIOs.
Dr8a7790-lager.dts298 * We use the I2C demuxer, so the desired IP core can be selected at runtime
Dexynos4.dtsi402 * CLK_G3D is not actually bus clock but a IP-level clock.
/arch/arm/plat-omap/
DKconfig25 bool "AVS(Adaptive Voltage Scaling) support for OMAP IP versions 1&2"
31 version 2 of the SmartReflex IP.
33 V2 is the update for the 45nm version of the IP used in OMAP3630
/arch/um/drivers/
DKconfig160 If you'd like to set up an IP network with the host and/or the
184 which can carry any Ethernet frame (and hence even non-IP packets),
185 the slip transport can only carry IP packets.
221 the host and/or other IP machines, say Y to the Ethertap or Slip
268 other IP machines.
270 To use this, your host kernel(s) must support IP Multicasting.
279 with other IP machines, make sure you select one of the other
307 known as SLiRP, a program that can re-socket IP packets back onto
308 he host on which it is run. Only IP packets are supported,
310 frames. In general, slirp allows the UML the same IP connectivity
/arch/arc/boot/dts/
Dhsdk.dts158 * controlled via register in SDIO IP. Due to its
160 * but it divides by 8) SDIO IP uses wrong clock and
Daxs10x_mb.dtsi56 * controlled via register in SDIO IP. It divides
/arch/arm/mm/
Dproc-sa110.S136 bl v4wb_flush_kern_cache_all @ clears IP
Dproc-sa1100.S146 bl v4wb_flush_kern_cache_all @ clears IP
/arch/nds32/
DKconfig.cpu144 here, which has a severe performance impact. With an IP-only
154 Check exceptions. With an IP-only configuration it is safe to say N,
/arch/unicore32/
DKconfig131 correct operation of some network protocols. With an IP-only
/arch/unicore32/configs/
Ddefconfig50 # TCP/IP networking
/arch/x86/um/
Dsignal.c182 GETREG(IP, ip); in copy_sc_from_user()
275 PUTREG(IP, ip); in copy_sc_to_user()
/arch/arm/kernel/
Dentry-ftrace.S76 add ip, sp, #12 @ move in IP the value of SP as it was
/arch/unicore32/kernel/
Dentry.S641 mov r0, #0 @ trace entry [IP = 0]
656 mov r0, #1 @ trace exit [IP = 1]
/arch/arc/
DKconfig201 bool "ARConnect Multicore IP (MCIP) Support "
205 This IP block enables SMP in ARC-HS38 cores.
/arch/arm64/boot/dts/marvell/
Darmada-ap806.dtsi302 * The thermal IP features one internal sensor plus, if applicable, one
/arch/sparc/
DKconfig415 IP cores that are distributed under GPL. GRLIB can be downloaded
/arch/arm/
DKconfig1632 correct operation of some network protocols. With an IP-only
1946 will be determined at run-time by masking the current IP with