Searched full:resistance (Results 1 – 25 of 44) sorted by relevance
12
| /Documentation/devicetree/bindings/hwmon/ |
| D | max6697.txt | 40 - resistance-cancellation
41 Boolean for all chips other than MAX6581. Set to enable resistance
43 For MAX6581, resistance cancellation enabled for all channels if
46 If not specified, resistance cancellation will be disabled for all
61 resistance-cancellation;
|
| D | maxim,max20730.yaml | 42 resistance. Therefore, the adjusted vout is equal to
43 Vout = Vout * output_resistance / total resistance.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | twl6040.txt | 31 - ti,vibldrv-res: Resistance parameter for left driver
32 - ti,vibrdrv-res: Resistance parameter for right driver
33 - ti,viblmotor-res: Resistance parameter for left motor
34 - ti,viblmotor-res: Resistance parameter for right motor
58 /* Vibra driver, motor resistance parameters */
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | cm3605.txt | 25 - capella,aset-resistance-ohms: the sensitivity calibration resistance,
27 as these are the resistance values that we are supplied with
37 capella,aset-resistance-ohms = <100000>;
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | battery.yaml | 70 factory-internal-resistance-micro-ohms:
71 description: battery factory internal resistance
73 resistance-temp-table:
76 and corresponding battery internal resistance percent, which is used to
77 look up the resistance percent according to current temperature to get an
78 accurate batterty internal resistance in different temperatures.
145 factory-internal-resistance-micro-ohms = <250000>;
153 resistance-temp-table = <20 100>, <10 90>, <0 80>, <(-10) 60>;
|
| D | sc27xx-fg.txt | 16 - sprd,calib-resistance-micro-ohms: Specify the real resistance of coulomb counter
57 sprd,calib-resistance-micro-ohms = <21500>;
|
| D | max17042_battery.txt | 12 - maxim,rsns-microohm : Resistance of rsns resistor in micro Ohms
|
| D | qcom,coincell-charger.txt | 20 Definition: resistance (in ohms) for current-limiting resistor
|
| /Documentation/devicetree/bindings/iio/afe/ |
| D | voltage-divider.txt | 5 interesting voltage is often the voltage over the full resistance
26 - output-ohms : Resistance Rout over which the output voltage is measured.
28 - full-ohms : Resistance R + Rout for the full divider. The io-channel
|
| D | current-sense-amplifier.txt | 12 - sense-resistor-micro-ohms : The sense resistance in microohms.
|
| D | current-sense-shunt.txt | 12 - shunt-resistor-micro-ohms : The shunt resistance in microohms.
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | ad7879.txt | 10 - adi,resistance-plate-x : total resistance of X-plate (for pressure
47 adi,resistance-plate-x = <120>;
65 adi,resistance-plate-x = <120>;
|
| D | ti-tsc-adc.txt | 13 ti,x-plate-resistance: X plate resistance
79 ti,x-plate-resistance = <200>;
|
| D | bu21029.txt | 8 - rohm,x-plate-ohms : x-plate resistance in Ohm
|
| D | ads7846.txt | 47 ti,x-plate-ohms Resistance of the X-plate,
49 ti,y-plate-ohms Resistance of the Y-plate,
|
| D | fsl-mx25-tcq.txt | 17 and the measured voltage after the plate was precharged. Resistance between
|
| D | tsc2007.txt | 6 - ti,x-plate-ohms: X-plate resistance in ohms.
|
| D | tsc2005.txt | 13 - ti,x-plate-ohms : integer, resistance of the touchscreen's X plates
|
| /Documentation/devicetree/bindings/phy/ |
| D | mxs-usb-phy.txt | 17 - fsl,tx-cal-45-dn-ohms: Integer [30-55]. Resistance (in ohms) of switchable
20 - fsl,tx-cal-45-dp-ohms: Integer [30-55]. Resistance (in ohms) of switchable
|
| D | xlnx,zynqmp-psgtr.yaml | 72 resistance in GT, which can be out of spec for the XCZU9EG silicon
|
| /Documentation/hwmon/ |
| D | max31730.rst | 24 supply voltage is from 3.0V to 3.6V. Resistance cancellation compensates
25 for high series resistance in circuit-board traces and the external thermal
|
| D | ntc_thermistor.rst | 33 that requires users to provide the resistance and lookup the corresponding
96 are suitable or the user can get the resistance directly, the user should
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | dpot-dac.txt | 4 current dpot wiper setting and the maximum resistance of the dpot. The
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-health-afe440x | 36 Get and set the resistance and the capacitance settings for the
|
| /Documentation/misc-devices/ |
| D | ad525x_dpot.rst | 8 work with the immediate resistance settings as well as update the saved startup
|
12