Home
last modified time | relevance | path

Searched refs:IO (Results 1 – 25 of 55) sorted by relevance

123

/drivers/scsi/pm8001/
Dpm80xx_hwi.c109 pm8001_dbg(pm8001_ha, IO, in pm80xx_get_fatal_dump()
123 pm8001_dbg(pm8001_ha, IO, "ossaHwCB: status1 %d\n", status); in pm80xx_get_fatal_dump()
124 pm8001_dbg(pm8001_ha, IO, "ossaHwCB: read_len 0x%x\n", in pm80xx_get_fatal_dump()
126 pm8001_dbg(pm8001_ha, IO, "ossaHwCB: direct_len 0x%x\n", in pm80xx_get_fatal_dump()
128 pm8001_dbg(pm8001_ha, IO, "ossaHwCB: direct_offset 0x%x\n", in pm80xx_get_fatal_dump()
149 pm8001_dbg(pm8001_ha, IO, "get_fatal_spcv: accum_len 0x%x\n", in pm80xx_get_fatal_dump()
151 pm8001_dbg(pm8001_ha, IO, "get_fatal_spcv: length_to_read 0x%x\n", in pm80xx_get_fatal_dump()
153 pm8001_dbg(pm8001_ha, IO, "get_fatal_spcv: last_offset 0x%x\n", in pm80xx_get_fatal_dump()
155 pm8001_dbg(pm8001_ha, IO, "get_fatal_spcv: read_len 0x%x\n", in pm80xx_get_fatal_dump()
157 pm8001_dbg(pm8001_ha, IO, "get_fatal_spcv:: direct_len 0x%x\n", in pm80xx_get_fatal_dump()
[all …]
Dpm8001_hwi.c1335 pm8001_dbg(pm8001_ha, IO, "No free mpi buffer\n"); in pm8001_mpi_build_cmd()
1398 pm8001_dbg(pm8001_ha, IO, " CI=%d PI=%d\n", in pm8001_mpi_msg_free_set()
1441 pm8001_dbg(pm8001_ha, IO, in pm8001_mpi_msg_consume()
1584 pm8001_dbg(pm8001_ha, IO, "IO_XFER_OPEN_RETRY_TIMEOUT\n"); in pm8001_work_fn()
1589 pm8001_dbg(pm8001_ha, IO, "...Task on lu\n"); in pm8001_work_fn()
1591 pm8001_dbg(pm8001_ha, IO, "...Task NOT on lu\n"); in pm8001_work_fn()
1638 pm8001_dbg(pm8001_ha, IO, "...Reset phy\n"); in pm8001_work_fn()
1652 pm8001_dbg(pm8001_ha, IO, "...Reset phy\n"); in pm8001_work_fn()
1659 pm8001_dbg(pm8001_ha, IO, "...Complete\n"); in pm8001_work_fn()
1936 pm8001_dbg(pm8001_ha, IO, "IO_SUCCESS,param = %d\n", in mpi_ssp_completion()
[all …]
/drivers/message/fusion/lsi/
Dmpi_history.txt88 * 03-11-05 01.05.07 Removed function codes for SCSI IO 32 and
91 * 06-24-05 01.05.08 Added function codes for SCSI IO 32 and
242 * Added Manufacturing pages, IO Unit Page 2, SCSI SPI
273 * Added IO Unit Page 3.
302 * Added structures for Manufacturing Page 4, IO Unit
364 * SAS IO Unit, SAS Expander, SAS Device, and SAS PHY.
368 * Two new bits defined for IO Unit Page 1 Flags field.
371 * Four new Flags bits defined for IO Unit Page 2.
372 * Added IO Unit Page 4.
379 * Added more defines for SAS IO Unit Page 0
[all …]
/drivers/pci/hotplug/
Dibmphp_res.c98 case IO: in alloc_bus_range()
132 case IO: in alloc_bus_range()
257 rc = alloc_bus_range(&newbus, &newrange, curr, IO, 1); in ibmphp_rsrc_init()
265 rc = alloc_bus_range(&bus_cur, &newrange, curr, IO, 0); in ibmphp_rsrc_init()
270 rc = alloc_bus_range(&newbus, &newrange, curr, IO, 1); in ibmphp_rsrc_init()
329 new_io->type = IO; in ibmphp_rsrc_init()
384 case IO: in add_bus_range()
407 case IO: in add_bus_range()
457 case IO: in update_resources()
491 case IO: in fix_me()
[all …]
Dibmphp_pci.c392 io[count]->type = IO; in configure_device()
657 bus_io[count]->type = IO; in configure_bridge()
813 io->type = IO; in configure_bridge()
1238 if (ibmphp_find_resource(bus, start_address, &io, IO)) in unconfigure_boot_device()
1248 &io, IO)) in unconfigure_boot_device()
1368 if (ibmphp_find_resource(bus, start_address, &io, IO) < 0) { in unconfigure_boot_bridge()
/drivers/net/ethernet/amd/
Datarilance.c234 #define DREG IO->data
235 #define AREG IO->addr
470 struct lance_ioreg *IO; in lance_probe1() local
530 IO = lp->iobase = (struct lance_ioreg *)ioaddr; in lance_probe1()
538 if (addr_accessible( &(IO->eeprom), 0, 0 )) { in lance_probe1()
540 i = IO->mem; in lance_probe1()
591 i = IO->eeprom; in lance_probe1()
596 i = IO->mem; in lance_probe1()
621 IO->ivec = IRQ_SOURCE_TO_VECTOR(dev->irq); in lance_probe1()
640 struct lance_ioreg *IO = lp->iobase; in lance_open() local
[all …]
/drivers/infiniband/ulp/rtrs/
DREADME8 transport. It is optimized to transfer (read/write) IO blocks.
53 The new rkey is sent back to the client along with the IO result.
55 registration on each IO causes performance drop of up to 20%. A user of the
97 side or network outage in an absence of IO.
100 corresponding path is disconnected, all the inflight IO are failed over to a
117 IO path
131 inflight IO and for the error code.
145 first, when it finishes, pass the IO to RNBD server module.
149 inflight IO and for the error code. The new rkey is sent back using
151 the message and finished IO after update rkey for the rbuffer, then post
[all …]
DKconfig25 RDMA Transport (RTRS) server module processing connection and IO
27 IO requests to its user eg. RNBD_server.
/drivers/pinctrl/ti/
DKconfig10 Say Y here to support Texas Instruments' IO delay pinconf driver.
11 IO delay module is used for the DRA7 SoC family.
/drivers/net/can/m_can/
DKconfig21 Say Y here if you want support for IO Mapped Bosch M_CAN controller.
23 IP embedded into the device and the IP is IO Mapped to the processor.
/drivers/usb/misc/
DKconfig171 tristate "IO Warrior driver support"
173 Say Y here if you want to support the IO Warrior devices from Code
175 IO Warrior 40
176 IO Warrior 24
177 IO Warrior 56
178 IO Warrior 24 Power Vampire
/drivers/scsi/pcmcia/
DKconfig44 IO-DATA PCSC-FP
56 [I-O DATA (OEM) (version string: "IO DATA","CBSC16 ","1")]
/drivers/block/drbd/
DKconfig47 Say Y here if you want to simulate IO errors, in order to test DRBD's
50 The actual simulation of IO errors is done by writing 3 values to
/drivers/scsi/cxlflash/
DKconfig12 Allows CAPI Accelerated IO to Flash
/drivers/net/arcnet/
DKconfig84 tristate "ARCnet COM90xx (IO mapped) chipset driver"
87 IO-mapped mode instead of memory-mapped mode. This is slower than
98 time only using memory-mapped mode, and no IO ports at all. This
/drivers/dma/ptdma/
DKconfig10 memory and IO copy operations. It performs DMA transfer through
/drivers/parport/
DKconfig58 tristate "Multi-IO cards (parallel and serial)"
61 This adds support for multi-IO PCI cards that have parallel and
82 Saying Y here enables some probes for Super-IO chipsets in order to
/drivers/net/can/sja1000/
DKconfig112 PLD IO base addresses are read from jumpers JP1 and JP2,
114 SJA1000 IO base addresses are chosen heuristically (first that works).
/drivers/soc/rockchip/
DKconfig18 tristate "Rockchip IO domain support"
/drivers/char/ipmi/
DKconfig110 provides the access of KCS IO space for BMC side.
122 provides the access of KCS IO space for BMC side.
/drivers/vdpa/
DKconfig33 vDPA block device simulator which terminates IO request in a
/drivers/bus/
DKconfig47 IO requests are routed to this bus by means of the DW AMBA 3 AXI
64 Interconnect (so called AXI Main Interconnect) routing IO requests
/drivers/iio/imu/
DKconfig105 A set of IO helper functions for the Analog Devices ADIS* device family.
/drivers/block/rnbd/
DREADME75 3. Client attaches RNBD_MSG_IO to each IO message send to a device. This
/drivers/video/fbdev/riva/
Dnv_driver.c338 par->riva.IO = (MISCin(par) & 0x01) ? 0x3D0 : 0x3B0; in riva_common_setup()

123