Searched refs:Supports (Results 1 – 25 of 25) sorted by relevance
| /drivers/net/phy/ |
| D | Kconfig | 196 Supports the Intel XWAY (former Lantiq) 11G and 22E PHYs.
204 Supports the LSI ET1011C PHY.
233 Supports the MediaTek Gigabit Ethernet PHYs.
239 Supports the KSZ9021, VSC8201, KS8001 PHYs.
244 Supports the LAN88XX PHYs.
249 Supports the LAN87XX PHYs.
298 Supports the Realtek 821x PHY.
303 Supports the Renesas PHYs uPD60620 and uPD60620A.
328 Supports the DP83822, DP83825I, DP83825CM, DP83825CS, DP83825S,
334 Supports the DP83TC811 PHY.
[all …]
|
| /drivers/clk/versatile/ |
| D | Kconfig | 11 Supports clocking on ARM Reference designs:
19 Supports clock muxing (REFCLK/TIMCLK to TIMERCLKEN0-3) capabilities
|
| /drivers/media/platform/renesas/rcar-vin/ |
| D | Kconfig | 13 Supports R-Car Gen3 and RZ/G2 SoCs.
29 Supports R-Car Gen{2,3} and RZ/G{1,2} SoCs.
|
| /drivers/crypto/aspeed/ |
| D | Kconfig | 31 Supports multiple message digest standards, including
47 Supports AES/DES symmetric-key encryption and decryption
|
| /drivers/clk/microchip/ |
| D | Kconfig | 11 Supports Clock Configuration for PolarFire SoC
|
| /drivers/usb/serial/ |
| D | io_edgeport.c | 522 product_info->Epic = epic->Supports; in get_epic_descriptor()
526 bits = &ep->epic_descriptor.Supports; in get_epic_descriptor()
1067 edge_serial->epic_descriptor.Supports.IOSPChase) { in edge_close()
1081 edge_serial->epic_descriptor.Supports.IOSPClose) { in edge_close()
1571 edge_serial->epic_descriptor.Supports.IOSPChase) { in edge_break()
1586 edge_serial->epic_descriptor.Supports.IOSPSetClrBreak) { in edge_break()
2193 !edge_serial->epic_descriptor.Supports.IOSPSetBaudRate) { in send_cmd_write_baud_rate()
2288 !edge_serial->epic_descriptor.Supports.IOSPWriteMCR && in send_cmd_write_uart_register()
2295 !edge_serial->epic_descriptor.Supports.IOSPWriteLCR && in send_cmd_write_uart_register()
2418 edge_serial->epic_descriptor.Supports.IOSPSetXChar) { in change_port_settings()
[all …]
|
| D | io_usbvend.h | 357 struct edge_compatibility_bits Supports; member
|
| /drivers/pci/switch/ |
| D | Kconfig | 10 Switchtec series of PCIe switches. Supports userspace access
|
| /drivers/clk/sifive/ |
| D | Kconfig | 19 Supports the Power Reset Clock interface (PRCI) IP block found in
|
| /drivers/clk/keystone/ |
| D | Kconfig | 6 Supports clock drivers for Keystone based SOCs. These SOCs have local
|
| /drivers/pinctrl/intel/ |
| D | Kconfig | 12 platforms. Supports 3 banks with 102, 28 and 44 gpios.
|
| /drivers/ptp/ |
| D | Kconfig | 82 Supports the DP83640 PHYTER with IEEE 1588 features.
|
| /drivers/net/ethernet/mellanox/mlx5/core/ |
| D | Kconfig | 83 offloading rules for traffic between such ports. Supports VLANs (trunk and
|
| /drivers/media/ |
| D | Kconfig | 184 Enables the DVB API, used by Digital TV devices. Supports several
|
| /drivers/net/mdio/ |
| D | Kconfig | 112 Supports GPIO lib-based MDIO busses.
|
| /drivers/video/fbdev/ |
| D | Kconfig | 1938 Supports fbdev clients like xf86-video-fbdev, kdrive, fbi, and
1939 mplayer -vo fbdev. Supports both UFX6000 (USB 2.0) and UFX7000
1954 Supports fbdev clients like xf86-video-fbdev, kdrive, fbi, and
1955 mplayer -vo fbdev. Supports all USB 2.0 era DisplayLink devices.
2026 Supports display resolutions up to 1024x1024 pixel, grayscale and
|
| /drivers/atm/ |
| D | Kconfig | 35 Supports ATM cards based on the Efficient Networks "Lanai"
|
| /drivers/clk/ |
| D | Kconfig | 41 Supports the clocking subsystem of the WM831x/2x series of
|
| /drivers/iommu/ |
| D | Kconfig | 197 Supports Interrupt remapping for IO-APIC and MSI devices.
|
| /drivers/iio/light/ |
| D | Kconfig | 520 Access data via iio and sysfs. Supports iio_events.
|
| /drivers/i2c/busses/ |
| D | Kconfig | 895 Supports the PA Semi PWRficient on-chip SMBus interfaces.
1395 Supports the SiByte SOC on-chip I2C interfaces (2 channels).
|
| /drivers/usb/host/ |
| D | Kconfig | 385 Supports the Philips ISP1362 chip as a host controller
|
| /drivers/input/misc/ |
| D | Kconfig | 670 Supports the pushbuttons and IR remote used with
|
| /drivers/gpio/ |
| D | Kconfig | 1615 chip to make 8 digital 24V inputs available via SPI. Supports
|
| /drivers/rtc/ |
| D | Kconfig | 547 Supports the RTC firmware in the MSP430 on the DM355 EVM.
|