Searched full:broadcast (Results 1 – 25 of 84) sorted by relevance
1234
| /Documentation/devicetree/bindings/cache/ |
| D | qcom,llcc.yaml | 77 - description: LLCC broadcast base register region
99 - description: LLCC broadcast base register region
122 - description: LLCC broadcast base register region
149 - description: LLCC broadcast base register region
180 - description: LLCC broadcast base register region
181 - description: LLCC broadcast AND register region
212 - description: LLCC broadcast base register region
237 - description: LLCC broadcast OR register region
238 - description: LLCC broadcast AND register region
|
| /Documentation/hwmon/ |
| D | acpi_power_meter.rst | 31 When both of them are set, an ACPI event will be broadcast on the ACPI netlink
41 average power consumption exceeds the cap, an ACPI event will be broadcast on
48 all cases the ACPI event will be broadcast on the ACPI netlink event socket as
|
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | nvidia,tegra186-mc.yaml | 155 - const: broadcast
174 - const: broadcast
205 - const: broadcast
245 <0x0 0x02c10000 0x0 0x10000>, /* Broadcast channel */
250 reg-names = "sid", "broadcast", "ch0", "ch1", "ch2", "ch3";
|
| /Documentation/networking/ |
| D | vrf.rst | 237 …3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP mode DEFA…
239 …4: eth2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP mode DEFA…
241 …7: eth5: <BROADCAST,MULTICAST> mtu 1500 qdisc noop master red state DOWN mode DEFAULT group defaul…
248 eth1 UP 02:00:00:00:02:02 <BROADCAST,MULTICAST,UP,LOWER_UP>
249 eth2 UP 02:00:00:00:02:03 <BROADCAST,MULTICAST,UP,LOWER_UP>
250 eth5 DOWN 02:00:00:00:02:06 <BROADCAST,MULTICAST>
282 …3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP group def…
290 …4: eth2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP group def…
298 7: eth5: <BROADCAST,MULTICAST> mtu 1500 qdisc noop master red state DOWN group default qlen 1000
321 broadcast 10.2.1.0 dev eth1 proto kernel scope link src 10.2.1.2
[all …]
|
| D | can.rst | 111 TCP/IP and ethernet networking, the CAN bus is a broadcast-only(!)
213 socket protocol and the broadcast manager (BCM). So to open a socket,
714 Broadcast Manager Protocol Sockets (SOCK_DGRAM)
717 The Broadcast Manager protocol provides a command based configuration
731 to communicate with the broadcast manager and the available operations are
734 The broadcast manager sends responses to user space in the same form:
750 messages to the broadcast manager from user space have this structure.
773 The broadcast manager socket is able to handle any number of in flight
777 When the broadcast manager socket is bound to 'any' CAN interface (=> the
784 Broadcast Manager Operations
[all …]
|
| D | net_failover.rst | 76 …4: ens10: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
82 …5: ens10nsby: <BROADCAST,MULTICAST> mtu 1500 qdisc fq_codel master ens10 state DOWN group default …
84 …7: ens11: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master ens10 state UP group default …
|
| D | ipvlan.rst | 64 that in L3 mode the slaves won't receive any multicast / broadcast traffic.
73 out. In this mode the slaves will RX/TX multicast and broadcast (if applicable)
83 will not receive nor can send multicast / broadcast traffic.
|
| /Documentation/driver-api/i3c/ |
| D | protocol.rst | 51 In addition to these per-device addresses, the protocol defines a broadcast
56 assigned a dynamic address, the device should still process broadcast messages.
92 request can be broadcast (applies to all devices) or sent to a specific
128 The MSB of this ID specifies whether this is a broadcast command (bit7 = 0) or a
172 using a broadcast CCC command.
|
| /Documentation/admin-guide/media/ |
| D | pci-cardlist.rst | 19 …controller [0480]: Philips Semiconductors SAA7131/SAA7133/SAA7135 Video Broadcast Decoder [1131:71…
21 …01:00.0 Multimedia video controller [0400]: Conexant Systems, Inc. CX23887/8 PCIe Broadcast Audio …
23 …s, Inc. CX23418 Single-Chip MPEG-2 Encoder with Integrated Analog Video/Broadcast Audio Decoder [1…
|
| D | dvb_intro.rst | 22 * Tune the receiver to receive a broadcast signal
23 * demodulate the broadcast signal
49 * Tune the received to receive a broadcast signal. * Extract the encoded
50 digital datastream from the broadcast signal.
99 The frequencies broadcast by Mount Dandenong transmitters are,
|
| /Documentation/networking/devlink/ |
| D | prestera.rst | 27 - Traps ARP broadcast packets (both requests/responses)
36 - Traps IPv4 packets with broadcast DA Mac address
|
| /Documentation/networking/device_drivers/ethernet/freescale/dpaa2/ |
| D | switch-driver.rst | 53 * Both the broadcast and flooding configuration should be per FDB. This
54 enables the driver to restrict the broadcast and flooding domains of each
60 fsl_dpaa2_switch dpsw.0: Broadcast domain is not per FDB, cannot probe
120 Broadcast flooding on a switch port can be disabled/enabled through the brport sysfs::
|
| /Documentation/features/time/arch-tick-broadcast/ |
| D | arch-support.txt | 2 # Feature name: arch-tick-broadcast
|
| /Documentation/driver-api/soundwire/ |
| D | locking.rst | 44 b. Transfer message (Read/Write) to Slave1 or broadcast message on
78 b. Transfer message (Read/Write) to Slave1 or broadcast message on
|
| /Documentation/networking/device_drivers/ethernet/altera/ |
| D | altera_tse.rst | 202 to the broadcast address or a multicast group.
210 the broadcast address.
219 a multicast group or broadcast address.
227 broadcast address.
239 including error, discarded, unicast, multicast, and broadcast packets.
|
| /Documentation/networking/device_drivers/ethernet/intel/ |
| D | e100.rst | 156 Multiple Interfaces on Same Ethernet Broadcast Network
160 system on two IP networks in the same Ethernet broadcast domain
174 (2) installing the interfaces in separate broadcast domains (either
|
| /Documentation/networking/dsa/ |
| D | lan9303.rst | 25 is enabled. This means that unicast traffic is forwarded in HW. Broadcast and
|
| /Documentation/bpf/ |
| D | map_devmap.rst | 48 With ``BPF_F_BROADCAST`` the packet will be broadcast to all the interfaces
50 from the broadcast.
54 - The broadcast feature can also be used to implement multicast forwarding:
|
| /Documentation/devicetree/bindings/scsi/ |
| D | hisilicon-sas.txt | 27 - broadcast
31 (broadcast, phyup, and abnormal) in increasing order.
|
| /Documentation/networking/device_drivers/ethernet/netronome/ |
| D | nfp.rst | 311 - Broadcast bytes received.
323 - Broadcast packets received.
358 - Broadcast bytes transmitted.
370 - Broadcast packets transmitted.
|
| /Documentation/driver-api/ |
| D | slimbus.rst | 22 reconfiguration sequence is a broadcast message announced to all devices)
106 broadcast to all active devices on the bus before the bus can enter low-power
|
| /Documentation/driver-api/media/drivers/ |
| D | radiotrack.rst | 31 broadcast band, so I could pick up the audio carriers from North American
32 broadcast TV channels, situated just below and above the 87.0-109.0 MHz range.
45 more or less limited from 87.0 to 109.0 MHz (the commercial FM broadcast
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | sbs,sbs-battery.yaml | 55 SBS batteries by default send broadcast messages to SBS compliant chargers to
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-dv.rst | 98 originates from a computer as opposed to content from a TV broadcast
157 from a computer as opposed to content from a TV broadcast or an
|
| /Documentation/netlink/specs/ |
| D | rt_addr.yaml | 94 name: ifa-broadcast
|
1234