Searched full:enabling (Results 1 – 25 of 334) sorted by relevance
12345678910>>...14
| /Documentation/driver-api/thermal/ |
| D | exynos_thermal_emulation.rst | 18 Enabling CONFIG_THERMAL_EMULATION option will make this support
32 enabling. It means when you want to update the any value of delay or
34 time. (Or you have to keep the mode enabling.) If you don't, it fails to
|
| /Documentation/devicetree/bindings/mtd/ |
| D | nand-macronix.txt | 8 Enabling the randomizer is a one time persistent and non reversible
12 with hardware ECC and not enabled at UBI level, then enabling the
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-power-rt9471 | 6 This entry allows enabling the sysoff mode of rt9471 charger devices.
24 This entry allows enabling the USB BC12 port detect function of rt9471 charger
|
| D | sysfs-driver-eud | 7 EUD based on a 1 or a 0 value. By enabling EUD,
|
| D | sysfs-bus-iio-adc-stm32 | 15 Writing value before enabling conversions sets trigger polarity.
|
| D | sysfs-class-power-rt9467 | 6 This entry allows enabling the sysoff mode of rt9467 charger
|
| D | debugfs-driver-dcc | 116 This debugfs interface is used for enabling the
122 On enabling the dcc, all the addresses specified
|
| /Documentation/PCI/ |
| D | pci-iov-howto.rst | 39 enabling and disabling of the capability via API provided by SR-IOV core.
49 checks, e.g., check numvfs == 0 if enabling VFs, ensure
91 command below before enabling SR-IOV capabilities. This is the
99 command below before enabling SR-IOV capabilities. Updating this
|
| /Documentation/virt/kvm/x86/ |
| D | cpuid.rst | 66 before enabling paravirtualized
70 before enabling paravirtualized
78 before enabling paravirtualized
|
| /Documentation/ABI/obsolete/ |
| D | sysfs-firmware-acpi | 8 enabling this knob is not safe and thus unsupported.
|
| /Documentation/gpu/amdgpu/display/ |
| D | dc-debug.rst | 23 enabling it, you will need::
85 information, we can trace DMUB commands by enabling the relevant bits in
116 enabling the relevant bits in the mask before reproducing the issue and
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | hycon,hy46xx.yaml | 57 description: Allows enabling glove setting.
66 description: Allows enabling power noise filter.
|
| /Documentation/admin-guide/media/ |
| D | building.rst | 77 enabling configuration options directly. To enable media support
99 It should be noticed that enabling the above from a clean config is
119 Enabling Remote Controller Support
136 ``lirc`` program, by enabling an API that allows userspace to receive raw data
164 Enabling HDMI CEC Support
192 Enabling Media Support
|
| /Documentation/arch/powerpc/ |
| D | pmu-ebb.rst | 57 section below titled "Enabling an EBB event" for more information.
87 Enabling an EBB event
94 However, due to the design of the perf_events API, enabling an event does not
|
| /Documentation/arch/arm64/ |
| D | pointer-authentication.rst | 94 guest implementation works by enabling both features together, so both
95 these userspace flags are checked before enabling pointer authentication.
111 Enabling and disabling keys
|
| /Documentation/trace/ |
| D | tracepoint-analysis.rst | 52 3. Enabling Events
55 3.1 System-Wide Event Enabling
59 can be enabled system-wide. A short example of enabling all events related
64 3.2 System-Wide Event Enabling with SystemTap
90 3.3 System-Wide Event Enabling with PCL
112 3.4 Local Event Enabling
|
| /Documentation/devicetree/bindings/powerpc/opal/ |
| D | sensor-groups.txt | 26 sensor groups like clearing min/max, enabling/disabling sensor
|
| /Documentation/devicetree/bindings/leds/backlight/ |
| D | gpio-backlight.yaml | 19 description: The gpio that is used for enabling/disabling the backlight.
|
| /Documentation/devicetree/bindings/ata/ |
| D | ti,da850-ahci.yaml | 20 … Address and size of Power Down Control Register (PWRDN) for enabling/disabling the SATA clock
|
| /Documentation/dev-tools/ |
| D | autofdo.rst | 36 When enabling the AutoFDO build configuration without providing an
80 - For enabling a single file (e.g. foo.o) ::
84 - For enabling all files in one directory ::
|
| /Documentation/devicetree/bindings/clock/ |
| D | gpio-gate-clock.yaml | 23 description: GPIO reference for enabling and disabling the clock.
|
| /Documentation/virt/kvm/arm/ |
| D | pkvm.rst | 25 Enabling pKVM
36 Enabling pKVM places some significant limitations on KVM guests, regardless of
|
| /Documentation/devicetree/bindings/regulator/ |
| D | qcom,qca6390-pmu.yaml | 65 description: GPIO line enabling the ATH11K WLAN module supplied by the PMU
69 description: GPIO line enabling the Bluetooth module supplied by the PMU
|
| /Documentation/gpu/rfc/ |
| D | i915_gem_lmem.rst | 10 * Merge basic HW enabling of DG1(still without pciid)
|
| /Documentation/devicetree/bindings/arm/ |
| D | qcom,coresight-remote-etm.yaml | 15 framework. Enabling this will allow turning on ETM tracing on remote
|
12345678910>>...14