| /third_party/uboot/u-boot-2020.01/lib/crypto/ |
| D | pkcs7_parser.c | 112 pr_warn("Inconsistently supplied authAttrs\n"); in pkcs7_check_authattrs()
295 pr_warn("Only support pkcs7_signedData type\n"); in pkcs7_check_content_type()
332 pr_warn("Unsupported SignedData version\n"); in pkcs7_note_signeddata_version()
372 pr_warn("Unsupported SignerInfo version\n"); in pkcs7_note_signerinfo_version()
375 pr_warn("SignedData-SignerInfo version mismatch\n"); in pkcs7_note_signerinfo_version()
448 pr_warn("Unsupported data type %d\n", ctx->last_oid); in pkcs7_note_content()
493 pr_warn("Mismatch between global data type (%d) and sinfo %u (%d)\n",
527 pr_warn("S/MIME Caps only allowed with Authenticode\n");
547 pr_warn("Authenticode AuthAttrs only allowed with Authenticode\n");
558 pr_warn("Repeated/multivalue AuthAttrs not permitted\n");
[all …]
|
| D | x509_cert_parser.c | 104 pr_warn("Couldn't decode AuthKeyIdentifier\n"); in x509_cert_parse()
270 pr_warn("Got cert with pkey (%u) and sig (%u) algorithm OIDs\n", in x509_note_signature()
|
| /third_party/uboot/u-boot-2020.01/arch/arm/mach-uniphier/ |
| D | board_late_init.c | 68 pr_warn("\"fdt_file\" environment variable was not set correctly\n"); in uniphier_set_env_fdt_file()
98 pr_warn("\"%s\" environment variable was not set correctly\n", env); in uniphier_set_env_addr()
|
| D | dram_init.c | 69 pr_warn("Sparse mem is enabled, but ch0 and ch1 overlap\n"); in uniphier_memconf_decode()
70 pr_warn("Only ch0 is available\n"); in uniphier_memconf_decode()
|
| /third_party/uboot/u-boot-2020.01/drivers/firmware/ |
| D | psci.c | 73 pr_warn("missing \"method\" property\n"); in psci_probe()
82 pr_warn("invalid \"method\" property: %s\n", method); in psci_probe()
|
| /third_party/uboot/u-boot-2020.01/drivers/mtd/nand/ |
| D | core.c | 75 pr_warn("failed to write BBM to block @%llx (err = %d)\n", in nanddev_markbad()
132 pr_warn("attempt to erase a bad/reserved block @%llx\n", in nanddev_erase()
|
| /third_party/uboot/u-boot-2020.01/include/linux/ |
| D | printk.h | 50 #define pr_warn pr_warning macro
|
| /third_party/uboot/u-boot-2020.01/arch/arm/mach-uniphier/arm32/ |
| D | psci.c | 96 pr_warn("warning: some of secondary CPUs may not boot\n"); in uniphier_smp_kick_all_cpus()
|
| /third_party/uboot/u-boot-2020.01/drivers/mtd/nand/raw/ |
| D | nand_bbt.c | 473 pr_warn("create_bbt(): chipnr (%d) > available chips (%d)\n", in create_bbt()
497 pr_warn("Bad eraseblock %d at 0x%012llx\n", in create_bbt()
576 pr_warn("Bad block table not found for chip %d\n", i); in search_bbt()
726 pr_warn("nand_bbt: ECC error while reading block for writing bad block table\n"); in write_bbt()
806 pr_warn("nand_bbt: error while writing bad block table %d\n", res); in write_bbt()
1258 pr_warn("Bad block pattern already allocated; not replacing\n"); in nand_create_badblock_pattern()
|
| D | nand_base.c | 569 pr_warn("timeout while waiting for chip to become ready\n"); in nand_wait_ready()
3559 pr_warn("%s: attempt to erase a bad block at page 0x%08x\n", in nand_erase_nand()
3992 pr_warn("Failed to detect ONFI extended param page\n"); in nand_flash_detect_onfi()
3994 pr_warn("Could not retrieve ONFI ECC requirements\n"); in nand_flash_detect_onfi()
4087 pr_warn("Invalid codeword size\n"); in nand_flash_detect_jedec()
4528 pr_warn("bus width %d instead %d bit\n", in nand_get_flash_type()
4712 pr_warn("No NAND device found\n"); in nand_scan_ident()
5109 pr_warn("No oob scheme defined for oobsize %d\n", in nand_scan_tail()
5127 pr_warn("No ECC functions supplied; hardware ECC not possible\n"); in nand_scan_tail()
5158 pr_warn("No ECC functions supplied; hardware ECC not possible\n"); in nand_scan_tail()
[all …]
|
| /third_party/uboot/u-boot-2020.01/drivers/net/phy/ |
| D | mscc.c | 811 pr_warn("failed to patch FW, expect non-optimal device\n"); in vsc8574_config_pre_init()
836 pr_warn("FW CRC after patching is not the expected one, expect non-optimal device\n"); in vsc8574_config_pre_init()
859 …pr_warn("VSC8584 revA not officially supported, skipping firmware patching. Use at your own risk.\… in vsc8584_config_pre_init()
980 pr_warn("failed to patch FW, expect non-optimal device\n"); in vsc8584_config_pre_init()
993 pr_warn("FW CRC after patching is not the expected one, expect non-optimal device\n"); in vsc8584_config_pre_init()
|
| D | dp83867.c | 193 pr_warn("PHY has delays via pin strapping, but phy-mode = 'rgmii'\n" in dp83867_of_init()
|
| /third_party/uboot/u-boot-2020.01/drivers/fastboot/ |
| D | fb_getvar.c | 294 pr_warn("WARNING: unknown variable: %s\n", cmd_parameter); in fastboot_getvar()
|
| /third_party/uboot/u-boot-2020.01/drivers/clk/ |
| D | clk-divider.c | 192 pr_warn("divider value exceeds LOWORD field\n"); in _register_divider()
|
| /third_party/uboot/u-boot-2020.01/drivers/net/ |
| D | sni_ave.c | 426 pr_warn("%s: halt timeout\n", priv->phydev->dev->name); in ave_stop()
565 pr_warn("%s: bad send packet status:%08x\n", in ave_send()
589 pr_warn("%s: bad packet[%d] status:%08x ptr:%p\n", in ave_recv()
|
| D | bcm6368-eth.c | 388 pr_warn("%s: invalid forced speed on port %s\n", in bcm6368_eth_start()
|
| /third_party/FreeBSD/sys/compat/linuxkpi/common/include/linux/ |
| D | kernel.h | 104 #define pr_warn pr_warning macro
|
| /third_party/uboot/u-boot-2020.01/drivers/video/stm32/ |
| D | stm32_ltdc.c | 176 pr_warn("%s: warning %dbpp not supported yet, %dbpp instead\n", in stm32_ltdc_get_pixel_format()
|
| /third_party/uboot/u-boot-2020.01/drivers/mmc/ |
| D | mmc.c | 1528 pr_warn("invalid bus witdh capability 0x%x\n", cap); in bus_width()
1771 pr_warn("unable to read ssr\n"); in sd_select_mode_and_width()
2526 pr_warn("MMC: SET_DSR failed\n"); in mmc_startup()
2689 pr_warn("mmc: failed to set signal voltage\n"); in mmc_set_initial_state()
|
| D | fsl_esdhc_imx.c | 753 pr_warn("HS400 strobe DLL status REF not lock!\n"); in esdhc_set_strobe_dll()
755 pr_warn("HS400 strobe DLL status SLV not lock!\n"); in esdhc_set_strobe_dll()
|
| /third_party/uboot/u-boot-2020.01/arch/arm/mach-uniphier/dram/ |
| D | umc-pxs2.c | 138 pr_warn("DQS Gateing System Latencies are not all leveled.\n"); in ddrphy_get_system_latency()
|
| /third_party/uboot/u-boot-2020.01/board/ti/common/ |
| D | board_detect.c | 346 pr_warn("%s: Ignoring record id %u\n", __func__, in ti_i2c_eeprom_am6_parse_record()
|
| /third_party/uboot/u-boot-2020.01/fs/ubifs/ |
| D | ubifs.h | 635 pr_warn("UBIFS warning (ubi%d:%d pid %d): %s: " fmt "\n", \
645 pr_warn("UBIFS warning (ubi%d:%d pid %d): %s: " fmt "\n", \
|
| /third_party/uboot/u-boot-2020.01/drivers/mtd/ubi/ |
| D | ubi.h | 52 #define ubi_warn(ubi, fmt, ...) pr_warn(UBI_NAME_STR "%d warning: %s: " fmt "\n", \
|
| /third_party/uboot/u-boot-2020.01/drivers/usb/gadget/ |
| D | dwc2_udc_otg.c | 550 pr_warn("Got %d hw endpoint but %d tx-fifo-size in array !!\n", in reconfig_usbd()
|