Home
last modified time | relevance | path

Searched +full:300 +full:a000 (Results 1 – 25 of 29) sorted by relevance

12

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/pwm/
Dallwinner,sun4i-a10-pwm.yaml99 pwm@300a000 {
/kernel/linux/linux-5.10/arch/arm64/boot/dts/realtek/
Drtd16xx.dtsi64 cpu3: cpu@300 {
158 sb2: syscon@1a000 {
/kernel/linux/linux-5.10/drivers/input/touchscreen/
Diqs5xx.c159 usleep_range(200, 300); in iqs5xx_read_burst()
213 usleep_range(200, 300); in iqs5xx_write_burst()
242 usleep_range(200, 300); in iqs5xx_reset()
615 * A000 and B000 devices use 8-bit and 16-bit addressing, respectively. in iqs5xx_dev_init()
616 * Querying an A000 device's version information with 16-bit addressing in iqs5xx_dev_init()
/kernel/linux/linux-5.10/Documentation/networking/device_drivers/ethernet/cirrus/
Dcs89x0.rst177 Base I/O Address: 300
563 A000-BFFF EGA Graphics Adapter
564 A000-C7FF VGA Graphics Adapter
/kernel/linux/linux-5.10/arch/arm64/boot/dts/nvidia/
Dtegra210-p3450-0000.dts135 pwm@7000a000 {
271 regulator-ramp-delay-scale = <300>;
287 regulator-ramp-delay-scale = <300>;
Dtegra132-norrin.dts537 pwm: pwm@7000a000 {
890 nvidia,cpu-pwr-off-time = <300>;
/kernel/linux/linux-5.10/arch/arm/boot/dts/
Dbcm-nsp.dtsi187 uart0: serial@300 {
325 ehci0: usb@2a000 {
Dste-dbx5x0.dtsi51 CPU0: cpu@300 {
723 i2c4: i2c@8012a000 {
773 spi0: spi@8011a000 {
Dtegra124-nyan.dtsi75 pwm@7000a000 {
386 nvidia,cpu-pwr-off-time = <300>;
Dtegra30-asus-nexus7-grouper-common.dtsi836 pwm: pwm@7000a000 {
972 post-power-on-delay-ms = <300>;
973 power-off-delay-us = <300>;
Domap4-l4.dtsi73 omap_control_usb2phy: control-phy@300 {
718 target-module@a000 { /* 0x4a10a000, ap 65 50.0 */
799 target-module@a000 { /* 0x4a20a000, ap 33 2c.0 */
895 target-module@2a000 { /* 0x4a22a000, ap 57 48.0 */
1019 target-module@a000 { /* 0x4a30a000, ap 15 34.0 */
1738 target-module@6a000 { /* 0x4806a000, ap 26 18.0 */
2088 target-module@9a000 { /* 0x4809a000, ap 51 2c.0 */
Ddm814x.dtsi251 i2c2: i2c@2a000 {
742 cpsw_emac1: slave@300 {
Dtegra20-acer-a500-picasso.dts518 pwm: pwm@7000a000 {
728 post-power-on-delay-ms = <300>;
729 power-off-delay-us = <300>;
Dam33xx-l4.dtsi546 target-module@1a000 { /* 0x47c1a000, ap 9 08.0 */
602 target-module@3a000 { /* 0x47c3a000, ap 19 1c.0 */
748 cpsw_emac1: slave@300 {
1002 target-module@2a000 { /* 0x4802a000, ap 14 2a.0 */
1260 target-module@4a000 { /* 0x4804a000, ap 85 60.0 */
Dda850.dtsi51 * Original silicon was 300MHz max, so higher frequencies
700 pll1: clock-controller@21a000 {
Dtegra114-dalmore.dts761 pwm@7000a000 {
1098 nvidia,cpu-pwr-off-time = <300>;
Dtegra124-venice2.dts614 pwm@7000a000 {
902 nvidia,cpu-pwr-off-time = <300>;
/kernel/linux/linux-5.10/arch/arm64/boot/dts/allwinner/
Dsun50i-h6.dtsi284 pwm: pwm@300a000 {
294 pio: pinctrl@300b000 {
/kernel/linux/linux-5.10/arch/arm64/boot/dts/apm/
Dapm-shadowcat.dtsi78 cpu@300 {
430 efuse: efuse@1054a000 {
Dapm-storm.dtsi66 cpu@300 {
468 efuse: efuse@1054a000 {
/kernel/linux/linux-5.10/Documentation/networking/
Darcnet-hardware.rst258 Trunk" is about 300 meters for RG-62. The maximum distance between the two
659 1 0 0 | 300
911 1 1 0 0 0 0 | 300
1097 001 300-30f
1130 00101 D:8000-D:87ff D:A000-D:bfff
1430 ON ON OFF | 300
1638 OFF OFF ON ON ON ON | 300
2043 ON ON OFF | 300
2189 ON ON OFF | 300
2293 300----- 0 0 0 0 1 1 1 1
[all …]
/kernel/linux/linux-5.10/drivers/crypto/caam/
Dregs.h863 /* Block hashes @ 200/300/400/500 */
932 * 5 typical, base + 0x8000/9000/a000/b000
/kernel/linux/linux-5.10/arch/arm64/boot/dts/qcom/
Dsm8150.dtsi91 CPU3: cpu@300 {
458 mc_virt: interconnect@163a000 {
622 interrupts = <GIC_SPI 300 IRQ_TYPE_LEVEL_HIGH>;
/kernel/linux/linux-5.10/arch/arm64/boot/dts/amlogic/
Dmeson-axg.dtsi1285 tdmin_a: audio-controller@300 {
1654 pwm_cd: pwm@1a000 {
/kernel/linux/linux-5.10/Documentation/filesystems/
Dproc.rst392 08049000-0804a000 rw-p 00001000 03:00 8312 /opt/test
393 0804a000-0806b000 rw-p 00000000 00:00 0 [heap]
1079 of memory, but only touches 300M of it will show up as
2043 | lr-------- 1 root root 64 Jan 27 11:24 400000-41a000 -> /usr/bin/ls

12